四臂星型聚苯乙烯-聚4-乙烯基吡啶嵌段共聚物纤维状胶束及负载金纳米粒子的研究

通过两步原子转移自由基聚合,制备了4种不同嵌段长度的四臂星型嵌段共聚物苯乙烯-聚4-乙烯基吡啶嵌段共聚物(PS-b-P4VP)4.在选择性溶剂甲苯中,随着嵌段长度的变化,自组装胶束的形态从球型到短棒状和纤维状的转变,其中(PS25-b-P4VP90)4自组装形成的以P4VP为核,以PS为花瓣型壳的纤维状胶束.以这种纤维状胶束作为模板,制备了金纳米粒子均匀分布的一维纳米材料     

反相微乳液助水热法可控合成FeNi3合金纳米结构

利用水热法处理表面活性剂/正辛烷/正己醇/水四元微乳体系成功合成FeNi3合金纳米结构. 通过改变表面活性剂的用量和类型来调控产物粒径与形貌. 当表面活性剂为聚乙二醇4000(PEG4000)时, 产物为球状, 粒径约为75 nm. 当表面活性剂为十六烷基三甲基溴化铵(CTAB)时, 产物为海胆状.单个海胆状颗粒是由许多纳米棒构成, 其直径约为42 nm, 长度为0.4-1.2 μm. 利用X射线粉末衍射(XRD), 穆斯堡尔谱, 扫描电子显微镜(SEM), 透射电子显微镜(TEM), 选区电子衍射(SAED), 多功能磁天平(MMVFTB)等测试手段对产物的组成、形貌和磁性能进行了表征. 球状和海胆状的FeNi3样品在室温下呈现典型的铁磁性特征, 其饱和磁化强度(Ms)值分别为114.4和97.4 emu·g-1, 矫顽力(Hc)值分别为94.0和329.0 Oe.     

信号肽功能化二氧化硅纳米颗粒的线粒体靶向作用研究

以N-(p-Maleimidophenyl)isocyanate(PMPI)为交联剂, 将线粒体信号肽分子共价修饰到二氧化硅荧光纳米颗粒表面, 构建线粒体信号肽功能化二氧化硅荧光纳米颗粒. 采用荧光分光光度计、Zeta电位仪以及透射电子显微镜对修饰前后的二氧化硅纳米颗粒进行了表征. 结果表明, 信号肽可被成功修饰在纳米颗粒表面, 并且纳米颗粒粒径在信号肽分子修饰前后没有发生明显变化. 以分离纯化的细胞核作为对照, 采用流式细胞术考察了信号肽功能化二氧化硅荧光纳米颗粒与分离纯化后的线粒体的相互作用. 结果表明, 线粒体信号肽修饰到二氧化硅纳米颗粒表面后依然保持良好的生物活性, 能够介导二氧化硅纳米颗粒特异性识别及结合分离纯化的线粒体, 从而为线粒体监测及其功能调控研究提供了新的思路.     

Size control synthesis of sulfur doped titanium dioxide （anatase） nanoparticles, its optical property and its photo catalytic reactivity for CO2 ＋ H2O conversion and phenol degradation

Sulfur doped anatase TiO2 nanoparticles (3 nm−12 nm) were synthesized by the reaction of titanium tetrachloride, water and sulfuric acid with addition of 3M NaOH at room temperature. The electro-optical and photocatalytic properties of the synthesized sulfur doped TiO2 nanoparticles were studied along with Degussa commercial TiO2 particles (24 nm). The results show that band gap of TiO2 particles decreases from 3.31 to 3.25 eV and for that of commercial TiO2 to 3.2 eV when the particle sizes increased from 3 nm to 12 nm with increase in sulfur doping. The results of the photocatalytic activity under UV and sun radiation show maximum phenol conversion at the particle size of 4 nm at 4.80% S-doping. Similar results are obtained using UV energy for both phenol conversion and conversion of CO2+H2O in which formation of methanol, ethanol and proponal is observed. Production of methanol is also achieved on samples with a particle size of 8 and 12 nm and sulfur doping of 4.80% and 5.26%. For TiO2 particle of 4 nm without S doping, the production of methanol, ethanol and proponal was lower as compared to the S-doped particles. This is attributed to the combined electronic effect and band gap change, S dopant, specific surface area and the light source used.     

Effect of CeO2 preparation method and Cu loading on CuO/CeO2 catalysts for methane combustion

CeO2 was synthesized by sol-gel, hydrothermal, nitrate thermal decomposition methods, respectively, and used as support to prepare CuO/CeO2 catalysts. According to characterization and reaction results, preparation method of CeO2 had a great influence on the physicochemical properties and activities of CuO/CeO2 catalysts. CuO with high dispersion and strong interaction with CeO2 was highly active in methane combustion, while CuO particles less associated with CeO2 showed less activity. The CuO catalyst supported on CeO2 which was prepared via nitrate thermal decomposition method showed the largest area, the smallest particle size, the highest dispersion of copper species and strong support metal interactions. Therefore, it presented the highest redox ability and activity for methane combustion. Activities of the catalysts with different copper content kept increasing until 5% Cu loading and from then on kept constant. Moreover, methane conversion decreased as methane space velocities increased on CuO/CeO2 catalyst. Addition of CO2 to the feed did not produce a significant effect on the catalytic activity, but the presence of H2O provoked a remarkable decrease on the activity of CuO/CeO2 catalyst.     

纳米镍-铁合金/膨胀石墨复合材料的制备、表征及其电磁屏蔽性能

The composites with nano-particles of Ni-Fe alloys dispersed on the nano-layers of expanded graphite (EG) were prepared by the impregnation of EG with ethanol solutions of nickel and iron acetates， followed by drying and reduction in H₂. The square nano-particles of Ni-Fe alloys with particle sizes of mainly 20～40 nm were found to be well spread on the layers of EG. The alloy nano-particles exhibited high shielding effectiveness (SE) for electromagnetic radiations at low frequencies due to their high magnetic conductivity. Since EG is electronically conductive and displayed high SE at high frequencies， the composites exhibited good SE at wide range of frequencies. The electric and magnetic conductivities of the composites could be monitored through regulating the loadings of alloy nano-particles on EG， and it was found that the composites with 20%～40% of the alloys exhibited good SE. Specifically， the composite 27%Ni-3%Fe-EG showed the excellent SE from 66 to 110 dB at the frequencies from 300 kHz to 1.5 GHz.     

城市土壤不同颗粒中重金属的分布及其对人体吸入重金属的影响

采集了9个不同质地的城市土壤,按颗粒大小分为6个粒级,分别测定了4种重金属(Cu、Cd、Co和Pb)的全量和有效态含量。结果表明,细颗粒中重金属有明显的富集,其中<0.002 mm粒组的重金属含量约为土壤的1.57~13.95倍。有效态重金属占其总量的比例一般是0.250~0.125 mm和0.125~0.050 mm粒组高于其它粒组。质地对重金属在不同颗粒中的分配有很大的影响;虽然重金属含量一般是质地较黏的土壤高于质地不黏的土壤,但砂质土壤中细颗粒组分中的重金属的含量却一般要高于黏质土壤的相应粒组。因此,在相同的重金属含量条件下,砂质土壤对人体的潜在影响要远高于黏质土壤。     

Protein Adsorption onto Nanosized Hydroxyapatite Particles for Controlled Drug Release

Nanosized hydroxyapatite(nsHAp) was synthesized to examine its possibility as a controlled release carrier of protein. To achieve effective protein release from nanosized hydroxyapatite, the study of the adsorptive properties of protein on nsHAp and different influence parameters such as pH, calcium, and phosphate concentrations during the adsorption process is necessary. Ovalbumin(OVA) was selected as the model of growth factors. The results show that the amount of OVA adsorbed onto nsHAp in acetic buffer(pH=3.6) is more than that in acetic buffer(pH=5.6) because of the electric interaction. The amount of OVA adsorption in phosphate buffer solution(PBS) is smaller than that in acetic buffer because of surface complexation and surface hydroxylation. The presence of Ca2 dramatically increases the adsorbed amount of OVA in acetic buffer on maintaining the same pH. Meanwhile, the release kinetics of OVA adsorbed onto nsHAp(nsHAp-OVA) was also examined. The amount of released OVA in PBS(pH=5.6) was significantly smaller than that released in solution of pH=7.0. All the results suggest that nanosized hydroxyapatite particles could be successfully used as controlled released carrier of protein.     

Al2O3/SnO2 Co-Nanoparticle Modified Grafted Collagen for Improving Thermal Stability and Infrared Emissivity

Al2O3/SnO2 co-nanoparticles were prepared with a modified sol-gel technique followed by a thermal treatment process. With these co-nanoparticles the grafted collagen-Al2O3/SnO2 nanocomposites were obtained using a supersonic dispersion method. X-ray diffraction, FT-IR analysis, transmission electron microscopy, TGA/DTA and infrared emissivity test were performed to characterize the resulting nanoparticles and nanocomposites, respectively. The Al2O3/SnO2 co-nanoparticles showed a narrow distribution of size between 20-40 nm and could be uniformly absorbed on the tri-helix scaffolds of the grafted collagen without any aggregation. The nanocomposites possessed better thermal stability and substantially lower infrared emissivity than the grafted collagen and Al2O3/SnO2 co-nanoparticles with an increase of degradation temperature from 39 to 210 ℃ and a decrease of infrared emissivity from 0.850 of the grafted collagen and 0.708 of the Al2O3/SnO2 co-nanoparticles to 0.424, which provided a potential application of the nanocomposites to areas such as photoelectronics.     

Studies on fluorenscence resonance energy transfer between CdS nanoparticles and DOCAI dyes

The water-soluble CdS nanoparticles were synthesized in aqueous solution. A novel fluorescence resonance energy transfer (FRET) system with CdS nanoparticles as energy donors and 3,30-diethyl-oxadicarbocyanine iodide (DOCAI) dyes as energy accepter has been developed.