预裂化理论研究:基质表面酸性位类型及不同类型酸性位接触顺序对裂化过程小分子烯烃收率的影响

在区分氢负离子转移反应与氢转移反应、非选择性氢转移反应与总的氢转移反应的情况下,通过合成物性相近但酸性不同的氧化铝,用以作为裂化催化剂基质材料,在固定床反应器上考察了催化裂化过程,基质酸性位类型及基质表面Lewis及Brönsted酸性位接触顺序对小分子烯烃(丙烯、丁烯)收率的影响。结果表明,催化裂化生成小分子烯烃过程中,分子筛与基质所呈现出的反应特点存在较大的区别,前者活性虽高,但总的氢转移反应活性过强。基质材料裂化活性虽低但其表面以氢负离子转移反应为主,反应路径角度更有利于小分子烯烃收率的提高。另外,基质表面存在Brönsted酸性位,或原料油首先与基质表面Lewis酸性位相接触再与Brönsted酸性位反应的预裂化过程,会在促进裂化反应发生的同时抑制总的氢转移反应,更有利于小分子烯烃收率的提高。     

滴加顺序对制备酯加氢催化剂Cu-Zn-Al-Ba的影响

采用共沉淀法以不同的滴加混合顺序制备了新型高效无铬Cu-Zn-Al-Ba催化剂,通过XRD、SEM、BET、H₂-TPR和TG等表征方式进行了分析,对其前驱体、焙烧后和还原后催化剂物相进行分析研究,探究了相同条件下不同滴加混合顺序对催化剂结构与催化性能的影响,同时考察了催化剂对C12~C18脂肪酸甲酯加氢制醇的催化性能以及重复利用性。结果表明,以混合盐溶液滴加沉淀剂所制备的无铬Cu-Zn-Al-Ba催化剂R-cat具有较好的酯加氢催化活性和稳定性。在230℃,3MPa氢压的反应条件下,R-cat催化C12~C18脂肪酸甲酯加氢制醇的收率和选择性都高于90%,催化剂重复利用5次,仍保持较高的催化活性。     

Rapid Fabrication of Hollow SiO2 Spheres with Novel Morphology

The hydrolysis of tetraethoxysilane (TEOS) occurred on the surface of poly(methyl methacrylate) (PMMA) microshperes immediately after these microshperes were prepared in TEOS. Micron-sized hollow SiO2 spheres were obtained by calcination of the coated PMMA microshperes. It was found that the final hollow spheres were constituted by small SiO2 particles.     

TPD修饰电化学生物传感器测定DNA片段序列

合成了一种新的吸附偶联试剂-硫酚乙酸琥珀酰亚胺酯(TPD),将TPD吸附在金的表面,利用其琥珀酰亚胺基与客体氨基的反应,将单链DNA修饰在金电极上作为探针,以电化学方法检测能与之互补DNA样品的碱基序列和含量。杂交后的DNA采用自行合成的双[1-二茂铁按甲酰丙基-四氢化吡嗪-4-丙基氨甲酰吡啶]并吩嗪(FCZ)作指示剂进行检测,该化合物能够嵌入DNA双螺旋结构的碱基对中,显示出高度电化学活性。该传感的电流信号与DNA深度在2×10^-8～1×10^-7mol/L范围有线性关系,检测限为8×10^-10mol/L。本方法可用于检测爱滋病和乙肝病毒DNA特征序列的研究。     

溶质在两种反相色谱柱中的动力学色谱行为

研究了不同流速下4种溶质在两种不同反相色谱柱上的色谱图及它们的动力学色谱性质,进一步验证了溶质相对保留值(RRT)与流动相流速之间存在良好的双对数线性关系,并对溶质在流速改变时洗脱顺序发生改变的现象从动力学因素上进行了合理的解释;同时还发现色谱填料的孔径及拓扑学构型不同将导致溶质在其上具有不同的动力学色谱参数及动力学色谱行为。     

Preparation and Inhibitory Effects of 20（S）-Ginsenoside Rh2 on Hep-A-22 Cells

<正>A modified method of preparing 20(S)-ginsenoside Rh_2(G-Rh_2) and the inhibitory effect of 20(S)-ginse-noside Rh_2 on Hep-A-22 cells were investigated.The total saponins and strong alkali were dissolved in glycerol at the atmospheric pressure,and the degradation was performed at a high temperature.After G-Rh_2 had been isolated and purified,MTT(methyl thiazolyl tetrazolium) assay was applied to evaluating the effect of 20(S)-ginsenoside Rh_2 on the cells viability and morphological changes were observed.It was shown that 20(S)-ginsenoside Rh_2 can reduce Hep-A-22 cells viability in dose-dependent manner and the cells took on cell shrinkage,membrane blebbing,chromosomal condensations,especially under the higher concentrations of it.In conclusion,20(S)-ginsenoside Rh_2 can be prepared effectively that not only decreases viability but also induces the apoptosis of Hep-A-22 cells.     

“调配问题”的动态规划模型与计算

本给出了调配问题的动态规划模型与计算,该表征更具一般化,且便于计算机计算。     

Effects of Different Dispersion Methods on the Microscopical Morphology of TiO2 Film

Nanocrystalline porous TiO2 films were prepared on conducting glass supports （ITO） by processed commercial TiO2 nanometre powder （P25）. Three methods of physical dispersing for TiO2 powder, i.e. grinding, magnetic stirring, sonicleaning, were used to disperse TiO2 nanometre powder. Surface morphologies of TiO2 films were observed by optic-microscope and SEM. It is found that the surface morphologies of TiO2 films are determined not only by the dispersing methods but also by the percentage of TiO2 powder in the dispersing system. Different film morphologies can be obtained under the same preparation condition but with different dispersing methods. A lot of cracks exist on the film surface for which the TiO2 slurry is dispersed by grinding. Magnetic stirring leads to some white points and micro-holes on the film surface. Only a few of micro-holes can be observed on the film surface, in which the TiO2 slurry is dispersed by sonicleaning. Different surface morphologies can also be found with different thicknesses of TiO2 films. Different film thicknesses are due to different percentages of TiO2 powder in the slurry. The related mechanism leading to different features of the surface morphologies for the TiO2 films is discussed.     

融合形态学连通域和CV模型的民族服饰图案纹样元素分割方法

对民族服饰图案进行自动分割以提取图案纹样元素,是民族服饰图案素材库构建急需解决的难题。通过融合形态学连通域标记和CV模型（MCC-CV）,提出了一种民族服饰图案自动分割方法,首先对民族服饰图案进行预处理,然后采用形态学连通域标记算法获得待分割目标的位置和大致轮廓信息,对CV模型进行初始化,最后通过CV模型对不同分割目标进行边缘追踪,以实现民族服饰图案纹样元素的自动分割。实验表明,融合形态学连通域和CV模型的民族服饰图案纹样元素自动分割方法在边界召回率（BR）为0.5时,分割准确率为60%,与其他自动分割算法相比,该算法更为有效,满足了民族服饰图案素材库建设对图案纹样元素分割的基本要求。     

微顺序注射-分光光度法快速测定海水中总磷

基于微顺序注射-阀上实验室,采用磷钼蓝分光光度法测定了海水中总磷,对实验参数进行了优化,并选取了海水中主要成分离子进行了干扰实验。结果表明,海水中总磷质量浓度在0.009~1mg/L范围内与吸光度呈线性关系(r=0.9995),方法的检出限为0.003mg/L。该法测定秦皇岛黄金海岸表层海水中总磷浓度为0.090mg/L,与国标法测定结果0.088mg/L无显著性差异;测定含磷浓度为0.20mg/L的人工海水,相对标准偏差(RSD)为2.4%,样品加标回收率为94.4%~95.7%;海水中主要离子对本实验方法测定产生的干扰在5%以内。