Practical absorption limits of MPP absorber

The construction and properties of microperforated panel (MPP) absorber are discussed. The absorption limit of the absorber had been shown that low values of the perforate constant k = d(f/10)1/2 and the orifice diameter d (in mm) are essential for MPP to have high absorption in wide frequency band. To find the exact limits, take 1 for k as a start, because both specific resistance and high absorption require k around one. And the orifice diameter d is chosen as 0.1 mm, so that the peak absorption coefficient (resonance absorption) is at 1000 Hz, and high sound frequency may be in the absorption region. Is it possible for a single layer of such an MPP to cover the whole absorption region required in practice? The half-absorption limit is not a good criterion, because low absorption comes in also in some cases. The 0.5 absorption coefficient limit is suggested for practical region, as a standard for comparison. Absorption curves were drawn for different load resistances, of absorption coefficients versus frequency. Ordinary MPP absorber absorbs in slightly over two octaves, and the new absorber with r = 1 (specific resistance equal to the characteristic impedance in air)is slightly better than these, 2.5 octaves. The new absorbers with r > 1, are much better than these, and some satisfies high absorption in broad frequency range. Realization of these will mean great progress of MPP absorbers.     

强非线性吸收下高斯光束Z-扫描衍射理论模型

 摘要：在同时考虑非线性折射和非线性吸收的情况下，借助光的衍射理论，研究了Z-扫描技术的衍射理论模型，分析了非线性折射和非线性吸收同时存在时Z-扫描曲线的形状特征和变化规律。数值计算表明，非线性吸收相移和非线性折射相移的比值是影响接收小孔输出光功率的重要因素。要想得到好的光限幅效果，应选取非线性相移比值远小于1或远大于2的非线性材料。     

光学式低浓度甲烷气体传感器的研究

针对0.5%VOL以下的低浓度甲烷气体,设计了一种基于近红外可调谐半导体激光吸收光谱的光学式甲烷气体传感器.调谐激光器扫描甲烷气体位于1 653.72 nm处的吸收谱线,采用一次谐波"峰-平比"对气体浓度进行测量.该方案能够有效地消除激光器光强波动和其它同类光功率波动所带来的影响,通过标定后的测试实验表明传感器测量准确...     

电调制非分光红外瓦斯传感系统设计

基于气体红外光谱吸收原理,设计了一款电调制非分光技术的红外瓦斯传感器系统.该系统采用单光路双波长技术,以红外LED光源IRL715、防尘防水的吸收气室和热释电探测器件LIM-262组成光学探头,利用有源滤波和差分放大电路实现信号调理,采用二项式拟合瓦斯浓度-电压关系曲线,实现了对瓦斯浓度的精确探测.实验表明,该传感器能...     

NaAlH4 表面Ti催化空间构型和X射线吸收光谱: Car-Parrinello分子动力学和密度泛函理论研究

通过采用Car-Parrinello分子动力学方法对掺杂Ti前后的NaAlH₄(001)2×2×1超晶胞表面晶体在333 K(60 ℃)温度条件催化脱氢的空间构型做了理论研究,发现掺杂Ti的合金中AlH₄团的其中两个Al—H键长分别从约1.64 (1 =0.1 nm)增大至1.74和1.93 ,而未掺杂合金表面中AlH₄团的4个Al—H键长基本不变,这意味着掺杂Ti相对未掺杂的合金更易于放氢.但在模拟温度条件下并未发现Ti-Al成键趋     

平台石墨炉原子吸收法测定合金钢中痕量镉

本文研究了平台石墨炉原子吸收法直接测定合金钢中的痕量镉,不需分离,不需加基体改进剂。测定范围为Cd 1μg/g～10μg/g;相对标准偏差为9.0%～14.0%;回收率为98%～102%。     

高精度非线性格式WCNS的分析研究与其应用

首先将Fourier方法推广于高维方向研究了五阶精度WCNS的特性,并与其他高阶格式进行比较。分析结果表明WCNS的高精度特性普遍接近甚至好于迎风偏置五阶显式格式EUW-5与Pade′标准格式。然后开展了WCNS的应用研究,采用高效率的WCNS-E-5数值模拟了含强激波的高维复杂流场。算例包括二维高超声速边界层对自由流扰动波的吸收问题以及三维球头绕流问题。计算结果反映出WCNS-E-5对激波等间断的良好捕捉能力,图像清晰光滑,数据准确可靠。     

傅立叶变换激光腔内吸收光谱方法研究吸收谱线的强度与线形

在原有傅立叶变换激光腔内吸收光谱实验装置的基础上,利用信号差分方法减少了光强波动对实验干涉谱图的影响,改善了信噪比.通过对大气中氧气在760nm处的吸收谱线的绝对强度测量,验证了该方法的定量测量能力.在不同压力条件下对磷烷v=6伸缩局域模泛频吸收谱带进行了测量,获得了其谱线的自压力加宽和自压力线移参数.     

Preparation of Ni-B Coating on Carbonyl Iron and Its Microwave Absorption Properties in the X Band

Ni-B coated carbonyl iron particles （CI@Ni-B） are prepared by the electroless plating technique. The structure, morphology, and antioxidant properties of the CI@Ni-B particles are analyzed. The results demonstrate that the CI particles have been coated with intact spherical-shell Ni-B coating, indicating the core-shell structure of CI@Ni-B particles, and the Ni-B coating can prevent the further oxidation of the CI particles. Compared with the raw CI particles/paraffin coatings with the same coating thickness of 2.0mm and particles content of 70%, the CI@Ni-B particles/paraffin coatings possess higher microwave absorption （the RL exceeding -10 dB is obtained in the whole X band （8.2-12.4GHz） with minimal RL of -3f.OdB at 9.2GHz）.     

测量光折变非线性参量动态行为的一种新方法

在z扫描方法的基础上，提出了一种测量光折变非线性参量动态行为的新方法——时间扫描方法.理论和实验研究结果表明，这种新方法是精确、可行的. 关键词： 时间扫描方法 z扫描方法 非线性折射率 非线性吸收