轴流压气机势流和尾迹相互干涉叠加效应分析

尾迹与势流的相互作用对压气机叶片表面的压力波动强度和出口的轴向速度分布及波动会产生很大影响。针对两级跨声速轴流压气机,采用数值方法研究两排转子叶片周向相对位置不同情况下,叶片表面压力波动抵消区域位置发生的变化。研究结果表明:转子叶片周向位置的变化会对静子叶片尾迹形态产生影响,会导致叶片表面压力波动抵消区域发生变化。伴随转子叶片周向相对位置的变化,存在上游转子叶片尾迹减缓下游静子叶片尾迹衰减的现象,从而改变了叶片排之间的相互干涉强度,并使叶片表面压力波动强度发生变化。     

液态硝基甲烷热分解行为及压力效应的第一性原理研究

采用基于密度泛函理论的第一性原理分子动力学方法对液态硝基甲烷的热分解行为进行了模拟,结合各产物布居数随时间的演化,讨论了热分解初期可能发生的3种反应,即分子内/分子间的质子迁移反应和C—N键的断裂.在长时间（30 ps）的模拟过程中,H₂O是主要产物.研究了液态硝基甲烷在不同密度（压力）条件下热分解的动力学行为.发现不同密度（压力）条件下液态硝基甲烷热分解呈现明显不同的变化趋势,并给出了解释. 关键词： 硝基甲烷 分子动力学 热分解 压力效应     

LOCAL BENDING OF THIN FILM ON VISCOUS LAYER

Effects of deposition layer position film are systematically investigated. Because the and number/density on local bending of a thin deposition layer interacts with the thin film at the interface and there is an offset between the thin film neutral surface and the interface, the deposition layer generates not only axial stress but also bending moment. The bending moment induces an instant out-of-plane deflection of the thin film, which may or may not cause the socalled local bending. The deposition layer is modeled as a local stressor, whose location and density are demonstrated to be vital to the occurrence of local bending. The thin film rests on a viscous layer, which is governed by the Navier-Stokes equation and behaves like an elastic foundation to exert transverse forces on the thin film. The unknown feature of the axial constraint force makes the governing equation highly nonlinear even for the small deflection chse. The constraint force and film transverse deflection are solved iteratively through the governing equation and the displacement constraint equation of immovable edges. This research shows that in some special cases, the deposition density increase does not necessarily reduce the local bending. By comparing the thin film deflections of different deposition numbers and positions, we also present the guideline of strengthening or suppressing the local bending.     

二次喉道扩压器对COIL的影响实验

 氧碘化学激光器分别采用二次喉道扩压器和8°扩压器时，对在不同阀门开度下的气流方向的壁面静压曲线和背压曲线，光轴壁面静压曲线，出口总压与上游压比值曲线，输出功率曲线进行了测量。对两种扩压器的数据进行了对比，结果表明：与8°扩压器相比，二次喉道扩压器能够有效隔离扩压器下游气流对光腔的干扰，显著减小捩区长度，并将转捩区控制在扩压器内。在激光器背压升高时，二次喉道扩压器的稳定性更强。     

冻干过程中升华界面温度测量方法的研究

压力测温技术是基于在平衡状态下,冰晶温度与其饱和蒸汽压为单值函数这一基本规律,在升华干燥过程中,突然中断从冻干室流向冷阱的水蒸汽流,通过测量冻干室内压力回升情况去推算升华界面温度的一种非接触式测温方法。与热电偶或热敏电阻测温相比,压力测温技术即不破坏冻干样品的结构,又能够较为准确地反应出移动升华界面的温度,并能判断升华干燥过程终点。文中分析了升华界面温度测量的意义与困难,建立了压力测温技术的数学模型与分析方法,并通过实验研究了压力测温技术。     

压力及杂质氢对金属锂弹性特性的影响

针对六角密堆金属锂16个原子超晶胞(supercell)、填隙一个氢原子的周期单元，采用基于密度泛函理论的平面波-赝势方法，研究了零温条件下压力及填隙氢掺杂对体系弹性性质的影响.结果表明氢掺杂导致体系的体模量增加.常压下掺杂体系的弹性常数C₁₁，C₃₃，C₆₆和C₁₂高于单质体系，剪切模量C₄₄有所下降，而C₁₃则与单质体系持平.压力作用下C₁₁，C₃₃和C₆₆一直大于单质体系，但C₁₂的值低于单质体系.在2GPa—4GPa压力区间内，弹性常数C₁₃呈反常变化，小于单质体系；在高压区掺杂体系的C₄₄和C₁₃则高于单质体系的相应量值，压力导致掺杂体系和单质体系之间剪切模的偏离加剧.掺杂体系在压力作用下依然保持压缩模的各向同性，具有和单质体系相似的特性. 关键词： 第一性原理 压力效应 弹性常数 金属锂     

Effect of Temperature on the Void Growth in Pure Aluminium at High Strain-Rate Loading

With the environment temperature varying from 273 K to 773 K, the dynamic process of void growth in pure aluminium at high strain-rate loading is calculated based on the dynamic growth equation of a void with internal pressure. The result shows that the effect of temperature on the growth of void should be emphasized. Because the initial pressure of void with gas will increase and the viscosity of materials will decrease with the rising of temperature, the growth of void is accelerated. Furthermore, material inertia restrains the growth of void evidently when the diameter exceeds 10 μm. The effect of surface tension is very weak in the whole process of void growth.     

Measuring Grüneisen Parameter of Lead by High Pressure-Jump Method

Using the technology of pressure jump, variations of temperature associated with pressure from 2.4 GPa to 4.6 GPa are measured for lead. The Grfuneisen parameter is calculated from the thermodynamic relation γ =（Ks/T）（aT/aP）s, in which substitution of △T/△P for aT/aP at median pressure is strictly justified. The correction of temperature change is carried out by analysing the experimental data, which makes the process more approaching to an adiabatic condition. The calculated values of △T/ △ P and γ gradually decrease with the increasing pressure. The decrease trend is consistent with the previous work. The γ values in the range of 2-3 GPa are averagely higher than the results of Ramakrishnan et al., indicating the effect of temperature correction. The improved method is promising for measurements of Grfineisen parameter to higher pressure range.     

阿伏伽德罗（Avogadro，Amedeo,1776-1856）意大利物理学家（Physicist，Italy）

阿伏伽德罗出生于都灵的一个贵族家庭，毕生致力于原子论的研究。当时由于道尔顿和盖-吕萨克研的工作，近代原子论处于开创时期，阿伏伽德罗从盖-吕萨克定律得到启发，于1811年提出了一个对近代科学有深远影响的假说：在相同的温度和相同的压力条件下，相同体积中的任何气体总含有相同的分子个数。但他的这个假说却长期不为科学界所认同，主要原因是当时科学界还不能区别分子和原子，同时由于有些分子发生了离解，出现了一些阿伏伽德罗假说难以解释的情况。