合成孔径成像激光雷达成像算法研究

在描述了调频连续波信号模型以及其外差接收体制特点的基础上,针对传统合成孔径雷达的"一步一停"模型中忽略的平台连续运动引入的多普勒频移项,采用线性调频连续波信号的合成孔径成像激光雷达瞬时距离较传统合成孔径雷达的改变.推导出在该模型下一种适用于机载合成孔径成像激光雷达系统的频率变标算法,一并考虑了在连续波信号模型中多普勒频移项对成像的影响.仿真证明了该算法能有效补偿平台连续运动带来的影响.     

A High-Power Continuous-Wave Laser-Diode End-Pumped Nd：YVO4 Laser of Single-Frequency Operation

We design and build a cw high quality and high power Nd:YV04 laser of single frequencv operation with a laser-diode dual-end-pumped geometry. The influence of the Nd^3 -doping concentration in the Nd:YVO4 crystal on the output performance of laser is theoretically and experimentally studied. With a Nd:YVO4 crystal of the Nd^3 -doping concentration 0.3 at. % and at pump power of 45 W, the output power of the single frequency laser is 18 W, and the slope efficiency is 48%.     

Efficient and high-power laser-diode single-end-pumped Nd：YVO4 continuous wave laser at 1342nm

A compact, efficient and high-power laser diode （LD） single-end-pumped Nd：YVO4 laser with continuous-wave emission at 1342 nm is reported. With a single crystal single-end-pumped by fibre-coupled LD array, an output power of 7.36W is obtained from the laser cavity of concave-convex shape, corresponding to an optical-to-optical efficiency of 32.8%. The laser is operated in TEM00 mode with small rms amplitude noise of 0.3%. The influences of the Nd concentration, transmissivity of the output mirror and the cavity length on the output power have been studied experimentally.     

调频连续波分布式光纤布拉格光栅复用系统

研究了利用调频连续波(FMCW)技术对分布式光纤布拉格光栅(FBG)复用系统进行寻址的基本原理;仿真分析了FBG传感器复用距离是系统最小分辨距离的整数倍或非整数倍时,对频谱信号的影响;搭建了基于FMCW的FBG复用系统实验平台,当传感距离1000 m时,分别验证了不同扫描周期与复用系统差频信号的线性关系,及不同扫频范围与系统差频信号的线性关系。实验结果表明：FBG复用距离是系统最小分辨距离整数倍时,在测量距离1100 m范围内,系统测量最大误差为243 Hz,最大相对误差小于5%,可以实现FBG传感器的地址查询功能。     

散斑照相孔径优化的研究

本文提出了三种新的散斑照相孔径方法:一维调频孔径法,交叉孔径法和旋转孔径法。给出了理论分析和实验证明。这些方法简单实用,能有效地改变衍射晕的能量分布。适当选择孔径的参数,实验者能相当任意地控制散斑图的空间频率成份。新方法兼顾了突出某一频率成份、灵敏度连续可调、获得多个方向散斑场运动信息等各方面的特性。     

Simulation of continuous terahertz wave transient state thermal effects on static water

We report a numerical simulation of continuous terahertz beam induced transient thermal effects on static water. The terahertz wave used in this paper has a Gaussian beam profile. Based on the transient heat conduction equation, the finite element method (FEM) is utilized to calculate the temperature distribution. The simulation results show the dynamic process of temperature change in water during terahertz irradiation. After about 300 s, the temperature reaches a steady state with a water layer thickness of 5 mm and a beam radius of 0.25 mm. The highest temperature increase is 7 K/mW approximately. This work motivates further study on the interaction between terahertz wave and bio-tissue, which has a high water content.     

36 W侧面抽运腔内倍频Nd:YAG/KTP连续绿光激光器

通过优化平-凹-平三镜折叠腔结构设计,利用大功率半导体激光器侧面抽运、Ⅱ类相位匹配KTP晶体腔内倍频,获得高效高功率连续绿色激光输出.当抽运电流约为36 A时,得到最高36.6 W的连续绿光激光输出,对应的光—光转换效率为8.71％.在输出功率33 W时测量激光功率稳定性,其功率不稳定度为0.27%.用刀口法测量了激光器高输出功率时的光束质量,光束质量因子小于8.对高功率抽运情况下三镜折叠腔的像散补偿、失调灵敏度和基模在腔内分布情况做了数值模拟. 关键词： 侧面抽运 腔内倍频 连续波     

1.319 μm连续波激光辐照PV型HgCdTe探测器的实验研究

用连续波1．319μm激光辐照PV型HgCdTe红外探测器,得到了不同辐照功率密度下,探测器的响应输出随激光功率密度变化的一系列实验结果,观察到了器件对光的线性、饱和响应以外的一些新现象,如混沌、零压输出,并对实验结果作了初步的解释。     

CW-COIL激光束漂移和光斑的诊断

 利用光斑动态分析仪测试技术，对连续波氧碘化学激光器输出的光束不稳定性进行定量诊断，其中包括光束的漂移、低频抖动、光强分布、光斑直径随时间的变化等内容，并初步分析了激光输出不稳定的原因。诊断的结果为激光器的稳定输出及激光—材料实验研究提供了依据。     

线性调频半导体激光器自混频干涉理论模型

使用半导体激光器在弱反馈条件下的动力学理论,建立了线性调频半导体激光器的自混频干涉理论模型.基于该模型,分析了激光器振荡频率偏移与输出功率变化特性.通过测量激光器输出功率谱,可以得到激光器前端面与被测目标之间的距离.