A modal analysis for the acoustic radiation problems, Ⅱ. Examples

The acoustic radiation modes and the field distribution modes describe the radiation patterns of a complex vibrating surface and the field distribution patterns respectively. The physical meanings of the acoustic radiation modes and the field distribution modes are revealed by numerical method. For a sphere body, a spinning body and a rectangular body, the geometrical patterns of the acoustic radiation modes and the field distribution modes are given. The radiation mode 1 represents the radiation behavior of a monopole radiator, the radiation modes 2 through 4 represent the radiation behavior of dipole radiators respectively, and the radiation modes 5 through 9 represent the radiation behavior of quadrapole radiators respectively. The acoustic radiation modes and the field distribution modes introduce the multi-pole decomposition method into discussion of the acoustic radiation problems.     

A New High Efficiency Multiwave Cerenkov Generator Operating at Low Magnetic Field

With a resonant cavity inserted between the second slow-wave-structure section and the tapered wavegulde, a new structure of the multlwave Cerenkov generator (MWCG) operating at low guiding magnetic field is proposed to produce high efficiency and high power microwave. Some features and potential advantages of the proposed device are analysed. The 2.5-dimensional partlcle-in-cell simulation is employed to verify the initial expectation.The results show that, with the use of an electron beam of 640keV and 8.4kA guided by the magnetic lield of 0.6 T, a stable and monochromatic X-band microwave output of 4 GW in peak power is achieved, and the average efficiency is over 30%.     

抽指加权宽带扇形叉指声表面波滤波器的等效电路分析

扇形换能器可以看成若干个沿孔径方向划分的均匀孔径换能器电端并联而成，根据梅森(Mason)等效电路模型以及由其延伸的混合场等效电路模型，推导出整个扇形换能器的导纳矩阵和频率响应，其中采用复阻抗模型考虑了叉指电极与自由表面的阻抗不连续的因素。本方法能够模拟指间反射、三次行程、指条寄生阻抗以及外围电路等对器件性能的影响；理论模拟与实验结果吻合。     

固态金属中声子热传递的分子动力学模拟研究

固态金属中的热传递是声子和自由电子共同作用的结果。自由电子引起的热导率可以通过电导率,利用Wiedemann-Franz定律得到,声子引起的热导率目前仍然不能进行实验测量,只能借助其他方法来研究。本文采用非平衡分子动力学(NEMD)方法,用镶嵌原子方法(EAM)势能模型,模拟计算了不同厚度(1.760-10.56nm)金属镍薄膜中由于声子-声子作用引起的热导率。然后根据纳米厚度金属薄膜的热导率借助关联式推到宏观尺度下由于声子-声子作用引起的热导率。结果表明,对于纳米厚度金属薄膜,由于声子-声子作用引起的热导率比块体金属镍的热导率小一个数量级;薄膜厚度越小,声子-声子作用引起的热导率越小;对于块体金属镍,由于声子-声子作用引起的热导率约占其总热导率的33.0%左右。     

Longitudinal leaky surface acoustic wave on Y-rotated cut quartz substrates

The properties of Quasi-longitudinal leaky surface acoustic wave(QLLSAW) on Y-rotated cut quartz substrates were presented. The phase velocity of QLLSAW on the quartz substrate along some orientations can be up from 6200 m/s to 7100 m/s, circa 100% above that of regular SAW. Both theoretical and experimental results show that QLLSAW propagating along some promising orientations for SAW devices are of small power flow angle and low tem-perature coefficient, for example, along the Euler angle (0°155.25°? 42°?, the measurements of phase velocity and temperature coefficient of delay of QLLSAW are 6201 m/s and 12.9 ppm/℃. The experimental results show that QLLSAW had little absorption by liquid loading on the substrate surface, which proved that the direction of particle motion is the same as wave vector and parallel to the surface of the substrates, i.e., the wave is of the properties of longitudinal wave.     

高能、超短脉冲、可调谐激光器用掺镱氟磷酸盐玻璃研究进展

Yb^3 与其它稀土离子相比有最简单的能级结构，这使它具有一些独特的性质，如避免激发态吸收，消除上转换和浓度猝灭等，因此它是高能输出激光器介质的理想掺杂离子。氟磷玻璃综合了氟化物玻璃和磷酸盐玻璃的优点，可降低磷酸盐的声子能量，改善其易吸湿性；提高氟化物玻璃的物理化学性能等，这使它成为稀土掺杂可调谐光纤激光器的很好的掺杂介质。众多研究表明，Yb^3 掺杂氟磷玻璃是一种很有前途的激光工作物质。本文总结了Yb^3 掺杂氟磷玻璃的特点，性质，结构及存在的问题。     

Giant Magneto-Impedance of Co50Ni22Ga28 Alloy with High Chemical Ordering

The microstructure of CosoNi22Ga28 ribbon with the L10 structure is examined. The band-like morphology is observed. These bands with the width in a range of 40-200 nm appear along the transverse direction of the ribbon. The giant magnetoimpedance （GMI） effect in this alloy is measured. The results show that Co5oNi22Ga28 exhibits a sharp peak of the GAI effect. The maximum GAH ratio up to 360% is detected. The GMI effect measured versus temperature shows large jumps of the magnetoimpedance amplitude at the reversal martensitic transformation temperature 240℃ and Curie temperature 375℃C respectively. The jump ratios of the magnetoimpedance amplitude examined at these temperatures are about 5 and 10, respectively.     

亚像元动态成像技术中系统调制传递函数的数值分析

亚像元动态成像技术是目前实现遥感器小型化非常有效的新方法,因而研究亚像元动态成像系统的调制传递函数MTF显得非常必要和重要.介绍了亚像元动态成像的基本原理及成像过程,指出了光程差对亚像元动态成像系统MTF的影响.对亚像元动态成像系统的MTF进行了数值分析,并指出了亚像元动态成像系统的成像质量及空间分辨率与一般成像系统相比较的优点.     

基于成像机理的小波包变换多聚焦图像融合

由于可见光成像系统的聚焦范围有限,因而在成像过程中,除聚焦良好的物体能生成清晰的图像外,该物体前后一定距离外的所有物体都将呈现不同程度的模糊.为了获得场景内所有物体均清晰的图像,在分析了多聚焦图像成像机理的基础上,提出了一种基于小波包变换的融合方法.它是将成像系统先聚焦在一部分对象上,得到其清晰的图像;然后再将其聚焦在另一部分对象上,得到另一清晰的图像;最后把这两幅实验图像加以融合,从而获得场景内所有物体均清晰的图像.实验结果表明,基于小波包变换的融合方法能够将信号的频带进行多层次划分,对高频成分也能进一步地分解,可有效综合多聚焦图像.     

波段三维ESR成像系统的研制（Ⅴ）——灵敏度与分辨率实验及系统总性能指标

实验确定了自行研制的L波段三维电子自旋共振成像（3D-ESRI）系统的检测灵敏度及成像分辨率指标. 用Tempo水溶液模型测量灵敏度结果表明： 样品体积为10 mm, 高30 mm，测量浓度1×10^-4 mol/L水溶液的信噪比为S/N=4∶1；加梯度磁场后，样品浓度需>5×10^-4 mol/L，样品体积为19 mm, 高30 mm时，获得的投影谱的信噪比可满足图像重建的需要. 用DPPH固体样品确定的成像分辨率结果<1 mm. 文中还对ESRI系统的
各项总体性能做了归纳总结.