同轴型爆磁压缩发生器1维磁扩散模型

 基于１维爆轰驱动模型、爆炸管与金属固壁的１维磁扩散模型及回路等效电路模型,编制了关于轴线起爆大电流同轴型爆磁压缩发生器的数值模拟程序CEMG2.0。应用该程序对洛斯·阿拉莫斯实验室设计试验的43 cm长Ranchero发生器进行了对比模拟,结果证明CEMG2.0程序所采用的模型是合理的,可以应用于今后同类发生器的优化设计。     

尿样中核基质蛋白22的免疫电化学生物传感器研制

将(4,4',4',4')四羧基酞菁钴(CoTcPc)和HRP标记核基质蛋白22抗体(HRP-Ab-NMP22)一起固定在Au电极表面,构建了一种快速测定膀胱肿瘤患者尿液中NMP22抗原含量的安培免疫传感器(HRP-Ab-NMP22/Fe3O4/CoPc CME).实验表明:该传感器对NMP22抗原具有良好的电化学响应,HRP对H2O2电催化氧化电流I0降低,△I0与NMP22浓度在1.0～150ng·mL-1成线性关系,检测限则为0.5ng·mL-1.该传感器基于一次性竞争性免疫反应,较Elisa法提高了检测速度,有望用于膀胱肿瘤的迅速诊断.     

光栅磁光阱中原子受力理论分析

从原子受力模型出发,研究光栅磁光阱中衍射光与磁场非正交条件下亚多普勒冷却机制,建立四束型和五束型光栅磁光阱中原子受力冷却和陷俘理论模型,分析光栅磁光阱作用下原子受到散射力与陷俘速度、回复力与形成势阱范围关系,以及光栅衍射角对原子陷俘速度和原子囚陷范围的影响。结果表明,衍射光与入射光的合力在磁场中心位置为零,构成有效势阱,光栅衍射角引起的衍射光偏振分量的变化对原子所受阻尼力、回复力和原子陷俘速度均有影响,也会最终影响到光栅磁光阱囚禁的原子数,为光栅磁光阱实现原子冷却和陷俘,以及光栅芯片设计提供了理论依据。     

可磁分离的氮掺杂二氧化钛光催化剂的制备及光催化性能

将氮掺杂二氧化钛和通过液相催化相转化制备的磁性载体混合、煅烧制备了一种可磁分离的光催化剂TiO2-xNx/SiO2/NiFe2O4(TSN), 这种光催化剂显示出了典型的铁磁性和可见光活性(λ>400 nm). 对该光催化剂的XRD谱图和透射电镜照片进行分析. 结果表明, SiO2/NiFe2O4(SN)纳米粒子黏附在TiO2-xNx聚集体的表面形成了TSN复合光催化剂. 利用光催化降解甲基橙的效果来评价这种光催化剂的活性. 结果表明, 在NiFe2O4和TiO2-xNx之间包覆一层无定形的SiO2, 可以显著地提高催化剂的脱色效果.     

反相微乳液法制备纳米Ag2S增感剂的化学增感研究

本文用反相微乳液法制备了纳米Ag₂S,并用作卤化银乳剂的硫增感剂,研究了其增感效果、增感规律及可能的增感机理.反相微乳液由异辛烷、表面活性剂AOT钠盐和水形成;制得的Ag₂S粒径3—5 nm;用制得颗粒增感卤化银乳剂,获得的感光性能优越于用Na₂S₂O₃水溶液增感;增感规律的研究表明,随着乳剂中纳米Ag₂S浓度的增加,模型乳剂感光度迅速提高、灰雾变化不大,并在100—200μmol/molAg左右获得最佳感光性能,进一步增加浓度则感光度呈下降趋势、灰雾升高;获得最佳感光性能所需的化学增感时间很短,约40分钟,之后感光度不再增加、灰雾上升;用漫反射光谱(DRS)作探针,跟踪记录增感时卤化银微晶表面上纳米Ag₂S增感剂颗粒的演变,为新型纳米增感剂的优异增感特性提供了机理性解释.     

MAGNETOMECHANICAL BEHAVIORS OF GIANT MAGNETOSTRICTIVE MATERIALS

The Laves phase alloy Tb-Dy-Fe, commercially known as Terfenol-D, exhibits the giant room-temperature magnetostriction at moderate field strength of a few kOe due to its combination of high magnetostriction and low magnetocrystalline anisotropic energy. Thus, this pseudobinary rare earth iron compound has found quite a number of applications such as in magnetomechanical transducers, actuators and adaptive vibration control systems. The simultaneous measurements of magnetostriction and magnetization at various fixed compressive pre-stresses applied in the axial direction for Tb0.3Dy0.7Fe1.95 samples are presented. The results show that the magnetostriction increases with increasing compressive stress until it reaches 1742 ×10^6 under 25 MPa, so does the coercive magnetic field. And the hysteresis loop area for magnetization and magnetostriction also increases with the increment of applied compressive stresses. But the maximum magnetic susceptibility χ（dM/dH） is obtained under zero stress field and the strain derivative dλ/dH increases to the highest amplitude of 0.039×10^-6 A^-1m at a stress level of 5 MPa. In the strain versus magnetization intensity curve, the initial fiat stage mainly consisting of a 180° domain wall motion becomes shorter with increasing stress. It means more initial domains are driven to the transversal direction under the compressive stress before magnetization, which is consistent with the improvement of the magnetostriction.     

DEPENDENCE OF DAMPING CHARACTERISTICS OF A BEAM WITH DAMPING RUBBER MAGNETIC POWDER ON RUBBER PROPERTY

A cantilever beam with Damping Material Applying Rubber Magnetic Powder （DRM） has been investigated. Two methods are selected to hold DRM to a vibrating steel beam, one is to attach DRM by the magnetic attractive force （called DRM beam） and the other by adhesive bonding （called AB-DRM beam）. Different from the damping property of AB-DRM beam caused by shear deformation of damping material, the damping property of DRM beam is characterized by the sliding frictional loss together with the internal loss of damping material. The authors established a formulation to predict the damping characteristics of DRM beam, which was validated experimentally. It is found that rubber material loss factor β has a decisive influence on damping improvement of DRM beam versus AB-DRM beam. If β is smaller than the critical value around 0.8255, a valid range of vibratory amplitude always exists in which DRM beam can achieve better damping than AB-DRM beam; conversely, if β is bigger than the critical value, the valid range does not exist when slide occurs. Such results are used to determine the merits and limitations of DRM and develop design guidelines.     

WAVE PROPAGATION IN PIEZOELECTRIC/PIEZOMAGNETIC LAYERED PERIODIC COMPOSITES

This paper is concerned with the dynamic behaviors of wave propagation in layered periodic composites consisting of piezoelectric and piezomagnetic phases. The dispersion relations of Lamb waves axe derived. Dispersion curves and displacement fields are calculated with different piezoelectric volume fractions. Numerical results for BaTiO3/CoFe2O4 composites show that the dispersion curves resemble the symmetric Lamb waves in a plate. Exchange between the longitudinal （i.e. thickness） mode and coupled mode takes place at the crossover point between dispersion curves of the first two branches. With the increase of BaTiO3 volume fraction, the crossover point appears at a lower wave number and wave velocity is higher. These findings are useful for magnetoelectric transducer applications.     

PPCP用固态脉冲电源的实验研究

 介绍了一种采用半导体开关与磁开关、可饱和脉冲变压器相结合技术的固态脉冲电源,此电源可用于脉冲放电等离子体烟气治理。在理论分析的基础上建立了实验模型,通过实验验证了此类电源的可行性,解决了8支晶闸管开关串联的动静态均压及开通同步性问题,并对可饱和脉冲变压器及磁开关的工作特性进行了分析计算。电源在阻性负载上得到峰值电压37.5 kV、前沿101 ns、脉宽1 μs的脉冲,重复频率300 Hz,输出功率10 kW。     

放大反应-氯化钠增敏光度法测定食品中的微量碘

样品中的有机碘高温灰化后,在酸性条件下,经饱和溴水将I^-氧化为IO3^-.在0．06％的磷酸酸度条件下,以KI还原KIO3,使样品中的碘放大六倍。系统优化选择了定波长、磷酸酸度、氯化钠质量浓度、淀粉用量、碘化钾用量等。在选定的最佳实验条件下,碘质量浓度在0～3．2μg／mL范围旱良好线性关系,相关系数为0．9995;方法榆出限为0．028μg／mL,回收率为96．27％～106．43％。