YZr2OZr3:Er3+纳米晶anti-Stokes发光性质的研究

采用均相沉积法制备了不同Er³⁺离子浓度掺杂的Y₂O₃纳米晶, 应用XRD，SEM和PL光谱对该体系材料进行了表征.在Y₂O₃:Er³⁺纳米材料体系中, 观察和研究了Stokes及anti-Stokes PL谱强度与Er³⁺离子摩尔浓度变化的关系, 当Er³⁺离子浓度为2.0mol%时, anti-Stokes PL强度最强.粉末X 关键词： 氧化钇纳米晶 anti-Stokes PL 双光子吸收     

BNCT蒙特卡洛剂量计算的混合网格算法研究

在硼中子俘获治疗(BNCT)的蒙特卡洛(MC)剂量计算中,通常使用单一的网格模式,如16mm,8mm,4mm.使用细网格计算资源太大,使用粗网格,计算精度不够,为此,根据粒子穿透深度和计数量的变化梯度,采用混合网格模拟计算,达到了细网格的精度,时间仅为细网格的37%.     

Solutions for a Mode Ⅲ Growing Crack in a Piezoelectric Plane Under Two Kinds of Electric Boundary Conditions ＊

The solutions for a mode Ⅲ crack growing along an arbitrary propagation path in a piezoelectric plane are studied under the impermeable surface condition and the electrical contact surface condition respectively. According to the two kinds of electric boundary conditions, the Hilbert and Riemann boundary value problems in a half-plane including opening smooth arc are obtained from the theoretical analysis. Moreover, the equipollence of the solution formed under these two electric boundaries is proved, and unified solutions for the stress and electric displacement distribution in the crack-tipfield of the piezoelectric plane are achieved.     

Design and Fabrication of 1.06 μm Resonant-Cavity Enhanced Reflective Modulator with GaInAs/GaAs Quantum Wells

A resonant-cavity enhanced reflective optical modulator is designed and fabricated, with three groups of three highly strained InGaAs/GaAs quantum wells in the cavity, for low voltage and high contrast ratio operation. The quantum wells are positioned in antinodes of the optical standing wave. The modulator is grown in a single growth step in an molecular beam epitaxy system, using GaAs/AlAs distributed Bragg reflectors as both the top and bottom mirrors. Results show that the reflection device has a modulation extinction of 3 dB at -4.5 V bias.     

聚甲基丙烯酸甲酯掺杂Ce3+的飞秒激光三维信息存储

用飞秒激光(200 fs,1 kHz,800 nm)脉冲在掺杂稀土离子Ce3 的聚甲基丙烯酸甲酯(PMMA)膜中进行了光存储实验研究,包括对样品的吸收光谱、激光照射前后的电子旋转共振(Electron spin resonance,ESR)光谱的测量和讨论。结果表明掺杂稀土离子Ce3 的聚甲基丙烯酸甲酯膜具有较低的写入阈值,有利于高速、并行的三维光存储。实验结果采用传统光学显微镜并行读出。给出了四层存储结果(点间距和层间距分别是4μm和16μm),并讨论了脉冲能量的大小对空腔尺寸的影响,进行高密度存储时,在保证读出信号灰度值足够大的情况下,应选择尽量小的激光脉冲写入能量。实验结果表明这种材料可以应用于三维光信息存储。     

用于原子吸收光谱仪的高灵敏度燃烧器

本文介绍了一种用于原子吸收光谱仪的气－样分进、双通道燃烧器，经过实际检测比较，该坷提高原子吸收灵敏度１￣５倍，且稳定性好。     

光声光谱法研究光学薄膜的吸收特性

本文以“一维热流活塞模型”为基础,推导出薄膜光声表达式,光声信号的幅值正比于吸收率.测量了透明基底上光学薄膜的光声吸收谱,实验结果与理论一致.尤其是测量弱吸收薄膜的吸收谱时,具有较高的灵敏度和实用性.     

电沉积富铁Fe-Ni合金箔工艺的研究

对硫酸盐-氯化物电解液中电沉积富铁Fe-Ni合金箔的工艺进行了研究,讨论了电解液组成、电流密度、温度及pH值等因素与合金箔组成之间的相互关系,得到了制备富铁合金箔的最佳镀液组成及工艺条件,并通过实验确定在阴阳极比为1:2时,镍铁联合阳极配比为1.5:1.通过扫描电镜,能谱和X-衍射对富铁Fe-Ni合金箔的形貌及结构进行分析表明合金箔晶粒细致,尺寸均匀,结构紧密,表面光滑平整,无孔洞和裂纹,晶粒结构为(111),(200),(311)及(222)织构,并表现为较强的(111)择优取向.