液体粘滞系数计时位移起点和温度关系研究

讨论了液体粘滞系数计时起点的确定依据,通过人眼分辨本领的研究确定了钢球下落计时的最佳观测起点,对钢球下落的计时位移起点和温度的关系展开讨论,给出了目前大学物理粘滞系数实验的速度和时间精度要求的理论依据。     

温度和支撑方式对1.2m SiC主镜面形的影响分析

为了研究温度和支撑方式对大口径SiC主镜用于地基望远镜的影响,基于1.2 m SiC主镜建立了有限元模型,分析了主镜在被动支撑和自由膨胀时,恒定温度场,轴向温度梯度,径向温度梯度和内外温差等对主镜面形的影响.结果表明,存在温度梯度时,支撑方式影响不明显,无论是被动支撑还是自由膨胀,镜面面形均很大.在达到热平衡后,即稳态...     

激光诱导铝合金E414d等离子体电子温度的空间分布

 采用调Q Nd:YAG脉冲激光诱导铝合金E414d,研究了等离子体的谱线强度、电子温度和电子密度。建立Al (Ⅰ) 256.80 nm、Al (Ⅰ) 308.21 nm和Al (Ⅰ) 396.15 nm的波耳兹曼平面,实验发现距靶面高度1.5 mm处等离子体的电子温度最高。罗仑兹函数拟合Mg (Ⅰ) 285.21 nm得到等离子体的电子密度是1.9×10₁₈ cm_-3,远大于局域热力学平衡所需的电子密度值9.8×10₁₅ cm_-3,证明实验得到的等离子体满足局部热力学平衡。     

Effect of substrate temperature on microstructure and optical properties of single-phased Ag20 film deposited by using radio-frequency reactive magnetron sputtering method

Using a radio-frequency reactive magnetron sputtering technique, a series of the single-phased Ag20 films are deposited in a mixture of oxygen and argon gas with a flow ratio of 2：3 by changing substrate temperature （Ts）. Effects of the Ts on the microstructure and optical properties of the films are investigated by using X-ray diffractometry, scanning electron microscopy and spectrophotometry. The single-phased Ag20 films deposited at values of Ts below 200℃ are （111） preferentially oriented, which may be due to the smallest free energy of the （111） crystalline face. The film crystallization becomes poor as the value of Ts increases from 100℃ to 225℃. In particular, the Ag20 film deposited at Ts=225℃ loses the （111） preferential orientation. Correspondingly, the film surface morphology obviously evolves from a uniform and compact surface structure to a loose and gullied surface structure. With the increase of Ts value, the transmissivity and the reflectivity of the films in the transparent region are gradually reduced, while the absorptivity gradually increases, which may be attributed to an evolution of the crystalline structure and the surface morphology of the films.     

Short range order transformation and magnetostriction of Fes3Ga17 ribbons

The relationship between magnetostriction and structure of melt-spun Fes3Ga17 ribbons are investigated by XRD and M5ssbauer spectrum technique （MS）. As the heat-treatment temperature increases from 650℃ to 800℃, the magnetostriction coefficient of Fes3Ga17 ribbon first increases and then decreases. The largest magnetostriction coeiffcient （-578.4 ppm） is achieved in those specimens quenched at 750oc. According to the XRD and MSssbauer spectrum anal- ysis, a small quantity of DO3 phase is precipitated in Fe83Ga17 ribbons when quenched from 650℃ and the DO3 phase is gradually transformed into B2-1ike phase if quenched at higher temperature. However, both DO3 and B2-1ike phases disappear when the temperature increases up to 800℃. From this point of view, B2-1ike phase might be beneficial to the enhancement of magnetostrictive properties of melt-spun ribbons.     

Study of diode-pumped Yb:YAG disk lasers at low temperature

A Yb:YAG disk laser with V-shaped stable resonator and active-mirror configuration,end-pumped by a 940-nm InGaAs laser diode array,is demonstrated.Performances and optimization of the disk laser at low temperature over a range of 130-200 K are investigated theoretically and experimentally.Laser output energy of 1.46 J/pulse operating at 10-Hz repetition rate is obtained with the optimum output coupler transmission of 30%,and the corresponding optical-to-optical efficiency is 48.7%.     

退火温度对YBa2Fe3O8的结构与磁性质影响分析

YBa2Fe3O8(YBFO)是具有三方钙钛矿结构的反铁磁(AFM)体,研究它的结构和磁性质对于我们认识三方钙钛矿结构具有重要作用.目前,关于固相法制备YBFO中退火温度方面的研究并不多,而控制退火温度是这种工艺中的重要环节.为制备高含量的YBa2Fe3O8,本文分别在760℃、950℃和1100℃退火温度下,采用固相...     

基于OH自由基A2Σ + →X2Πr 电子带系发射光谱的温度测量技术

本文基于OH自由基所固有的分子结构特征,通过分子光谱理论系统地分析和计算了OH自由基A²Σ ⁺ →X²Π_r 电子带系发射光谱的谱线跃迁频率、能级分布以及爱因斯坦自发发射跃迁概率等重要参数.同时结合实际的光谱实验,分析了谱线的自然展宽、碰撞展宽、多普勒展宽以及仪器展宽等各种展宽因素对谱线线型的影响,从理论上计算了任意转动温度、振动温度以及谱线展宽条件下OH自由基A²Σ ^{关键词： 发射光谱 转动温度 振动温度 自发发射爱因斯坦跃迁概率}     

抑制损伤发展的CO_2激光修复技术及机理研究

熔石英表面激光损伤发展问题一直制约着激光器的运行通量。采用CO2激光在线熔融修复损伤点,修复后形成一个光滑的高斯坑,去除了损伤点中的裂纹,平滑了凹凸不平的表面,并且在紫外脉冲激光作用下,修复斑再次产生损伤的阈值高于熔石英元件的损伤生长阈值。因此CO2熔融修复技术能有效地抑制损伤发展。通过分析CO2激光作用下熔石英表面的温度分布,讨论修复坑的形成过程,确定激光参数对修复效果的影响,为寻找最佳修复参数提供理论基础。同时利用原子力显微镜(AFM)、轮廓仪细致分析损伤点和修复斑的微细结构,采用有限差分时域方法计算损伤点和修复斑周围的光强分布,探索消除裂纹和平滑表面对抑制损伤生长的作用。