Numerical simulation of end-pumped CW Nd^3＋：GdVO4 laser at 1063 nm

A theoretical model to simulate an end-pumped CW Nd^3＋：GdVO4 laser at 1063 nm is presented. Its essence is to use the propagation equations to demonstrate the spatial evolutions of the pump and the laser powers in the cavity, hence it is applicable to both low and high gain lasers. The simulation results obtained by this model are in good agreement with the experimental observations reported in the literature for a Ti：sapphlre-pumped Nd^3＋：GdVO4 laser. Moreover, some parameters, such as the reflectivity of output coupler, the spot size of laser beam and the crystal length, are discussed with a view to optimizing the laser performance.     

激光功率和能量计量技术的现状与展望

功率和能量是激光器的两个基本参数,激光功率和能量测量一直是激光参数计量中最基础的测量工作.总结了美国标准技术研究院(NIST)、英国国家物理实验室(NPL)以及中国国家计量院(NIM)在激光功率能量计量方面的技术现状,重点介绍了国防科工委光学计量一级站激光功率能量计量方面已具备的条件,详细说明了所采用的测量原理以及所达到的测量范围和测量不确定度等技术指标.提出了激光功率和能量计量的发展趋势和发展方向.     

CMOS vision sensor with integrated into low fully digital image process power 1/8-inch chip

A digital still camera image processing system on a chip, different from the video camera system, is pre- sented for mobile phone to reduce the power consumption and size. A new color interpolation algorithm is proposed to enhance the image quality. The system can also process fixed patten noise （FPN） reduction, color correction, gamma correction, RGB/YUV space transfer, etc. The chip is controlled by sensor regis- ters by inter-integrated circuit （I2C） interface. The voltage for both the front-end analog and the pad cir- cuits is 2.8 V, and the volatge for the image signal processing is 1.8 V. The chip running under the external 13.5-MHz clock has a video data rate of 30 frames/s and the measured power dissipation is about 75 roW.     

掺染料微结构光纤荧光传感器的理论分析

针对一般光纤荧光传感器收集荧光能力不足的缺陷,设计了一种在微结构聚合物光纤的空气孔内填充掺有机染料高折射率液体的荧光传感器.使用可调节边界条件傅里叶分解法计算了这种微结构光纤的模场分布,分析了光纤结构参量和液体折射率对荧光捕获分数的影响,结果表明,使用小纤芯半径和高于纤芯折射率的液体可以增强激发光的吸收效率,增大荧光捕...     

电学典型题错解剖析

1 物理概念理解不清 [例1](2008年山东潍坊)将标有"220 V,15 W"的甲灯和"220 V,60 W"的乙灯串联后接在220 V的电源上,组成闭合回路(设灯丝电阻不变)则下列判断正确的是     

A narrow-linewidth continuous wave Ho：YAL03 laser with Fabry-Perot etalons

A narrow linewidth continuous wave Ho：YAP laser with two Fabry-Perot etalons pumped by a Tm：YLF laser is reported. The maximum output power reaches 8.3 W when the incident pump power is 15.8 W, with 52.5% optical-to- optical conversion efficiency and 62.6% slope efficiency. A stable laser output at 2118.1 nm is achieved, with a linewidth less than 0.4 nm （full width at half maximum）. The beam quality factor is M2- 1.25, measured by the traveling knife-edge method.     

LD端面抽运Nd:YAG 1319nm/1338nm双波长激光器研究

从LD端面抽运固体激光器的激光阈值公式出发，建立了双波长激光同时振荡的阈值条件，理论计算了腔镜对于两个波长的透过率关系，实现了LD端面抽运Nd:YAG 1319nm/1338nm双波长激光连续和准连续输出.双波长激光连续输出功率可达6W，斜效率为30%；准连续输出功率在重复频率50kHz时可达4.75W，斜效率为24.73%，脉冲宽度为55.05ns；腔内插入布儒斯特片，在重复频率为50kHz时，双波长激光准连续线偏振输出功率可达2.22W，不稳定性小于0.52%，M²     

双折射吸收非线性介质薄膜中倍频的产生

从二次谐波电场满足的波动方程出发，考虑到介质对二次谐波的吸收以及把完全边界条件应用于基频波和二次谐波在介质的入射面和出射面之间的反射效应，推导出了单光轴非线性薄膜介质中的二次谐波输出功率的计算式.结果表明：当采用复折射率的概念时，可以把非线性无吸收介质的二次谐波输出功率计算式应用到非线性吸收介质二次谐波输出功率计算式中去.     

372-mJ long pulse pyrotechnically pumped laser

A pyrotechnically pumped Nd glass laser is demonstrated by the use of pyrotechnic flashlamps composed of several chemical materials arranged in a stable plane concave resonator cavity. The flashlamp was made of chemical mixture with oxidant, fuel, and binder. The emission spectrum of pyrotechnic flame covered most of the absorption bands of Nda＋ in phosphate glass. Under 4.56-g chemical mixture pumping, long pulse output power of about 5.5 W was achieved.     

上海光源150MeV电子直线加速器的设计与调试

上海光源150MeV直线加速器由热阴极电子枪,次谐波聚束器和聚束器,四根S波段等梯度行波加速管及必要的磁铁等组成.外围还有由从微波到直流的电源和功率源,性能监测和联锁控制的硬件和软件等.概述了150MeV直线加速器的设计,安装,调试和达到的结果.