Analysis on absolute measurement of optical coating absorption loss based on photothermal detuning technique

Based on the photothermal detuning technique, the three linear relations among reflectance （or trans- mittance）, temperature rise, and pump beam power are studied to achieve the absolute measurement of absorption loss. The relation between temperature and reflectance and the calculation accuracy of tem- perature rise on sample surface have great impacts on the measured result. The influences of parameters involved in the method and the relation between temperature and reflectance and the temperature model of sample surface are also studied. The results show that the absolute absorption loss of optical coatings can be achieved by the proposed method. The measurement accuracy depends on the temperature model and the relation between temperature and reflectance. The linear relation between reflectance and temper- ature rise has largest slope when probe beam wavelength is 632.8 nm and incident angle is 28°. The linear relation slope between temperature rise and pump beam power decreases with the growing of beam size and modulation frequency. The results provide theoretical and experimental supports for the perfection and further application of the photothermal detuning technique.     

Densification and lithium ion conductivity of garnet-type Li7-xLa3Zr2-xTaxO12 （x=0.25） solid electrolytes

The garnet-type Li7La3Zr2O12 ceramic is a promising solid electrolyte for all-solid-state secondary lithium batteries. However, it faces the problem of lithium volatilization during sintering, which may cause low density and deterioration of ionic conductivity. In this work, the effects of sintering temperature and addition on the density as well as the lithium ion conductivity of Li7-xLa3Zr2-xTaxO12 (LLZTO, x=0.25) ceramics prepared by solid state reaction have been studied. It is found that optimization of the sintering temperature leads to a minor increase in the ceramic density, yielding an optimum ionic conductivity of 2.9×10-4 S·cm-1 at 25℃. Introduction of Li 3 PO 4 addition in an appropriate concentration can obviously increase the density, leading to an optimum ionic conductivity of 7.2×10-4 S·cm-1 at 25℃. This value is superior to the conductivity data in most recent reports on the LLZTO ceramics.     

Effects of clouds, sea surface temperature, and its diurnal variation on precipitation efficiency

The effects of clouds, sea surface temperature, and its diurnal variation on precipitation efficiency are investigated using grid-scale data from nine equilibrium sensitivity cloud-resolving model experiments driven without large-scale vertical velocity. The precipitation efficiencies are respectively defined in surface rainfall, cloud, and rain microphysical budgets. We mathematically and physically demonstrate the relationship between these precipitation efficiencies. The 2℃ increases in spatiotemporal invariant sea surface temperature (SST) from 27℃ to 29℃ and from 29℃ to 31℃, and the inclusion of diurnal SST difference 1℃ and the 1℃ increase in diurnal SST difference generate opposite changes in the precipitation efficiency by changing ice cloud-radiation interactions. The radiative and microphysical processes of ice clouds have opposite effects on the precipitation efficiency because of the rainfall increase associated with the reduction in the saturation mixing ratio caused by the exclusion of radiative effects and the decrease in rainfall related to the reduction in net condensation caused by the exclusion of deposition processes. The radiative effects of water clouds on the precipitation efficiency are statistically insensitive to the radiative effects of ice clouds.     

中等pd值介质阻挡放电中等离子体温度研究

近大气压条件下,在介质阻挡放电系统中得到了氩气和空气混合气体在300～800 nm范围内的发射光谱,研究了中等pd值(约6.4×103 Pa·cm) 氩气和空气混合气体中电子激发温度与分子振动温度。实验选用两条ArⅠ谱线763.51 nm(2P₆→1S₅)与772.42 nm(2P₂→1S₃),用强度对比法测量电子激发温度,利用氮分子第二正带系(C 3Π_u→B 3Π_g)计算氮分子振动温度。实验结果表明：电子激发温度和分子振动温度均随电压的增加而增加,并且电子激发温度随电压的变化速率大于分子振动温度的变化速率。     

QGP热力学势中的屏蔽和阻尼效应

采用含有Debye屏蔽和阻尼效应的胶子谱函数, 在实时温度QCD理论的框架下计算了夸克胶子等离子体中有效二圈热力学势, 得到了依赖于胶子屏蔽和阻尼作为物理参数的解析结果. 数值计算表明, 我们的结果与格点QCD理论计算的最新结果在温度T≥2T_c时相符.     

小阶跃反应性输入时点堆中子动力学方程的解析解

对小阶跃反应性输入（0<ρ,０<β）且有温度反馈时点堆中子动力学方程进行了研究. 导出任意初始功率条件下核反应堆功率、反应性与时间的解析表达式. 分析和讨论了初始功率与输入小阶跃反应性的大小对功率、反应性变化规律的影响，得到了一些新的结果. 关键词： 中子动力学 反应性 点堆 温度反馈     

激光能量对激光诱导Cu等离子体特征辐射强度、电子温度的影响

利用Nd:YAG激光(波长1 064 nm,脉宽10 ns)烧蚀金属Cu靶获得等离子体 .改变激光脉冲能量,观测到Cu的原子谱线和离子谱线随激光脉冲能量有不同的变化关系, 但都在330 mJ/pulse时,谱线强度达到最大,随后在330 mJ～370 mJ/pulse间出现一小平台 ,能量继续增加,各谱线强度减小.同时,使用烧蚀Cu靶产生的五条原子谱线(465.11 nm,5 10.55 nm,515.32 nm,521.82 nm,529.25 nm)的相对强度,在局部热力学平衡近似下,利用B oltzmann图的最小二乘法拟合,测定了不同激光能量下Cu等离子体的电子温度.随激光能量的增加,电子温度近似单调地从1.02×104 K上升到1.46×104 K后,反而有所下降.     

光纤复合型油气井下压力温度测量系统

针对目前广泛使用的电子式油气井下压力温度测量系统可靠性低、高温环境漂移大的不足,设计了一种基于非本征型F-P干涉仪(EFPI)和光纤布喇格光栅(FBG)的复合型油气井下压力、温度测量系统,详细说明了其工作原理、传感器组成和信号解调方法,初步试验结果表明,该测量系统不仅克服了电子测量方式的不足,而且具有复用性好、测量精度高等优点.     

具有HfN/HfO2栅结构的p型MOSFET中的负偏置-温度不稳定性研究

研究了HfN/HfO₂高K栅结构p型金属-氧化物-半导体(MOS)晶体管(MOSFET)中，负 偏置-温度应力引起的阈值电压不稳定性(NBTI)特征.HfN/HfO₂高K栅结构的等效 氧化层厚度(EOT)为1.3nm，内含原生缺陷密度较低.研究表明，由于所制备的HfN/HfO₂ 高K栅结构具有低的原生缺陷密度，因此在p-MOSFET器件中观察到的NBTI属HfN/HfO2高K栅结构的本征特征，而非工艺缺陷引起的；进一步研究表明，该HfN/HfO₂高K栅结构中观察到的NBTI与传统的SiO₂基栅介质p-MOSFET器件中观察 到的NBTI具有类似的特征，可以被所谓的反应-扩散(R-D)模型表征： HfN/HfO₂ 栅结构p-MOSFET器件的NBTI效应的起源可以归为衬底注入空穴诱导的界面反应机理，即在负 偏置和温度应力作用下，从Si衬底注入的空穴诱导了Si衬底界面Si-H键断裂这一化学反应的 发生，并由此产生了Si^＋陷阱在Si衬底界面的积累和H原子在介质层内部的扩散 ，这种Si^＋陷阱的界面积累和H原子的扩散导致了器件NBTI效应的发生. 关键词： 高K栅介质 负偏置-温度不稳定性(NBTI) 反应-扩散(R-D)模型     

离子束增强沉积VO2多晶薄膜的温度系数

用改进的离子束增强沉积方法和恰当的退火从V2O5粉末直接制备了VO2多晶薄膜.实验测试表明，薄膜的取向单一、相变特性显著、结构致密、界面结合牢固、工艺性能良好，薄膜的电阻温度系数（TCR）最高可达4.23%/K.从成膜机理出发，较详细地讨论了离子束增强沉积 VO2多晶薄膜的TCR高于VOx薄膜的TCR的原因.分析认为，单一取向的VO2结构使薄膜晶粒具有较高的电导激活能，致密的薄膜结构减少了氧空位和晶界宽度，使离子束增强沉积 VO2多晶薄膜结构比其他方法制备的VOx薄膜更接近于单晶VO2是其具有高TCR的原 关键词： VO2多晶薄膜 离子束增强沉积 热电阻温度系数