A New High Efficiency Multiwave Cerenkov Generator Operating at Low Magnetic Field

With a resonant cavity inserted between the second slow-wave-structure section and the tapered wavegulde, a new structure of the multlwave Cerenkov generator (MWCG) operating at low guiding magnetic field is proposed to produce high efficiency and high power microwave. Some features and potential advantages of the proposed device are analysed. The 2.5-dimensional partlcle-in-cell simulation is employed to verify the initial expectation.The results show that, with the use of an electron beam of 640keV and 8.4kA guided by the magnetic lield of 0.6 T, a stable and monochromatic X-band microwave output of 4 GW in peak power is achieved, and the average efficiency is over 30%.     

碱蓝6B共振光散射法检测DNA

研究了碱蓝 6B与脱氧核糖核酸在酸性条件下共振光散射特征 ,考察了影响因素和最佳反应条件 ,建立了一种测定纳克级DNA的方法。在四硼酸钠 盐酸 (pH =2 90 )缓冲溶液中 ,线性范围为 10～ 10 0 4 μg·L- 1 ,相关系数为 0 9913,检出限为 4 2 μg·L- 1 ,用于合成样品的测定结果令人满意。     

光突发交换的交换控制策略和光缓存配置

光突发交换是面向下一代互联网的光交换模式.讨论了异步光突发交换系统的交换控制策略以及相应光缓存的优化配置策略.除了传统预约模式的交换策略,还研究了非预约和改进型预约模式,它们的性能评估由计算机仿真给出.结果表明:在条件相当情况下,改进型预约模式具有最低的丢包率.同时光缓存的配置对上述几类交换控制策略的性能都有很大影响,仿真结果指出:光缓存的粒度对系统性能具有重要影响,所讨论的几类交换模式都存在最佳时延粒度,研究结果对光交换矩阵的设计有指导意义.     

开口波导有效接收面积的测量

高功率微波功率测量的基本思想是将高功率降为低功率来进行测试，空间辐射场测量方法是基于该思想的功率测量方法之一。空间辐射场测量方法是通过测量接收天线接收的辐射场功率来测量微波源的功率，该方法需要已知接收天线在特定频率下的有效接收面积，以便计算出辐射源的功率。对于标准接收天线的有效面积，可以采用近似值来代替接收天线的有效面积，但是测量结果误差较大，因此，为了准确测量辐射源的功率，     

温度对PSⅡCP4 7/D1/D2/Cytb559复合物荧光光谱特性的影响

采用激励光源为514.5 nm的分幅扫描单光子计数荧光光谱装置对经20℃、42℃和48℃不同温度处理后的反应中心复合物CP47/D₁/D₂/Cyt b559的荧光光谱特性进行了研究.经解析,获得不同温度处理后,CP47/D₁/D₂/Cyt b559复合物最大峰值未发生变化,均在682 nm,说明Chla670的能量都由Chla682接收,但损耗愈来愈小,在48℃时,损耗程度最小,而其荧光百分比未发生多大变化.振动副带～700 nm和～740 nm的中心波长都发生蓝移,在不同温度下分别为:20℃ 703 nm,749 nm;42℃ 697 nm,744 nm;48℃ 694 nm,740 nm.因此可以推测温度的升高,影响了CP47/D₁/D₂/Cyt b559色素蛋白的二级结构以及色素分子的空间位置,使最大峰值处的荧光强度逐渐降低,振动副带逐渐蓝移.42℃的温度已造成影响,48℃影响较大.     

Longitudinal leaky surface acoustic wave on Y-rotated cut quartz substrates

The properties of Quasi-longitudinal leaky surface acoustic wave(QLLSAW) on Y-rotated cut quartz substrates were presented. The phase velocity of QLLSAW on the quartz substrate along some orientations can be up from 6200 m/s to 7100 m/s, circa 100% above that of regular SAW. Both theoretical and experimental results show that QLLSAW propagating along some promising orientations for SAW devices are of small power flow angle and low tem-perature coefficient, for example, along the Euler angle (0°155.25°? 42°?, the measurements of phase velocity and temperature coefficient of delay of QLLSAW are 6201 m/s and 12.9 ppm/℃. The experimental results show that QLLSAW had little absorption by liquid loading on the substrate surface, which proved that the direction of particle motion is the same as wave vector and parallel to the surface of the substrates, i.e., the wave is of the properties of longitudinal wave.     

Incoherently Coupled Grey Photovoltaic Spatial Soliton Families

A theory is developed for incoherently coupled grey photovoltaic soliton families in unbiased photovoltaic crystals. Both the properties and the forming conditions of these soliton families are discussed in detail. The theory can also be used to investigate the dark photovoltaic soliton families. Some relevant examples are presented, in which the photovoltaic-photorefractive crystal is of lithium niobate type.     

Recombination Efficiency in Double-Layer Organic Light-Emitting Devices

We analyse the influence of properties of organic/organic interface (OOI) on the characteristics of recombination efficiency of organic double-layer light-emitting diodes. Based on the disordered hopping theory model, spatial and energetic disorder of hopping states are also discussed for the case of space charge limited currents in hole transmitting layers but injection-limited currents in electron transporting layers. The results show that the recombination efficiency increases firstly and then decreases for different OOI parameters, and there is a maximum value changed with different spatial disorder parameters and energetic disorder scale. Different spatial disorder parameters make carrier mobilities change greatly, and the energetic disorder scale causes various localized state densities. Our calculated results are qualitatively in agreement with the experimental data.     

掺杂两种荧光染料的有机红光电致发光器件

制作了掺杂rubrene和4-(dicyanomethylene)-2-t-butyl-6-(1,1,7,7-tetramethyljulolidyl-9,enyl)-4H-pyran(DCJTB)两种荧光染料的红光有机电致发光器件。N,N’-diphenyl-N,N’-bis(1-naphthyl)-(1,1’-biphenyl)-4,4’-diamine(NPB)和掺杂的Tri-(8-hydroxyquinoline)aluminum(Alq3)分别作为空穴和电子传输层。我们发现掺rubrene和DCJTB的器件性能与只掺DCJTB的器件性能相比有所提高。器件性能的改善是因为掺入的rubrene能够促进从Alq3到DCJTB的能量转移。根据荧光衰减曲线,计算出从Alq3到DCJTB、从Alq3到rubrene以及从rubrene到DCJTB的能量转移速率分别为1.04×109,3.89×109,2.79×109s-1。可以看出能量通过rubrene从Alq3到DCJTB的转移速率是能量直接从Alq3到DCJTB的2.7倍。     

30J能量驱动类镍银X光激光的理论研究

 在1.2×10¹³W·cm^－2低功率密度下，对基频激光预主短脉冲驱动类镍银X光激光机理进行了数值模拟和理论分析。证实了在靶长23 mm范围内X光激光都能获得有效放大，取得了和实验相符合的结果。考虑了单柱面镜线聚焦沿靶长度方向功率密度的非均匀性对X光激光放大的影响，采用弯曲靶能有效克服折射以及单柱面镜线聚焦功率密度非均匀带来的不利影响。理论模拟给出的类镍银X光激光的出光下限泵浦功率密度也与实验符合得很好。理论模拟还表明，采用1%左右的预脉冲强度并对预主脉冲时间间隔进行优化，X光激光的输出能量和能量转换效率将获得大幅度提高。