在几何和参数上表示同一条曲线的两条有理NURBS曲线的权与控制顶点之间的关系

The paper discusses the relationship between weights and control vertices of two rational NURBS curves of degree two or three with all weights larger than zero when they represent the same curve parametrically and geometrically, and gives sufficient and necessary conditions for coincidence of two rational NURBS curves in non-degeneracy case.     

A Continuation Method of Parameter Inversion for Non-Equilibrium Convection-Dispersion Equation

Based on the homotopy mapping, a globally convergent method of parameter inversion for non-equilibrium convection-dispersion equations （CDEs） is developed. Moreover, in order to further improve the computational efficiency of the algorithm, a properly smooth function, which is derived from the sigmoid function, is employed to update the homotopy parameter during iteration. Numerical results show the feature of global convergence and high performance of this method. In addition, even the measurement quantities are heavily contaminated by noises, and a good solution can be found.     

High-Average-Power Nanosecond Quasi-Phase-Matched Single-Pass Optical Parametric Generator in Periodically Poled Lithium Niobate

A pulsed nanosecond optical parametric generator (OPG) in periodically poled lithium niobate (PPLN) crysal is presented. The pump laser is an acousto-optically Q-switched Nd:YVO4 laser with the maximum average power of 6.58 W. When the repetition rate is 50kHz and the pulse width of the pump source is 80ns, the maximum average total output power of the single-pass PPLN OPG is about 1.9 W, which includes 1.322 W of 1.536μm signal radiation. The length of the PPLN crystal is only 38.7mm (at room temperature) with a grating period of 28.93μm (at room temperature). The 1.502-1.536μm signal radiation and 3.652-3.465μm idler radiation are obtained by adjusting the PPLN crystal temperature from 155℃ to 250℃.     

弥散型金属薄膜逾渗系统的临界特性

报道了一种弥散型金属薄膜逾渗系统的制备方法和研究结果。从实验发现这种新型的逾渗系统具有异常的R-I关系、三次谐波系数与独特的电流临界规律。分析表明:这些特性与此类薄膜逾渗结构随电流增大而逐渐变化的过程有关,是由沿膜横向逐渐变化的局域隧道电流(LDTC)与跳跃电导(LDHC)效应引起的。     

同步电机定子绕组不对称状态的分析方法——Ⅱ.参数的计算方法

参数计算是分析电机绕组不对称状态的关键问题。用多回路法分析同步电机定子绕组不对称状态时所用的参数,与绕组正常时的参数不同,它包括定子绕组每个支路、转子各阻尼回路和励磁绕组的自感系数和互感系数。定子支路参数可以由单个线圈参数组成。本文在考虑铁心饱和的情况下,研究了参数计算的两种方法,即气隙磁导分析法和磁场数值分析法,并将它们应用于实际电机的计算,验证和比较了两种计算方法。     

标准体系的比例型寿命使用期模型与分析

本文在基于标准被废除按比例进行时的标准体系使用期的两个新模型。首先给出了模型假设条件,然后定义了标准使用期。根据假设给出了两个模型条件下的标准使用期公式,最后通过数值示例说明了标准使用期的公式使用。     

X分形晶格上Gauss模型的临界性质

采用实空间重整化群变换的方法,研究了2维和d(d>2)维X分形晶格上Gauss模型的临界性质.结果表明:这种晶格与其他分形晶格一样,在临界点处,其最近邻相互作用参量也可以表示为K=bqiqi(qi是格点i的配位数,bqi是格点i上自旋取值的Gauss分布常数)的形式;其关联长度临界指数v与空间维数d(或分形维数df)有关.这与Ising模型的结果存在很大的差异. 关键词： X分形晶格 重整化群 Gauss模型 临界性质     

一类半参数回归模型的估计理论

考虑半参数回归模型Y=X’β+g(T)+e,其中(X,T)为取值于R^p×[0,1]上的随机向量,β为p×1未知参数向量,g为定义于[0,1]上的未知函数,e为随机误差,Ee=0,Ee²=σ²>0,且(X,T)与e独立。本文综合最近邻和最小二乘的方法定义了β,g和σ²的估计量,g_n^*和。在适当条件下证明了和的渐近正态性,并得到了g_n^*的最优收敛速度。