Kinetics and mechanism of free-surface vaporization of zinc, cadmium and mercury oxides analyzed by the third-law method

On the basis of critical comparison of experimental and theoretical values of the E parameter and investigation of the retardation effect of oxygen on the evaporation rate of ZnO, CdO and HgO, it was concluded that the dissociative evaporation of ZnO and HgO proceeds with releasing of atomic oxygen (O) as a primary product of decomposition. By contrast, the mechanism of dissociative evaporation of CdO corresponds to the equilibrium reaction with releasing of molecular oxygen (O₂) as a primary product of decomposition. As was shown, this difference in mechanisms is not related with interatomic OO distances in these oxides. From the analysis of crystal structure for 12 different oxides, which evaporate with releasing of atomic oxygen, and for 13 compounds, which evaporate with releasing of molecular oxygen, it was revealed that the first mechanism is observed for all oxides with the cubic crystal structure. It was proposed that a decisive role in this difference belongs to a local symmetry in the position of O atoms.     

Novel antibiotics: second generation macrocyclic peptides designed to trap Holliday junctions

Described are the syntheses of 15 macrocyclic peptides designed to trap Holliday junctions (HJs) in bacteria during site-specific and homologous recombination. This leads to inhibiting bacterial growth. These second generation macrocycles were based on the C-2 symmetrical HJ. They were synthesized using a strategy that permits elucidation of the amino acid role in binding HJs. The syntheses of these macrocycles are an important step in the development of a new class of antibiotics.     

Kinetics and equilibrium of small metallic clusters: Ab initio confinement molecular dynamics study of 4

The ab initio molecular dynamics (AIMD) [1] is combined with the heuristic, successive confinement method of surveying a potential energy surface (PES) [2], thereby offering a framework for the simulation study of kinetics and equilibrium properties of metallic clusters. This approach is applied to the study of Au₄, a cluster possessing a simple but specific PES, which consists of very shallow and deep basins and due to this presents a challenge to the conventional AIMD methods. Among other things, the probabilities of the transitions between isomers have been found, and on this basis, both the time-dependent and equilibrium populations of the isomers have been calculated for the conditions typical of the NeNePo experiments [3] in the femtosecond pump-probe spectroscopy.     

Coercive boundary value problems for regular degenerate differential-operator equations

This study focuses on nonlocal boundary value problems (BVP) for degenerate elliptic differential-operator equations (DOE), that are defined in Banach-valued function spaces, where boundary conditions contain a degenerate function and a principal part of the equation possess varying coefficients. Several conditions obtained, that guarantee the maximal L_p regularity and Fredholmness. These results are also applied to nonlocal BVP for regular degenerate partial differential equations on cylindrical domain to obtain the algebraic conditions that ensure the same properties.     

A DC excited waveguide multibeam CO2 laser using high frequency pre-ionization technique

High power industrial multibeam CO₂ lasers consist of a large number of closely packed parallel glass discharge tubes sharing a common plane parallel resonator. Every discharge tube forms an independent resonator. When discharge tubes of smaller diameter are used and the Fresnel numberN ≪ 1 for all resonators, they operate in waveguide mode. Waveguide modes have excellent discrimination of higher order modes. A DC excited waveguide multibeam CO₂ laser is reported having six glass discharge tubes. Simultaneous excitation of DC discharge in all sections is achieved by producing pre-ionization using an auxiliary high frequency pulsed discharge along with its other advantages. Maximum 170 W output power is obtained with all beams operating in EH₁₁ waveguide mode. The specific power of 28 W/m is much higher as compared to similar AC excited waveguide multibeam CO₂ lasers. Theoretical analysis shows that all resonators of this laser will support only EH₁₁ mode. This laser is successfully used for woodcutting     

Cu-MgF2复合纳米金属陶瓷薄膜的电导特性研究

用射频磁控共溅射法制备了Cu体积分数分别为 10 % ,15 % ,2 0 %和 3 0 %的Cu MgF2 复合金属陶瓷薄膜 .用x射线衍射、x射线光电子能谱和变温四引线技术对薄膜的微结构、组分及电导特性进行了测试分析 .微结构分析表明 :制备的Cu MgF2 复合薄膜由fcc Cu晶态纳米微粒镶嵌于主要为非晶态的MgF2 陶瓷基体中构成 ,Cu晶粒的平均晶粒尺寸随组分增加从 11 9nm增至 17 8nm .5 0— 3 0 0K温度范围内的电导测试结果表明 :当Cu体积分数qM 由 15 %增加到 2 0 %时 ,Cu MgF2 复合薄膜的电阻减小了 8个量级 ,得出制备的复合薄膜渗透阈qCM 应处于 15 %和 2 0 %之间 .qM 在 10 %和 15 %之间的薄膜呈介质导电状态 ,而在 2 0 %和 3 0 %之间的薄膜则呈金属导电状态 .从理论上讨论了复合薄膜中杂质电导和本征电导的激活能及其对电导的贡献 ,并讨论了Cu MgF2 复合纳米金属陶瓷薄膜的渗透阈 ,得到了和实验一致的结果     

The spectrum of cyclic BSA(ν, 3, λ; α) with α = 2, 3

Balanced sampling plans excluding contiguous units (or BSEC) were first introduced by Hedayat, Rao, and Stufken in 1988. In this paper, we generalize the concept of a cyclic BSEC to a cyclic balanced sampling plan to avoid the selection of adjacent units (or CBSA for short) and use Langford and extended Langford sequences to construct a cyclic BSA(ν, 3, λ; α) with α = 2, 3. We finally establish the necessary and sufficient conditions for the existence of a cyclic BSA(ν, 3, λ; α) where α = 2, 3. © 2005 Wiley Periodicals, Inc. J Combin Designs.     

Correlation between Al2O3 particles and interface of Al-Al2O3 coatings by cold spray

Al-Al₂O₃ composite coatings with different Al₂O₃ particle shapes were prepared on Si and Al substrate by cold spray. The powder compositions of metal (Al) and ceramic (Al₂O₃) having different sizes and agglomerations were varied into ratios of 10:1 wt% and 1:1 wt%. Al₂O₃ particles were successfully incorporated into the soft metal matrix of Al. It was found that crater formation between the coatings and substrate, which is typical characteristic signature of cold spray could be affected by initial starting Al₂O₃ particles. In addition, when the large hard particles of fused Al₂O₃ were employed, the deep and big craters were generated at the interface between coatings and hard substrates. In the case of pure soft metal coating such as Al on hard substrate, it is very hard to get proper adhesion due to lack of crater formation. Therefore, the composite coating would have certain advantages.     

A comparison between optically active CdZnSe/ZnSe and CdZnSe/ZnBeSe self-assembled quantum dots: effect of beryllium

The composition and size of optically active Cd_xZn_1−xSe/ZnSe quantum dots are estimated with a previously developed method. The results are then compared with those obtained for Cd_xZn_1−xSe/Zn_0.97Be_0.03Se QDs. We show that introducing Be into the barrier material enhances both Cd composition and quantum size effect of optically active quantum dots.     

Synthesis of MgAl2O4 Spinel Nanometer Powder via Biology Polysaccharide Assisted Sol-Gel Process

A novel and cost-effective sol-gel process for preparation of MgAl₂O₄ spinel nanometer powders has been developed in this study. A solution of magnesium and aluminum nitrates in stoichiometric proportion was successfully embraced in the biology polysaccharide gel network, formed by the synergistic interaction between xanthan gum (XG) and locust bean gum (LBG) utilizing their broad-spectrum stability of salt tolerance and character of transformation from sol to gel on the condition of proper temperature and relative proportion of polymeric components. Dry gel could be obtained by vacuum dehydration of aqueous gel at low temperatures. Monolithic MgAl₂O₄ spinel nanometer powders were produced by calcining the dry gel above 800°C, with average crystallite size of 20 nanometers.