乌桕类可可脂结晶过程中表现体积变化

为了解乌桕类可可脂(CTCBE)缓冷结晶横向胀罐爆裂原因，研究CTCBE结晶过程中的膨胀特性，采用流体静力法测试了不同等温结晶条件下CTCBE结晶形成的表观密度和表观体积及其横纵向膨胀状况。结果表明，CTCBE缓冷结晶后形成外部和中部两个晶区。在5-25℃的各等温结晶范围内，当结晶温度增加时，外部结晶区域减小、表观密度变化不大；中部结晶区域增大、表观密度明显减小，CTCBE的表观体积、横向、纵向膨胀率均增大，膨胀横向大于纵向。进一步表明CTCBE在自然缓冷固化的表观体积根本上由其结晶温度决定。为有效防止横向胀罐，自然缓冷固化温度应低于10℃。     

Stress concentration and effective stiffness of aligned fiber reinforced composite with anisotropic constituents

The paper addresses the problem of calculation of the local stress field and effective elastic properties of a unidirectional fiber reinforced composite with anisotropic constituents. For this aim, the representative unit cell approach has been utilized. The micro geometry of the composite is modeled by a periodic structure with a unit cell containing multiple circular fibers. The number of fibers is sufficient to account for the micro structure statistics of composite. A new method based on the multipole expansion technique is developed to obtain the exact series solution for the micro stress field. The method combines the principle of superposition, technique of complex potentials and some new results in the theory of special functions. A proper choice of potentials and new results for their series expansions allow one to reduce the boundary-value problem for the multiple-connected domain to an ordinary, well-posed set of linear algebraic equations. This reduction provides high numerical efficiency of the developed method. Exact expressions for the components of the effective stiffness tensor have been obtained by analytical averaging of the strain and stress fields.     

Assessment of thermal expansion coefficient of methylsilsesquioxane thin film

For the methylsilsesquioxane film whose optical birefringence is almost zero, it was recently reported that its vertical thermal expansion coefficient (CTE) was approximately one order of magnitude larger than the lateral CTE. Though the birefringence is not an absolute predictor of anisotropic behavior, the discrepancy in both the CTEs was so remarkable that it was essential to investigate whether the anisotropy was intrinsic property or not. If the effect of Poisson's ratio is considered in the calculation of the vertical CTE and when elastic modulus measured by surface acoustic wave spectroscopy is used in the assessment of the lateral CTE, both the CTEs are coincident with each other. Therefore, it can be concluded that the discrepancy in the CTEs can be attributed to a higher in‐plane polymer chain orientation but it can also arise from the misleadingly assumed modulus and Poisson's ratio. © 2006 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 44: 3109–3120, 2006     

狭义相对论效应──运动时钟变慢的计算机模拟演示实验

利用精炼的C语言进行程序设计，定量模拟狭义相结论的运动时钟变慢，并对处于两种不同时空观的时钟运行进行对比，使得时间膨胀效应变得直观。     

Palladium-catalyzed ring expansion reaction of 1-alkynylcyclobutanols with aryl iodides: an efficient route to 2-disubstituted methylenecyclopentanones

The reaction of 1-alkynylcyclobutanols with aryl iodides in the presence of Pd(OAc)₂ and Et₃N in acetonitrile at 80°C for 24 h gives 2-disubstituted methylenecyclopentan-1-ones in modest to good yields. The tandem insertion-ring expansion process proceeds via the formation of an alkynyl π-complex, followed by migration of a carbon-carbon bond of the tert-alkanol to form the cyclopentanones stereoselectively.     

用电子散斑干涉法测量材料热膨胀系数

 利用双光束电子散斑干涉法（ESPI）对试件受热变形进行了实时观测，针对一次实验过程中得到的图片较多（300～500幅）的特点，在图像处理时摒弃了以往的手动识别等位移线的办法，用MATLAB语言编写了批处理程序，能够在采集的大量散斑图片中自动快速准确地标定等位移线，得到相应的位移和应变，并结合实时测量的温度值，获得了45钢和LY12铝合金在不同温升率下的热膨胀系数及其随温度的变化。实验结果表明，在涉及的温升率范围内，温升率的改变对材料热膨胀系数的影响不明显，材料的热膨胀系数随温度的升高略有上升。     

Exploration of the Crystal Structure and Thermal and Spectroscopic Properties of Monoclinic Praseodymium Sulfate Pr2(SO4)3

Praseodymium sulfate was obtained by the precipitation method and the crystal structure was determined by Rietveld analysis. Pr₂(SO₄)₃ is crystallized in the monoclinic structure, space group C2/c, with cell parameters a = 21.6052 (4), b = 6.7237 (1) and c = 6.9777 (1) Å, β = 107.9148 (7)°, Z = 4, V = 964.48 (3) ų (T = 150 °C). The thermal expansion of Pr₂(SO₄)₃ is strongly anisotropic. As was obtained by XRD measurements, all cell parameters are increased on heating. However, due to a strong increase of the monoclinic angle β, there is a direction of negative thermal expansion. In the argon atmosphere, Pr₂(SO₄)₃ is stable in the temperature range of T = 30–870 °C. The kinetics of the thermal decomposition process of praseodymium sulfate octahydrate Pr₂(SO₄)₃·8H₂O was studied as well. The vibrational properties of Pr₂(SO₄)₃ were examined by Raman and Fourier-transform infrared absorption spectroscopy methods. The band gap structure of Pr₂(SO₄)₃ was evaluated by ab initio calculations, and it was found that the valence band top is dominated by the p electrons of oxygen ions, while the conduction band bottom is formed by the d electrons of Pr³⁺ ions. The exact position of ZPL is determined via PL and PLE spectra at 77 K to be at 481 nm, and that enabled a correct assignment of luminescent bands. The maximum luminescent band in Pr₂(SO₄)₃ belongs to the ³P₀ → ³F₂ transition at 640 nm.     

Stationary states of crystal growth in three dimensions

A new Markov process describing crystal growth in three dimensions is introduced. States of the process are configurations of the crystal surface, which has a terrace-edge-kink structure. The states are continuous along edges but discrete across edges, in accordance with the very different rates for the two types of captures of particles. Stationary distributions, describing steady crystal growth, are found in general. To our knowledge, these are the first examples of stationary distributions for layered crystal growth in three dimensions. The steady growth rate and other quantities are obtained explicitly for two interacting edges. For many interacting edges, growth behavior is determined (a) in various asymptotic regimes including thermodynamic limits, (b) via simulations, and (c) using series (cluster) expansions in the slope of the surface, the first three coefficients being computed. The theoretical growth rates show a marked dependence on surface dimensions. This may contribute to the size dependence and dispersion in the observed growth rate of small crystals.     

通过有光阑近轴ABCD光学系统激光束的近似解析传输公式

用傅立叶级数展开法研究光束通过有光阑限制的近轴ABCD光学系统的传输特性,导出了光阑透射率函数不同时的传输公式。硬边光阑的情况可作为其它光阑的特例得到,其它光阑也可视作硬边光阑来处理。数值计算表明了该方法快速的优点,并得到与用Collins公式直接积分一致结果。