级联二阶非线性铌酸锂全光开关的研制

以基于准位相匹配和频与差频级联二阶非线性[X^(2)：X^(2)]基础上的全光开关的理论分析作指导,进行了周期极化铌酸锂晶体(PPLN)和退火质子交换光波导(APE)的实验制备,利用所研制的PPLN-APE器件,以自行研制的工作波长为1．54μm的被动调Q掺钴铝酸镁激光器作为控制光源,以工作波长为1．5μm的连续二极管激光器为信号光源进行了级联二阶非线性全光开关实验。当控制光峰值功率为3kw,信号光功率为1mW时,实现13％的开关效率,分析了进一步提高全光开关性能的途径。     

MOS器件辐照过程和辐照后效应模拟

模拟MOS器件脉冲电离辐射响应和长时间恢复效应.假设隧道电子从硅进入氧化层和界面态的建立是辐射效应的恢复机理.在整个退火恢复期,采用卷积模型并考虑了栅偏置压的效应.模拟结果表明:退火过程所加栅偏压的大小以及隧道电子效应与建立的界面态所占比例的不同影响器件的恢复率.     

CONVERGENCE OF CASCADE ALGORITHMS AND SMOOTHNESS OF REFINABLE DISTRIBUTIONS

In this paper, the author at first develops a method to study convergence of the cascade algorithm in a Banach space without stable assumption on the initial (see Theorem 2.1), and then applies the previous result on the convergence to characterizing compactly supported refinable distributions in fractional Sobolev spaces and Holder continuous spaces (see Theorems 3.1, 3.3, and 3.4). Finally the author applies the above characterization to choosing appropriate initial to guarantee the convergence of the cascade algorithm (see Theorem 4.2).     

Annealing effect on magnetic anisotropy in ultrathin（Ga,Mn）As

We investigated the effect of low temperature annealing on magnetic anisotropy in 7-nm ultrathin Ga0.94Mn0.06As devices by measuring the angle-dependent planar Hall resistance(PHR).Obvious hysteresis loops were observed during the magnetization reversal through the clockwise and counterclockwise rotations under low magnetic fields(below 1000 Gs,1 Gs = 10-4 T),which can be explained by competition between Zeeman energy and magnetic anisotropic energy.It is found that the uniaxial anisotropy is dominant in the whole measured ferromagnetic range for both the as-grown ultrathin Ga0.94Mn0.06As and the annealed one.The cubic anisotropy changes more than the uniaxial anisotropy in the measured temperature ranges after annealing.This gives a useful way to tune the magnetic anisotropy of ultrathin(Ga,Mn)As devices.     

Ripening of single-layer InGaAs islands on GaAs（001）

The present paper discusses our investigation of InGaAs surface morphology annealed for different lengths of time.After annealing for 15 min,the ripening of InGaAs islands is completed.The real space scanning tunneling microscopy(STM) images show the evolution of InGaAs surface morphology.A half-terrace diffusion theoretical model based on thermodynamic theory is proposed to estimate the annealing time for obtaining flat morphology.The annealing time calculated by the proposed theory is in agreement with the experimental results.     

电子束蒸发在不同Ar气氛下外退火制备MgB2超导薄膜

制备高质量的MgB2薄膜是实现MgB2超导电子器件应用的前提和基础.我们用电子束蒸发B膜和Mg/B多层膜为前驱然后后退火的方法,分别在高温区(~900℃)和中温区(~750℃)成功获得了MgB2超导薄膜.改变退火的Ar气压条件,采用B膜前驱退火的样品Tc可达到38K以上,转变宽度0.3K.Mg/B多层膜的结果尽管Tc稍低(Tc~35K),但薄膜表面更加均匀,且避免了高温下Mg蒸汽污染的问题.对于两种前驱退火中观察到的完全不同的退火气压影响,我们认为是与其各自的超导成相过程相联系的,在此基础上我们对退火气压效应给出了自己的分析和解释,为今后进一步细致研究退火过程中的薄膜生长机制提供了参考.     

Microstructure and Texture Changes of Tungsten-Rhenium coated on Carbon Fiber Composite during Annealing

Since tungsten was chose as the divertor tiles of 1TER, the investigation of tungsten and its coating as plasma facing material (PFM) have been paid more attentions by fusion scientists all over the world. Recent years, tungsten coatings have been successfully     

金属有机物化学气相沉积法生长Ga2（1-x）In2xO3薄膜的结构及光电性能研究

采用金属有机物化学气相沉积（MOCVD）法在蓝宝石（0001）衬底上制备出了Ga_2（1-x）In_2xO₃（x=01—09）薄膜,研究了薄膜的结构、电学和光学特性以及退火处理对薄膜性质的影响.测量结果表明：当In组分x=02时,样品为单斜β-Ga₂O₃结构;x=05的样品,薄膜呈现非晶结构,退火处理后薄膜结构得到明显的改善 关键词： 金属有机物化学气相沉积 2（1-x）In_2xO₃薄膜')" href="#">Ga_2（1-x）In_2xO₃薄膜 蓝宝石衬底 退火     

不同衬底和CdCl2退火对磁控溅射CdS薄膜性能的影响

在科宁7059玻璃, FTO, ITO, AZO四种衬底上磁控溅射CdS薄膜, 并在CdCl₂+干燥空气380 ℃退火, 分别研究了不同衬底和退火工艺对CdS薄膜形貌、结构和光学性能的影响. 扫描电子显微镜形貌表明: 不同衬底原位溅射CdS薄膜的形貌不同, 退火后相应CdS薄膜的晶粒度和表面粗糙度明显增大. XRD衍射图谱表明: 不同衬底原位溅射和退火CdS薄膜均为六角相和立方相的混相结构, 退火前后科宁7059玻璃, FTO, AZO衬底上CdS薄膜有 H(002)/C(111) 最强衍射峰, ITO衬底原位溅射CdS薄膜没有明显的最强衍射峰, 退火后出现 H(002)/(111) 最强衍射峰. 紫外-可见分光光度计分析表明: AZO, FTO, ITO, 科宁7059玻璃衬底CdS薄膜的可见光平均透过率依次减小, 退火后相应衬底CdS薄膜的可见光平均透过率增大, 光学吸收系数降低; 退火显著增大了不同衬底CdS薄膜的光学带隙. 分析得出: 上述结果是由于不同衬底类型和退火工艺对CdS多晶薄膜的形貌、结构和带尾态掺杂浓度改变的结果. 关键词： CdS薄膜 磁控溅射 退火再结晶 带尾态