Subharmonic Response of a Quasi-Isochronous Vibroimpact System to a Randomly Disordered Periodic Excitation

A quasi-isochronous vibroimpact system is considered, i.e. a linear system with a rigid one-sided barrier, which is slightly offset from the system's static equilibrium position. The system is excited by a sinusoidal force with disorder, or random phase modulation. The mean excitation frequency corresponds to a simple or subharmonic resonance, i.e. the value of its ratio to the natural frequency of the system without a barrier is close to some even integer. Influence of white-noise fluctuations of the instantaneous excitation frequency around its mean on the response is studied in this paper. The analysis is based on a special Zhuravlev transformation, which reduces the system to one without impacts, or velocity jumps, thereby permitting the application of asymptotic averaging over the period for slowly varying inphase and quadrature responses. The averaged stochastic equations are solved exactly by the method of moments for the mean square response amplitude for the case of zero offset. A perturbation-based moment closure scheme is proposed for the case of nonzero offset and small random variations of amplitude. Therefore, the analytical results may be expected to be adequate for small values of excitation/system bandwidth ratio or for small intensities of the excitation frequency variations. However, at very large values of the parameter the results are approaching those predicted by a stochastic averaging method. Moreover, Monte-Carlo simulation has shown the moment closure results to be sufficiently accurate in general for any arbitrary bandwidth ratio. The basic conclusion, both of analytical and numerical simulation studies, is a sort of smearing of the amplitude frequency response curves owing to disorder, or random phase modulation: peak amplitudes may be strongly reduced, whereas somewhat increased response may be expected at large detunings, where response amplitudes to perfectly periodic excitation are relatively small.     

Fluid-Damping Controlled Instability in Tube Bundles Subjected to Air Cross-Flow

There are different excitation mechanisms that cause fatal damages due to undesirable vibrations in heat exchanger tube bundles subjected to cross-flow. One of them is the fluid-damping-controlled instability (galloping) that is characterised by a sudden appearance of large amplitudes of the tubes exclusively in cross-flow direction. This paper reports on investigations using an experimental set-up in a wind tunnel where the galloping mechanism in a tube bundle can be observed as an isolated phenomenon. The apparatus allows to realise several tube bundle configurations and geometry's of real heat exchangers. The position of a flexible test tube with a linear iso-viscoelastic mounting inside the tube array is variable. The test tube is equipped with dynamical pressure sensors which are placed directly under pressure holes inside the tube. For the investigation of the acting fluid forces the non-stationary pressure distribution is measured simultaneously at 30 points on the circumference in mid plane and at 15 points in line along the tube together with the tube motion. The acting fluid forces are determined by integration of the whole pressure field process. The study gives insights into the effect of the fluid-damping-controlled instability that is still not fully understood. Moreover, a flow visualization gives an impression of the mechanism at relevant Reynolds-numbers. The results show that in case of instability due to galloping the correlation length of the forces acting along the tube axis increases suddenly to large values. The fluid forces are correlated well for the whole tube when galloping is dominant. The exciting fluid forces show harmonic character and lead to a classical resonance behaviour. Instead of a simple free vibration test in vacuum or still air, which is done mostly for fluid excited structures, the damping coefficient of the oscillating system is determined under operating conditions on the basis of the measured fluid forces. A comparison of the results with those of a free vibration test in still air is shown. This revised version was published online in July 2006 with corrections to the Cover Date.     

结构振动对湍流近尾迹的影响

研究了圆柱绕流中流体与结构的相互作用,侧重结构振动对湍流尾迹的影响,用激光测振仪测量圆柱在升力方向的位移;用热线和LDA（二维）测量湍流的近尾迹,通过变化自由流的速度和圆柱体直径（特征尺寸）来变化雷诺数,用两个振动特性不同的（一个相对刚性,一个相对弹）圆柱来产生尾迹,研究固体结构振动对湍流近尾迹的平均速度场和湍流场的影响,结果表明,结构自由振动对湍流近尾迹场影响明显,该影响随雷诺数的变化不明显。     

Nonlinear Response of Cylindrical Shells to Random Excitation

An analytical study of nonlinear flexural vibrations of cylindrical shells to random excitation is presented. Donnell's thin-shell theory is used to develop the governing equations of motion. Thermal effects for a uniform temperature rise through the shell thickness are included in the formulation. A Monte Carlo simulation technique of stationary random processes, multi-mode Galerkin-like approach and numerical integration procedures are used to develop nonlinear response solutions of simply-supported cylindrical shells. Numerical results include time domain response histories, root-mean-square values and histograms of probability density. Comparison of Monte Carlo results is made to those obtained by statistical linearization and the Fokker–Planck equation.     

环形调液阻尼器振动控制中拍的研究

对环形调液阻尼器减振控制中的拍现象进行研究,分析了环形调液阻尼器对结构纯扭转振动控制中的拍现象,分别考虑无阻尼结构体系、主体结构有阻尼而CTLCD无阻尼的体系及主体结构和CTLCD中均有阻尼的体系,从数学角度对拍现象发生的机理进行解释.研究结构表明,当拍现象发生时,主体结构的振动不仅不会受到抑制,有时反而会加强;当环形调液阻尼器的阻尼增大到一定程度时,拍现象会消失;对于受廹振动,发生拍现象时,由于结构反应的瞬态部分不能得到迅速衰减,结构的瞬态响应将会占结构响应的很大一部分,如果仅考虑结构的稳态响应会带来较大的误差.     

Bias in modal parameters using the direct and iterative RFP identification procedures

In the rational fraction polynomial method [1] the identification of modal parameters is obtained through a direct linear least-square optimization technique but a particular form of fitting error is minimized. An iterative algorithm has been recently developed which uses the true fitting error [2]. In this paper a statistical analysis is developed to estimate the bias effects on the identified parameters when the data are polluted with noise. Both the direct and iterative procedures are considered. Numerical simulations are used to validate the results predicted by the theoretical analysis, which shows that the iterative approach is by far more efficient than the direct method.A first version of this paper was presented at 17th Int. Seminar on Modal Analysis, Leuven (Belgium), 23–25 September 1992, and preprinted in the Proceedings.     

Modelling of fluidelastic instability in a square inline tube array including the boundary layer effect

Flow-induced vibration (FIV) is a design concern in many engineering applications such as tube bundles in heat exchangers. When FIV materializes, it often results in fatigue and/or fretting wear of the tubes, leading to their failure. Three cross-flow excitation mechanisms are responsible for such failures: random turbulence excitation, Strouhal periodicity, and fluidelastic instability. Of these three mechanisms, fluidelastic instability has the greatest potential for destruction. Because of this, a large amount of research has been conducted to understand and predict this mechanism. This paper presents a time domain model to predict the fluidelastic instability forces in a tube array. The proposed model accounts for temporal variations in the flow separation. The unsteady boundary layer is solved numerically and coupled with the structure model and the far field flow model. It is found that including the boundary layer effect results in a lower stability threshold. This is primarily due to a larger fluidelastic force effect on the tube. The increase in the fluidelastic effect is attributed to the phase difference between the boundary layer separation point motion and the tube motion. It is also observed that a non-linear limit cycle is predicted by the proposed model.     

On the efficiency of energy harvesting using vortex-induced vibrations of cables

Many technologies based on fluid–structure interaction mechanisms are being developed to harvest energy from geophysical flows. The velocity of such flows is low, and so is their energy density. Large systems are therefore required to extract a significant amount of energy. The question of the efficiency of energy harvesting using vortex-induced vibrations (VIV) of cables is addressed in this paper, through two reference configurations: (i) a long tensioned cable with periodically-distributed harvesters and (ii) a hanging cable with a single harvester at its upper extremity. After validation against either direct numerical simulations or experiments, an appropriate reduced-order wake-oscillator model is used to perform parametric studies of the impact of the harvesting parameters on the efficiency. For both configurations, an optimal set of parameters is identified and it is shown that the maximum efficiency is close to the value reached with an elastically-mounted rigid cylinder. The variability of the efficiency is studied in light of the fundamental properties of each configuration, i.e. body flexibility and gravity-induced spatial variation of the tension. In the periodically-distributed harvester configuration, it is found that the standing-wave nature of the vibration and structural mode selection plays a central role in energy extraction. In contrast, the efficiency of the hanging cable is essentially driven by the occurrence of traveling wave vibrations.     

Wake-induced vibrations of an elastically mounted cylinder located downstream of a stationary larger cylinder at low Reynolds numbers

Two-dimensional numerical simulations of flow past two unequal-sized circular cylinders in tandem arrangement are performed at low Reynolds numbers (Re). The upstream larger cylinder is stationary, while the downstream cylinder has both one (transverse-only) and two (transverse and in-line) degrees of freedom (1-dof and 2-dof, respectively). The Re, based on the free stream velocity U_∞ and the downstream cylinder diameter d, varies between 50 and 200 with a wide range of reduced velocities U_r. The diameter of the upstream cylinder is twice that of the downstream cylinder, and the center-to-center spacing is 5.5d. In general, for the 1-dof case, the calculations show that the wake-induced vibrations (WIV) of the downstream cylinder are greatly amplified when compared to the case of a single cylinder or two equal-sized cylinders. The transverse amplitudes build up to a significantly higher level within and beyond the lock-in region, and the U_r associated with the peak amplitude shifts toward a higher value. The dominant wake pattern is 2S mode for Re=50 and 100, while with the increase of Re to 150 and 200, the P+S mode can be clearly observed at some lower U_r. For the 2-dof vibrations, the transverse response characteristics are similar to those presented in the corresponding 1-dof case. The in-line responses are generally much smaller, except for several significant vibrations resulting from in-line resonance. The obvious in-line vibration may induce a C (chaotic) vortex shedding mode for higher Re (Re=200). With regard to the 2-dof motion trajectories, besides the typical figure-eight pattern, several odd patterns such as figure-double eight and single-looped trajectories are also obtained due to the wake interference effect.     

Effects of several lanthanide trichloride hydrates on the melting behavior and spherulitic superstructure of poly(ethylene oxide)

Binary mixtures of poly(ethylene oxide) (PEO) with the trichloride hydrates of lanthanum, cerium, europium, terbium, and ytterbium have been studied with calorimetry, polarized optical microscopy, and infrared spectroscopy. Melting‐point depression of the PEO‐rich phase occurs in all cases. At sufficiently high concentrations of the low molecular weight lanthanide complex, crystallization of the polymer is absent. The lighter lanthanides with larger ionic radii, such as lanthanum and cerium, are more effective in suppressing PEO crystallization from solution or the molten state because they are more oxophilic. The spherulitic superstructure of PEO disappears at rather low concentrations of the lanthanide salts, between 2 and 8 mol % Ln³⁺. Lanthanum and terbium are most efficient at disrupting the formation of PEO spherulites, and europium is least efficient. Infrared spectroscopy identifies twisting and wagging vibrational absorptions of CH₂ groups in the polymer that are sensitive to the morphologies of these mixtures. Modifications of the PEO infrared absorbances in the presence of these five lanthanide salts correlate more closely with the presence or absence of major PEO melting, not the formation of a spherulitic superstructure. The phase behavior is rather simple, with no evidence of eutectic solidification upon cooling from the molten state. Multiple melting endotherms are observed in the differential scanning calorimetry heating traces of binary mixtures containing 8 mol % Yb³⁺ and between 10 and 20 mol % Eu³⁺, but the concentration dependence of these first‐order endothermic transitions is not characteristic of eutectic phase behavior. The presence of trivalent cations, such as Eu³⁺ or Yb³⁺, in these complexes perturbs the crystallization kinetics of PEO upon cooling from the molten state, as well as the melting behavior upon heating. Ion–dipole or electrostatic interactions between the lanthanide cation and the ether oxygen of PEO might alter the surface free energy at the periphery of the crystalline lamellae and perturb the chain‐folding characteristics of PEO. Consequently, coupling between the amorphous matrix and the PEO crystallites is strengthened, and this provides stability for the existence of multiple‐chain‐folded crystals composed of rather thin lamellae that could be responsible for multiple melting behavior. © 2003 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 41: 2200–2213, 2003