应当正视教材练习题上的2处硬伤

指出了人教版《化学1》教材上的2处硬伤,常温常压下硫酸铜溶液浓度不可能达到2 mol/L,实验时更不可能给学生1试管NO2。实验发现,通常情况下,将1试管NO2倒扣在水中,待液面基本稳定时,水位上升远远不止2/3试管。     

Effects of polybutadiene-g-SAN impact modifiers on the morphology and mechanical behaviors of ABS blends

A series of PB-g-SAN impact modifiers with different ratio of PB to SAN ranging from 20.6/79.4 to 91.9/8.1 were synthesized by seeded emulsion polymerization. ABS blends were prepared by blending these PB-g-SAN impact modifiers and SAN resin. The rubber concentration of these ABS blends was kept at a constant value of 15 wt%. The influences of different impact modifier on the mechanical behavior and morphology of ABS blends have been investigated. The dynamic mechanical analysis on ABS blends shows that T_g of the rubbery phase shifts to a lower temperature, (tan δ)_max of the rubbery phase increases and then decreases with the increase of PB concentration in PB-g-SAN impact modifier. A uniform dispersion of rubber particles in the matrix can be observed when PB/SAN ratio in PB-g-SAN impact modifier is in the range from 20.6/79.4 to 71.7/28.3. When it exceeds 71.7/28.3, an agglomeration of rubber particles occurs. The mechanical tests indicate that the ABS blend, in which PB/SAN ratio in the impact modifier is 71.7/28.3, has the maximum impact strength and yield strength.     

不同变质程度煤的高分辨率透射电镜分析

利用高分辨率透射电子显微镜(HRTEM)分析了三种不同变质程度煤样的结构特征。基于傅里叶-反傅里叶变换方法,并结合Matlab、Arcgis和Auto CAD软件,通过图像分析技术,获得了HRTEM照片的晶格条纹参数。结果表明,三种煤样的晶格条纹呈现不同特征,按条纹长度分别归属于1×1-8×8共计八个类型。以3×3为临界点,在1×1和2×2中,ML-8中芳香层片的比例高于DP-4和XM-3;在3×3-8×8中,ML-8中芳香层片的比例低于DP-4和XM-3。对比HRTEM和XRD参数d002发现,随着镜质组反射率的增加d002都呈现递减趋势。     

The Degree of Disorder in Hardwood Kraft Pulps Studied by Means of LODP

The amount of disordered material in two types of hardwood kraft pulps was estimated by determining the weight loss at the point where the levelling-off degree of polymerisation (LODP) was reached. The pulps used were commercial pulps viz (1)one conventional birch kraft and (2)one mixed hardwood (MHW) kraft pulp that had been prehydrolysed prior to cooking. The results indicated that the hemicellulose xylan is closely associated with the cellulose in commercial birch pulps. It is therefore only possible to use LODP as a measure of the crystallite length of hardwood cellulose in highly purified pulps, such as prehydrolysed kraft pulp. A model explaining the LODP-results is proposed.     

MICELLIZATION STUDIES OF DODECYL BENZENESULFONIC ACID AND ITS INTERACTION WITH POLYVINYLPYRROLIDONE

Dodecyl benzenesulfonic acid (DBSA) surfactant was used in the present study to find the effect of concentration on its electrical conductance in solution from 293-323K above and below the critical micelle concentration (CMC). The micellization parameters i.e. degree of counter ion binding (β), aggregation number (n) and number of counter ion micelle(m) were measured. The interaction of DBSA with polyvinylpyrrolidone (PVP) was also studied at 293K throughconductance and surface tension measure ments. A number of important parameters i.e. critical aggregation concentration (CAC), Gibb‘s free energy (△G) and binding ratio (R) were determined and the effect of NaCl on the CAC and polymer saturation point (PSP) was also investigated.     

不同脱乙酰度对壳聚糖表面物理及吸附性能的影响

壳聚糖是甲壳素部分脱乙酰化的产物,脱乙酰度的大小对壳聚糖的性能影响很大。利用碱液法,通过对反应时间的控制,制备了不同脱乙酰度的壳聚糖并对其性能进行了研究。结果表明,随着脱乙酰度的增大,壳聚糖膜的吸水率增加,而对其表面接触角的变化则没有影响。同时,壳聚糖海绵对Ca2+和牛血清蛋白(BSA)的吸附能力也随着脱乙酰度的增大而增加。     

高聚合度Ⅱ-型聚磷酸铵的合成

用聚合反应-热处理两段工艺合成了高聚合度的聚磷酸铵（APP）阻燃材料,其结构经XRD,粒度及平均聚合度表征。优化反应条件为：磷酸氢二铵1mol,n（磷酸氢二铵）：n（五氧化二磷）：n（脲）：1．0：1．0：0．3．干燥氨气氛下于290℃反应30min,再经250℃-280℃后处理100min-110min。APP的平均聚合度大于150,粒度小于50μm。     

Nitrate ion association with Nd3+

The overall stability constantsK ₁ andK ₂ of NdNO ₃ ²⁺ and Nd(NO₃) ₂ ⁺ complexes were determined (K ₁=1.77;K ₂=1.28) using an extraction method with tri-n-butyl phosphate as the extractant. The ratio ₁/₂ of the stepwise stability constants is discussed. It was established that the Nd(NO₃) ₂ ⁺ complex was an outer-sphere ion pair.

---

Die Assoziation von Nitrat-Ion mit Nd³⁺

Zusammenfassung Mittels einer Extraktionsmethode wurden die StabilitätskonstantenK ₁ undK ₂ von NdNO ₃ ²⁺ - und Nd(NO₃)⁺-Komplexen bestimmt (K ₁=1.77;K ₂=1.28; Tri-n-butylphosphat als Extraktionsmittel). Das Verhältnis ₁/₂ der stufenweisen Stabilitätskonstanten wird diskutiert. Es stellte sich heraus, daß der Nd(NO₃)⁺-Komplex als ein Outer-Shere-Ionenpaar vorliegt.

     

锂硫电池用高度环化硫化聚丙烯腈的制备

硫化聚丙烯腈因其不溶解机制和有效缓解锂硫电池中多硫化物“穿梭效应”,被认为是具有吸引力的锂硫电池正极候选材料。硫化聚丙烯腈的导电聚合物骨架具有优异的电子导电性,同时共轭主链能有效解决充放电过程中硫正极体积变化引起的正极结构坍塌问题。因硫化聚丙烯腈的固-固反应机理,有效克服了传统硫正极在醚类电解液中多硫化物溶解及穿梭效应的问题,具有高正极活性物质利用率、出色的循环稳定性和结构稳定性等优势。有许多研究工作致力于通过硫化促进剂来提高硫化聚丙烯腈的硫含量,进而提高材料的能量密度。其中,硫化聚丙烯腈主链的环化度与循环稳定性的关系引起了我们的关注。在该研究工作中,通过在硫化过程中引入无水硫酸铜和正乙基正苯基二硫代氨基甲酸锌(ZDB)合成了SPAN-C-V复合材料。无水硫酸铜和ZDB的共同引入降低了聚丙烯腈环化反应的起始温度,同时提高了产物SPAN-C-V内碳碳双键的含量,在提高了材料硫含量的同时提高了其环化度。以SPAN-C-V为正极活性物质所组装的锂硫电池展现出良好的循环稳定性和倍率性能：在0.2 C (1 C = 600 mAh·kg^-1)下循环100次后的可逆容量为601 mAh·kg^-1,容量保持率为93%。该工作对于硫化聚丙烯腈材料的发展提供了参考。