An improved microwave plasma torch for atomic spectrometry

The analytical performance of a microwave plasma torch was improved through mechanical alterations. Several problems reported in earlier designs were addressed: the ignition and stabilization of a helium plasma in the MPT was difficult; high powers were required to both ignite and operate the plasma; otherwise, the plasma would erratically change from an annular to a filament type discharge. In the new torch, the helium discharge was stabilized by replacing the copper central tube with one made of quartz. In addition, air entrainment was alleviated through use of a sheathing gas. This modification simplified the background mass spectrum and raised the effective ionization temperature of the discharge. A detailed schematic diagram of the new microwave plasma torch is presented.     

ICP—AES卡尔曼滤波同时测定铁基体中26种痕量元素

本文利用电感耦合等离子体原子发射光谱（ＩＣＰ－ＡＥＳ）多色仪的扫描功能，用Ｃ语言编制了Ｋａｌｍａｎ滤波程度软件包，用该软件包对铁基体中２６种痕量元素进行了回收率试验，并对标准碳素钢样中１３种痕量元素进行了测定，结果表明Ｋａｌｍａｎ滤波完全适用于复杂谱线基体中的多种元素同时分析。     

金属蛋白研究中几个值得注意的动向

本文叙述了金属蛋白和金属酶研究中近年来几个值得注意的发展动向，即与金属离子相关的疾病（特别是神经退行性疾病）、金属离子在蛋白质的折叠、聚集和装配中的作用，金属伴侣分子、金属蛋白的设计和构建、金属蛋白与DNA相互作用。     

Cyclodextrin effects on physical–chemical properties of novocaine

The UV-vis absorption and the fluorescence emission spectra of novocaine were analysed in aqueous cyclodextrin (CD) solutions. Either the absorbance read at λ_max 290 nm or the fluorescence emission intensity at λ_ems 346 nm increase in the presence of both α- and β-CD due to the formation of 1:1 inclusion complexes. The lower polarity of the CD-cavity sensed by the included drug enhances the emitted fluorescence; in fact, the same effect was observed in aqueous mixtures of acetonitrile, dioxane, or dimethylsulfoxide. The inclusion complex formation between the monocation of novocaine and CDs diminishes the electrical conductance of aqueous solutions of novocaine hydrochloride (NoHCl). Both the nitrosation reaction in aqueous acid medium and the ester hydrolysis in alkaline medium are retarded in the presence of CDs. The strongest effect was observed with β-CD as a consequence of the higher stability inclusion complex.     

Optimization of selenium determination in plant samples by hydride generation and axial view inductively coupled plasma atomic emission spectrometry

The use of hydride generation coupled with axial view inductively couple plasma atomic emission spectrometry was presented for the determination of selenium in plant samples. The chemical factors affecting potentially the hydride generation efficiency (hydrochloric acid, sodium borohydride and sodium hydroxide concentrations) were assessed through investigation of chemical interference, accuracy and repeatability. The accuracy of measurements was not affected by elements present in high concentration in the plant matrix (K, Ca, Mg, and P). No interference was also observed with transition metals. Using a real sample (maize) with standard additions, decreases of recoveries were sometimes observed for 0.1% (m/v) NaOH, and attained 13.8% in the most unfavourable case. The final accuracy of the method was verified by using two certified reference materials: CRM 402 (white clover) and CRM 279 (sea lettuce). No statistically significant differences were obtained between the measured concentrations and the certified values. The optimized method was found sensitive (detection limit 0.15 μg l⁻¹), reliable and repeatable (R.S.D. between 1.3% and 4.0%).     

Low-temperature electrothermal vaporization of thenoyltrifluoroacetone complex of Sc(III) and Y(III) for sample introduction in an inductively coupled plasma atomic emission spectrometry,and their determination in biological samples

A new method for inductively coupled plasma atomic emission spectrometry (ICP-AES) determination of trace Sc and Y, based on gaseous compound introduction into the plasma as their thenoyltrifluoroacetone (TTA) complexes by electrothermal vaporization was developed. Using the reagent TTA as chemical modifier can not only enhance the analytical signals, but also reduce the vaporization temperature. At a temperature of 1,000 °C the trace Sc and Y can be vaporized completely into ICP. The factors affecting the formation of the chelate and its vaporization behavior, such as drying time, vaporization temperature/time, reaction medium and the amount of TTA, were investigated in detail. Under the optimized conditions (drying temperature/time 100 °C/10 s, vaporization temperature/time 1,000 °C/4 s), the limits of detection for Sc and Y were 19 pg and 34 pg (3), respectively, and the relative standard deviations for Sc and Y were 4.2% (c _Sc=0.2 g mL^–1; n=7) and 2.6% (c _Y=0.5 g mL^–1; n=7). The linear ranges of the calibration graphs cover three orders of magnitude. The method was applied to the analysis of the biological reference materials (GBW 07602, bush branches and leaves; GBW 07604, poplar leaves), and the results obtained were in good agreement with the certified values.     

New silver(i) thiazole-based coordination polymers: structural and photophysical investigation

1. Download : Download high-res image (93KB)
2. Download : Download full-size image

     

Determination of trace impurities in boron nitride by graphite furnace atomic absorption spectrometry and electrothermal vaporization inductively coupled plasma optical emission spectrometry using solid sampling

Two digestion-free methods for trace analysis of boron nitride based on graphite furnace atomic absorption spectrometry (GFAAS) and electrothermal vaporization inductively coupled plasma spectrometry optical emission (ETV-ICP-OES) using direct solid sampling have been developed and applied to the determination of Al, Ca, Cr, Cu, Fe, Mg, Mn, Si, Ti and Zr in four boron nitride materials in concentration intervals of 1–23, 54–735, 0.05–21, 0.005–1.3, 1.6–112, 4.5–20, 0.03–1.8, 6–46, 38–170 and 0.4–2.3 μg g^− 1, respectively. At optimized experimental conditions, with both methods, effective in-situ analyte/matrix separation was achieved and calibration could be performed using calibration curves measured with aqueous standard solutions. In solid sampling GFAAS, before sampling, the platform was covered with graphite powder and, for determination of Si, also the Pd/Mg(NO₃)₂ modifier was used. In the determination of all analyte elements by solid sampling ETV-ICP-OES, Freon R12 was added to argon carrier gas. For solid sampling GFAAS and ETV-ICP-OES, the achievable limits of detection were within 5 (Cu)–130 (Si) ng g^− 1 and 8 (Cu)–200 (Si) ng g^− 1, respectively. The results obtained by these two methods for four boron nitride materials of different purity grades are compared each with the other and with those obtained in analysis of digests by ICP-OES. The performance of the two solid sampling methods is compared and discussed.     

Mechanism of silicon film deposition in the RF plasma reduction of silicon tetrachloride

Plasma-chemical reduction of SiCl₄ in mixtures with H₂ and Ar has been studied by optical emission spectroscopy (OES) and laser interferometry techniques. It has been found that the Ar:H₂ ratio strongly affects the plasma composition as well as the deposition (r _D) and etch (r _E) rates of Si: H, Cl films and that the electron impact dissociation is the most important channel for the production of SiCl_x species, which are the precursors of the film growth. Chemisorption of SiCl_x and the reactive surface reaction SiCl_x+H–SiCl_(x–1)0+HCl are important steps in the deposition process. The suggested deposition model givesr _D [SiCl_x][H], in agreement with the experimental data. Etching of Si: H, Cl films occurs at high Ar: H₂ ratio when Cl atoms in the gas phase become appreciable and increases with increasing Cl concentration. The etch rate is controlled by the Cl atom chemisorption step.     

Ultrasensitive fluorescent probe for the hydrophobic range of solvent polarities

The new 3-hydroxychromone derivative 2-(6-diethylaminobenzo[b]furan-2-yl)-3-hydroxychromone (FA) displays a dramatic solvent-dependent transformation of fluorescence spectra in the range of low-polarity solvents. The two well-separated emission bands change their relative intensities so that the short-wavelength band being of a very low intensity in hexane becomes dominant in the more polar ethyl acetate and trichloromethane. We suggest the participation in this effect of excited-state intramolecular proton transfer, which is characteristic for other 3-hydroxychromone and 3-hydroxyflavone derivatives, in the range of solvents of much higher polarities. Because of these unique properties, a number of spectroscopic parameters (positions of absorption and two fluorescence maxima, the ratio of their intensities and the fluorescence quantum yield) can be measured in this solvent range with multiparametric analysis of the data. In terms of solvent polarity, the shifts in both emission bands and their intensity ratio demonstrate a good correlation with empirical polarity scales E_T^N, P_y and SPP, while the absorption spectra reveal some deviations for the tested oxygen-containing solvent molecules. A good cross-correlation is observed between fluorescence spectral shifts and the ratio of band intensities. The latter provides the means for a dramatic amplification of solvent response. Thus, a new approach for ultrasensitive scaling and probing the solvent polarity in the low-polararity range can be suggested. It involves very simple ratiometric measurements at two emission bands and can be posed for a variety of applications. We present examples of these applications for distinguishing of polarities between methylated benzene derivatives, for quantitative assay of polar impurities in low-polar solvents and for detection of the changes of solvent polarity as a function of temperature.