Complications in the Use of the Taylor Dispersion Method for Ternary Diffusion Measurements: Methanol + Acetone + Water Mixtures

The Taylor dispersion technique is used to measure the ternary mutual diffusion coefficients of aqueous nonelectrolyte solutions at 25°C. The dispersion of the injected solutes is recorded by a differential refractometer and an ultraviolet-visible detector. The diffusion coefficients are calculated directly by fitting the theoretical dispersion equations to about six experimental curves simultaneously. If the ternary diffusion effects in the measured dispersion profiles are not confused by the inaccuracy of the experimental method or an unfavorable relative detector sensitivity, the diffusion coefficients are precise. For the system methanol + acetone + water, it is shown that the Taylor dispersion method is unsuitable for the determination of all the diffusion coefficients if the methanol mole fraction is less than 0.45 or the acetone mole fraction if more than 0.001.     

聚合物介质中盐离解行为的温度依赖性研究

<正> 近十年来尽管聚合物-盐复合物作为潜在的理想电解质材料已得到广泛研究,人们对于在象聚合物这样的高粘度介质中盐的离解行为仍缺乏了解。特别是关于盐离解度的温度依赖性,不同的作者对相似的体系曾得出截然相反的结论。最近,Angell和许康等相继通过不同研究途径证实了在上述介质中盐离解产生的自由离子数n随温度上升而下降,其趋势可由Arrhenius公式表示:     

水洗和回烧工艺对高镍三元材料LiNi0.88Co0.07Al0.05O2微观结构及电化学性能的影响

以镍钴氢氧化物、异丙醇铝为原料,采用水解法合成三元前驱体Ni_(0.88)Co_(0.07)Al_(0.05)O_2,再与锂盐混合烧结得到正极材料(TEM)、X射线光电子能谱(XPS)、能量色散X射线谱(EDS)和恒电流充放电测试等对样品的晶体结构、微观形貌、元素价态以及电化学性能进行表征。研究表明,料液比1∶25、水洗3次、600℃回烧2 h合成的LiNi_(0.88)Co_(0.07)Al_(0.05)O_2具有较优的综合电化学性能,其在0.2C的放电比容量达207.6 mAh·g~(-1),首次充放电效率为84.8%,1C放电比容量为192.0 mAh·g~(-1),循环100周后,材料的放电比容量仍有148.0 mAh·g~(-1),容量保持率达到77.1%。     

Evaluation of defect induced surface heterogeneity in Metal-Organic Framework materials with alkali dopants employing adsorption isotherm modelling

In this article, an assessment of surface structural heterogeneity in porous metal organic framework (MOF) structure has been demonstrated by employing the methane and carbon-dioxide adsorption isotherms data. The virgin MIL-101-(Cr) MOF was synthesized by the hydrothermal method and defects were induced in the MOF structure by doping with various alkali (K, Na, Li) cations. The synthesized MOFs were characterized by XRD, SEM, EDX and BET measurement techniques. In order to understand the defect induced surface heterogeneity by alkali cation dopants, the surface energy distributions for CH₄ and CO₂ adsorptions on MOFs were measured by Dubinin – Astakhov model equation. The surface heterogeneity is mainly controlled by the limiting uptakes of adsorbates, the polarizability of adsorbates and the adsorbate-adsorbent interaction energy.     

中低温Fe_2O_3-MnO_2-CeO_2/TiO_2脱硝催化剂的合成、表征及催化活性

选用共沉淀法以Fe,Mn和Ce三元复合氧化物为活性组分,以Ti O_2为载体,制备出一种铁基中低温SCR脱硝催化剂Fe_2O_3-Mn O_2-Ce O_2/Ti O_2.将制备的铁基中低温SCR脱硝催化剂进行脱硝活性模拟测试,结果表明在150℃~250℃温度区间内,掺杂含量不同的Fe_2O_3-Mn O_2-Ce O_2/Ti O_2复合氧化物催化剂大多都具有持续稳定的脱硝性能,催化效率最高可稳定在91%以上.同时,采用SEM,XRD,TG和EDS等催化剂表征手段,详细分析了其组分分布,空隙结构与催化性质.     

水在纳米管道中流动行为的分子动力学模拟

采用分子动力学方法模拟了纳米管道内水分子的流动行为. 考察了压强差、 管道直径和管道长度对通量的影响, 验证了流体在直径为2～2.8 nm管道中的流动行为符合Hagen-Poiseuille(HP)方程. 研究发现, 末端效应具有长度依赖性, 对于较短的管道其末端效应更为显著. 为了深入了解真实非均匀管道的流动行为, 使用直径不同的2种管道以不同的连接顺序组合成4种非均匀管道模型, 最终得到了不同的流量. 提出了二元管道模型, 对非均匀管道内的流动行为进行了初步探讨.     

铕(Ⅲ)水杨酸邻菲咯啉三元配合物性质研究

合成了Eu3+的水杨酸和邻菲咯啉三元配合物,其组成为Eu(Hsal)3phen,用IR,UV,XPS研究配合物的性质和成键特征.结果表明,Hsal-的羧基、phen的两个氮原子均与Eu3+离子呈双齿配位,形成配合物后芳香环上的共轭性减小.用循环伏安法研究了配合物在玻碳电极上的电化学行为,发现配合物的电化学可逆性比游离Eu3+离子差,不同底液对配合物的电化学行为有影响.     

2-乙酰氨基-3-苯基-N-苯基-丙烯酰胺衍生物的电子轰击质谱研究

本文报道了6种新的丙烯酰胺衍生物的EI谱。在精确质量测量和B/E,B~2/E联动扫描亚稳离子测定的基础上,着重讨论了该类化合物的共同质谱特征:如分子离子失去H_2O的成环反应;产物离子的开环反应;分子内的氢重排反应等。同时,利用Hammett方程讨论了化合物中N-苯基端苯环上不同取代基对特定碎片离子强度的影响     

Isometric crystallization of stretched poly(e-caprolactone) sheets for medical applications

Low melting temperature thermoplastic sheets based on poly(e-caprolactone) (PCL) can be formed directly on the patient and are used as immobilization device (mask) in the radiation therapy. The immobilization mask is allowed to harden in isometric conditions on the body at room temperature. A new method for isometric crystallization kinetics of thermoplastic polymer sheets is developed using a tensile-strength instrument. The isometric crystallization method allows investigating the shrinkage force on time of crystallization of stretched samples of thermoplastic polymer sheets or immobilization medical devices. The dependence of the shrinkage force on time is described by Avrami equation and the kinetics parameters of isometric crystallization are calculated. This revised version was published online in July 2006 with corrections to the Cover Date.