Analysis of Carbamazepine in Tablet and Human Serum by Sweeping‐Micellar Electrokinetic Chromatography Method

Abstract

A sensitive and simple micellar electrokinetic chromatography (MEKC) method was developed for the determination of the antiepileptic drug carbamazepine (CBZ) using a sweeping on‐line concentration method with photodiode array detection. The effect of pH, concentration of the running buffer solution, organic modifier, applied voltage and injection time on the concentration efficiency and separation was investigated. An untreated fused‐silica capillary was used (50 cm; effective length, 40 cm, 75 µm i.d.) for the analysis. The background solution (BGS) was 50 mmol · L^?1 NaH₂PO₄ (pH 3.0) containing 100 mmol · L^?1 SDS and 20% acetonitrile (5.82 ms · cm^?1) with an applied voltage of ?20 kV at 25°C. Sample introduction was performed at 0.5 psi for 90 s with diode array detection at 214 nm. For the method, the calibration curve was linear over a range of 0.5–40 µg · mL^?1 for CBZ with a correlation coefficient of 0.998. The detection limit (S/N=3∶1) of CBZ was 0.10 µg · mL^?1. About 100‐fold improvement in concentration sensitivity was achieved in terms of peak height by the sweeping method compared to conventional injection method. The sweeping‐MEKC method has been successfully applied to the analysis of CBZ in tablet and human serum.     

Principal Component‐Wavelet Neural Network as a Multivariate Calibration Method for Simultaneous Determination of Iron,Nickel, and Cobalt

Abstract

Principal component‐artificial neural network (PC‐ANN) and principal component‐wavelet neural network (PC‐WNN) are applied for simultaneous determination of iron(II), nickel(II), and cobalt(II). A simple and selective spectrophotometric method for simultaneous determination of iron(II), nickel(II), and cobalt(II) based on formation of their complexes with 1‐(2‐pyridylazo)‐2‐naphtol (PAN) in micellar media is described. Although the complexes of Fe(II), Ni(II), and Co(II) with reagent show a spectral overlap, they have been simultaneously determined by PC‐ANN and PC‐WNN. The results obtained by the two methods were compared and it was shown that in PC‐WNN, the convergence speed was faster and the root mean square error of prediction set was also smaller than PC‐ANN. Interference effects of common anions and cations were studied and the proposed method was also applied satisfactorily to the determination of Fe(II), Ni(II) and Co(II) in synthetic samples.     

Ricinus communis agglutinin I functionalisation of poly(methyl methacrylate) (PMMA) as a substrate for microfluidic device

We report a functionalisation strategy which is able to generate Ricinus communis agglutinin I (RCA 120) modified PMMA microfluidic device for binding and culturing living cells. The functionalisation is achieved by standard amine-aldehyde (Schiff base) reaction through the cross-linker, glutaraldehyde. To prove the ability of the RCA 120 modified PMMA surface, the PC 12 cell line (rat pheochromocytoma cells) has been captured and cultured by the microfluidic device. In the presence of tunicamycin, the dose/time-dependence on decreasing of binding affinity of RCA 120 modified device with PC 12 cell is also observed. The experimental results demonstrate that the lectin-functionalized microfluidic device can be employed as efficient cell culturing platform, and has a great promise of being used as a powerful tool for monitoring the interaction of drug with living cell.     

Measuring Bismuth Oxide Particle Size and Morphology in Film-Coated Tablets

The assessment of active pharmaceutical ingredient (API) particle size and morphology is of great importance for the pharmaceutical industry since it is expected to significantly affect physicochemical properties. However, very few methods are published for the determination of API morphology and particle size of film-coated (FC) tablets. In the current study we provide a methodology for the measurement of API particle size and morphology which could be applied in several final products. Bismuth Oxide 120 mg FC Tabs were used for our method development, which contain bismuth oxide (as tripotassium dicitratobismuthate (bismuth subcitrate)) as the active substance. The sample preparation consists of partial excipient dissolution in different solvents. Following this procedure, the API particles were successfully extracted from the granules. Particle size and morphology identification in Bismuth Oxide 120 mg FC Tabs was conducted using micro-Raman mapping spectroscopy and ImageJ software. The proposed methodology was repeated for the raw API material and against a reference listed drug (RLD) for comparative purposes. The API particle size was found to have decreased compared to the raw API, while the API morphology was also affected from the formulation manufacturing process. Comparison with the RLD product also revealed differences, mainly in the API particle size and secondarily in the crystal morphology.     

粉末压片-X-射线荧光光谱法分析砂岩型铀矿制样中粘结剂用量的探讨

由于砂岩型铀矿的成矿特性,样品粉末的内聚力小,采用直接压片法有时难以成型,样片表面常见裂纹,上机测量易碎裂。混合压片法适应性强,制样成功率高,但常见的问题是样品经粘结剂稀释会影响元素的检出限及结果的准确性。本文对粉末压片-X射线荧光光谱法测定砂岩型铀矿地质样品时,前期制样中添加粘结剂的比例进行了研究。试验按照不同比例在铀矿石标准物质GBW04101、GBW04102中添加粘结剂,在扫描电镜下观察到随着粘结剂用量的增加样片表面的光滑度及致密度都呈上升趋势,在X-射线荧光光谱仪上对主量元素进行测定后发现X射线强度在粘结剂添加量大于0.2 g时明显下降,经与GBW04101、GBW04102标准值进行对比后优选出粘结剂与样品的最佳比例为1：20,在此比例下制成的样片光滑平整,不易碎裂,用粉末压片-X射线荧光光谱法进行测定,标准物质测定结果的相对误差为0.56%～6.76 %,相对标准偏差(RSD,n=12)为0.013 %～7.68 %,均达到了《地质矿产实验室测试质量管理规范》DZ/T 0130-2006的要求。本文为粉末压片-X射线荧光光谱法分析砂岩型铀矿地质样品提供了可靠的实验参考依据。     

铁(Ⅲ)置换氧化还原滴定法测定维生素C片剂及针剂中抗坏血酸

基于将测定抗坏血酸的碘滴定（药典）法和铁铵矾滴定法相结合,即先用铁铵矾基准物氧化碘化钾置换出相当量的12,再在维生素C药物溶液滴定中让相当量的12定量氧化抗坏血酸。合适的反应条件是：乙酸介质,碘离子过量,室温置暗处置换反应10min。将该法用于维生素C药物中抗坏血酸的测定,结果与药典法结果相符。     

Electro-mechanical coupling wave propagating in a locally resonant piezoelectric/elastic phononic crystal nanobeam with surface effects

The model of a "spring-mass" resonator periodically attached to a piezoelectric/elastic phononic crystal(PC) nanobeam with surface effects is proposed, and the corresponding calculation method of the band structures is formulized and displayed by introducing the Euler beam theory and the surface piezoelectricity theory to the plane wave expansion(PWE) method. In order to reveal the unique wave propagation characteristics of such a model, the band structures of locally resonant(LR) elastic PC Eul...     

Comprehensive chemical profiling and quantification of Shexiang Xintongning tablets by integrating liquid chromatography-mass spectrometry and gas chromatography-mass spectrometry

Shexiang Xintongning tablet (SXXTN) is a traditional Chinese medicine (TCM) preparation for the treatment of coronary heart disease (CHD) angina pectoris. However, due to the complexity of the compounds in SXXTN, the active chemical components responsible for the therapeutic effect are still ambiguous. The purpose of our study was to characterize the chemical profile of SXXTN and quantify the representative chemicals. The high-performance liquid chromatography coupled with time-of-flight mass spectrometry (HPLC-QTOF MS) method and gas chromatograph coupled with mass spectrometry (GC–MS) method were utilized to identify the chemical constituents of SXXTN. A total of 140 compounds including alkaloids, ginsenosides, organic acids, esters, triterpenes, phthalides and amino acid were identified in accordance with their retention times, accurate masses and characteristic MS/MS fragment patterns. Forty-four volatile components were characterized by GC–MS through NIST database matching. In the further research of quantitative analysis, 40 non-volatile compounds and 17 volatile compounds were determined and successfully applied for detecting in 7 batches of SXXTN samples by high performance liquid chromatography coupled with triple-quadrupole tandem mass spectrometry (HPLC-QQQ MS) and gas chromatograph coupled with triple-quadrupole tandem mass spectrometry (GC-QQQ MS) in multiple reaction monitoring (MRM) mode, respectively. The quantitative methods were verified in linearity, precision, repeatability stability and recovery. The above results indicated that the established method was practical and reliable for synthetical quality evaluation of SXXTN. In addition, our study might supplement the chemical evidence for disclosing the material basis of its therapeutic effects.