Surface‐Tension‐Confined Microfluidics and Their Applications

This article is a brief overview of the emerging microfluidic systems called surface‐tension‐confined microfluidic (STCM) devices. STCM devices utilize surface energy that can control the movement of fluid droplets. Unlike conventional poly(dimethylsiloxane)‐based microfluidics which confine the movement of fluids by three‐dimensional (3D) microchannels, STCM systems provide two‐dimensional (2D) platforms for microfluidics. A variety of STCM devices have been prepared by various micro‐/nanofabrication strategies. Advantages of STCM devices over conventional microfluidics are significant reduction of energy consumption during device operation, facile introduction of fluids onto 2D microchannels without the use of a micropump, increased flow rate in a special type of STCM device, among others. Thus, STCM devices can be excellent alternatives for certain areas in microfluidics. In this Minireview, fabrication methods, operating modes, and applications of STCM devices are introduced.     

ZnFe2O4/Ag/TiO2复合材料的制备及其光催化性能

以硝酸银、钛酸四丁酯、无水氯化锌、六水氯化铁为原料,采用溶胶-凝胶法与溶剂热相结合的方法制备了ZnFe₂O₄/Ag/TiO₂复合材料,通过扫描电子显微镜、能谱分析仪、X射线粉末衍射仪、X射线光电子能谱仪、振动样品磁强计、紫外可见分光光度计对样品进行表征及测试。结果表明： ZnFe₂O₄/Ag/TiO₂-10具有最佳的光催化效果,在紫外和可见光下对染料的降解率都能达到90%以上,具有优异的紫外可见光光催化活性。ZnFe₂O₄/Ag/TiO₂具有独特的磁性,能在外部磁场作用下进行回收利用,这使其在实际应用中成为可能。通过磁分离技术重复回收利用5次后仍然保持优良的光催化性能,说明ZnFe₂O₄/Ag/TiO₂-10具有优异的磁性及较高的光催化循环稳定性。     

鸡骨素及其酶解液的美拉德反应产物挥发性风味成分比较分析

利用固相微萃取/气相色谱-质谱(SPME/GC-MS)联用与电子鼻(E-Nose)嗅探技术对鸡骨素美拉德反应产物(MRPs1)及鸡骨素酶解液美拉德反应产物(MRPs2)中的挥发性风味成分进行比较分析。在两种产物中共鉴定出77种挥发性化学成分,其中醇类18种、醛酮类23种、酸类3种、酯类10种、杂环类7种及其他类16种,两种产物中共有成分26种。与MRPs1相比,MRPs2中醛酮、杂环类化合物的相对含量较高,但前者的酯类物质含量更为丰富。(E)-2-辛烯-1-醇、(6Z,9Z)-十五碳二烯-1-醇、苯甲醛、辛醛、6-甲基-5-庚烯-2-酮、2-乙基-3-羟基-4(4H)-吡喃酮、2,3,5-三甲基-6-乙基吡嗪、2-[(甲基二硫基)甲基]呋喃构成了MRPs2的特有成分,γ-丁位十二内酯为MRPs1的特有成分。在两种反应产物中,除4-甲基-5-羟乙基噻唑的相对含量均较高外(MRP1相似文献   

超高效液相色谱串联质谱法同时快速测定牛奶中不同类型的11种兽药残留

建立了超高效液相色谱串联质谱测定牛奶中四环素类、青霉素类、磺胺类和泰乐菌素等11种兽药残留的检测方法。样品经乙腈超声提取后离心分离,上层清液稀释10倍后过0.2μm滤膜上机测定。在优化条件下,11种兽药在其线性范围内的相关系数均在0.998以上,定量下限(LOQ,S/N=10)为0.3～15μg/kg,在低、中、高3个水平下的加标回收率为81%～117%,相对标准偏差为0.6%～10.2%。方法用于实际牛奶样品中兽药残留量的测定,结果满意。     

Fe/MgO催化裂解甲烷制备碳纳米带

采用溶胶-凝胶法制备了Fe/MgO催化剂(E)。以甲烷为碳源,通过催化化学气相沉积法在E上生长出了碳纳米带(F),其结构和形貌经SEM和TEM表征。在最佳制备条件[E中Fe负载量为50%,甲烷流速70mL·min-1,于870℃反应1 h]下制备的F宽度约135 nm,厚约89 nm,长度在几十微米量级。     

Development and validation of a rapid and sensitive assay for the determination of anisodamine in 50 μL of beagle dog plasma by LC–MS/MS

A simple, rapid, high‐throughput, and highly sensitive LC–MS/MS was developed to determine anisodamine in a small volume (50 μL) of beagle dog plasma using atropine sulfate as the internal standard. The analyte and internal standard were isolated from 50 μL plasma samples after a one‐step protein precipitation using Sirocco 96‐well protein precipitation filtration plates. The separation was accomplished on a Hanbon Hedera CN column (100 × 4.6 mm, 5 μm) and the run time was 4 min. A Micromass Quatro Ultima mass spectrometer equipped with an ESI source was operated in the multiple reaction monitoring mode with the precursor‐to‐product ion transitions m/z 306.0→140.0 (anisodamine) and 290.0→123.9 (atropine) used for quantitation. The method was sensitive with a low LOQ of 0.05 ng/mL, and good linearity in the range 0.05–50 ng/mL for anisodamine (r² ≥ 0.995). All the validation data, such as accuracy, intra‐ and interrun precision, were within the required limits. The method was successfully applied to the pharmacokinetic study of anisodamine hydrochloride injection in beagle dogs.     

Determination of 48 fragrance allergens in toys using GC with ion trap MS/MS

This paper presents a method for the simultaneous determination of 48 fragrance allergens in four types of toys (plastic toys, play clays, plush toys, and paper toys) based on GC with ion trap MS/MS. Compared with single‐stage MS, MS/MS is superior in terms of the qualification and quantification of a large range of compounds in complicated matrices. Procedures for extraction and purification were optimized for each toy type. The method proved to be linear over a wide range of concentrations for all analytes with correlation coefficients between 0.9768 and 0.9999. Validation parameters, namely, LODs and LOQs, ranged from 0.005–5.0 and from 0.02–20 mg/kg, respectively. Average recoveries of target compounds (spiked at three concentration levels) were in the range of 79.5–109.1%. Intraday and interday repeatabilities of the proposed method varied from 0.7–10.5% and from 3.1–13.4%, respectively. The proposed method was used to monitor fragrance allergens in commercial toy products. Our findings indicate that this method is an accurate and effective technique for analyzing fragrance allergens in materials composed of complex components.     

Simultaneous determination of 11 related impurities in propofol by gas chromatography/tandem mass spectrometry coupled with pulsed splitless injection technique

A variety of related impurities, including starting materials, process impurities, and degradation products, can be detected in propofol. In this article, a sensitive and selective GC‐MS/MS method using pulsed splitless injection technique for the determination of 11 main related impurities in propofol in one chromatogram is investigated. This method is extensively validated for its linearity, recovery, precision, LOD, and LOQ, and is able to detect trace‐level related impurities (LOD = 0.2–5.6 μg/g) in propofol bulk drug. Stressed tests proposed that oxidative degradation, photolytic degradation, and heat are the main causes for the formation of degradation products in propofol.     

Coherent Vibrational Dynamics and High-resolution Nonlinear Spectroscopy： A Comparison with the Air/DMSO Liquid Interface

We present a comparative study on the C-H stretching vibrations at air/DMSO （dimethyl sulfoxide） interface with both the free-induction decay （FID） coherent vibrational dynamics and the sub-wavenumber high resolution sum-frequency generation vibrational spectroscopy measurements. In principle the frequency-domain and time-domain spectroscopic measurements should generate identical information for a given molecular system. However, when the molecular systems are with several coupled or overlapping vibrational modes, obtain- ing detailed spectroscopic and coherent dynamics information is not as straightforward and rather difficult from either the time-domain or the frequency domain measurements. For the case of air/DMSO interface that is with moderately complex vibrational spectra, we show that the frequency-domain measurement with sub-wavenumber high-resolution sum-frequency generation vibrational spectroscopy is probably more advantageous than the time- domain measurement in obtaining quantitative understanding of the structure and coherent dynamics of the molecular interface.