电感耦合等离子体发射光谱法测定记号笔笔芯和墨水中铜和铬

报道了使用ICP-AES测定记号笔芯和墨水中的铜和铬的方法。 主要关注了不同的样品前处理方法的研究。 结果表明: 对标记用的油性记号笔笔芯和含有高分子树脂的墨水, 采用550 ℃灰化, 混合酸(V_HNO3∶V_HClO4=3∶1)溶解的方法处理样品, 是该类样品比较好的处理方法; 而对不含有高分子树脂的墨水, 采用直接用混合酸(V_HNO3∶V_HClO4=3∶1)的消解即可。 消解后的样品经稀酸酸化后, 采用ICP-AES测定铜和铬, 结果准确、稳定。该方法适合记号笔或墨水中元素的测定。     

Improving signal-to-noise ratio for the forensic analysis of glass using micro X-ray fluorescence spectrometry

Micro X-ray fluorescence spectrometry (μXRF) is a standard technique used for the elemental analysis of glass fragments in forensic casework. The glass specimens encountered in casework are usually small (<1 mm), thin fragments that are partially transparent to the exciting X-ray beam. In addition to providing fluorescence from the small glass fragments, the primary beam X-rays can scatter within the chamber and provide noise in the measurements. To reduce scatter from the sample stage, the fragments are typically mounted on a thin plastic film and raised on an XRF sample cup (≤3 cm in height). However, at these heights, there may still be significant scatter from the sample stage, which adversely affects the signal-to-noise ratio (SNR) and the limit of detection (LOD). A plastic mount was designed and 3D-printed in-house to allow fragments to be raised as high as possible from the sample stage, thereby minimizing stage scatter. Most elements detected in glass showed an improvement in the SNR when using the 3D-printed mount for analyses. The greatest improvement (>30%) was observed for lower atomic number elements (Na and Mg) and higher atomic number elements (Sr and Zr). Another simple method to improve SNR is the use of primary beam filters; when using primary beam filters during analyses, elements with characteristic lines in the high-energy range (Rb, Sr, and Zr) showed the greatest improvement (>70%) in SNR. The impact of both strategies for the improvement of SNR is presented here.     

高盐样品中锂的电感耦合等离子体发射光谱法(ICP-OES)测定研究

锂是重要的战略金属和新能源材料,其开发利用受到全球的高度关注。在高盐卤水特别是盐湖卤水和地下卤水中富含巨量的锂资源,在对这些资源进行锂的开发利用过程中,需对锂的含量进行准确测定,然而卤水中共存的高浓度Na+, K+, Ca2+和Mg2+会对微量锂的准确测定产生严重的干扰。电感耦合等离子体发射光谱法(ICP-OES)具有线性范围宽和多元素同步分析能力,针对卤水中锂的快速准确测定,详细开展了高盐样品中锂的ICP-OES分析方法研究。结果表明,锂在610.364 nm处具有较高的信噪比,且Na+, K+, Ca2+, Mg2+和Ar不会对锂的测定产生显著的谱线干扰。然而,样品中大量共存的Na+, K+和Mg2+会对锂的测定产生严重的基体正干扰,而Ca2+产生负干扰。尽管内标法在消除基体干扰方面具有广泛的应用,但传统的以钇和钪为内标元素的内标法不能有效解决该问题。此外,针对标准加入法操作繁琐、不适合批量样品分析问题,以及基体匹配法需多离子匹配,且不适合样品基体组成变化的批量样品分析等问题,考察了采用单一组分进行复杂基体匹配的可行性。由于NaCl广泛存在于卤水中,且对锂的测定具有显著的增敏效应,通过系列研究发现,通过同时向样品和标准溶液中加入10 g·L-1的NaCl,成功解决了总量不超过40 g·L-1的NaCl, KCl和MgCl2所产生的干扰。尽管采用该法或沉淀预分离方式均不能消除Ca2+产生的负干扰,但当样品中Ca2+含量不高于1.8 g·L-1时,对测定不产生显著的影响。通过采用该方法对三种不同基体组成的卤水样品进行加标回收测定,其回收率在96.60%~104.20%范围内。此外,通过与电感耦合等离子体质谱法(ICP-MS)测定结果进行对比,充分论证了该法的准确性和可靠性(相对误差±3.66%)。该法仅以单一的NaCl进行复杂基体匹配,不仅简化了操作,还实现了基体组成变化的批量样品分析,因而在卤水中锂的快速准确测定及锂资源开发利用方面具有重要意义。     

Nonlinear Measures to Evaluate Upright Postural Stability: A Systematic Review

Conventional biomechanical analyses of human movement have been generally derived from linear mathematics. While these methods can be useful in many situations, they fail to describe the behavior of the human body systems that are predominately nonlinear. For this reason, nonlinear analyses have become more prevalent in recent literature. These analytical techniques are typically investigated using concepts related to variability, stability, complexity, and adaptability. This review aims to investigate the application of nonlinear metrics to assess postural stability. A systematic review was conducted of papers published from 2009 to 2019. Databases searched were PubMed, Google Scholar, Science-Direct and EBSCO. The main inclusion consisted of: Sample entropy, fractal dimension, Lyapunov exponent used as nonlinear measures, and assessment of the variability of the center of pressure during standing using force plate. Following screening, 43 articles out of the initial 1100 were reviewed including 33 articles on sample entropy, 10 articles on fractal dimension, and 4 papers on the Lyapunov exponent. This systematic study shows the reductions in postural regularity related to aging and the disease or injures in the adaptive capabilities of the movement system and how the predictability changes with different task constraints.     

环境水样中硒形态分析的样品预处理

综述了近几年来测定环境水样中硒的样品前处理方法,主要包括样品消解,加入基体改进剂和分离富集3个方面。消解法中主要使用湿法消解;加入基体改进剂适用于石墨炉原子吸收光谱法的样品预处理,可以提高硒的灰化温度,减少硒的损失以及样品中基体的干扰;固相萃取法是萃取法的主要使用手段。     

胶束液相色谱法测定制剂和尿样中布洛芬

采用胶束液相色谱法分离和测定制剂和尿样中布洛芬,考察了表面活性剂的种类及浓度、柱温、流动相pH值,流速对布洛芬色谱保留行为的影响,探讨并提出了布洛芬在吐温-80为非离子表面活性剂的胶束液相色谱中的色谱保留模型。以ZORBAXExtend-C18色谱柱(4.6mm×250mm,5μm),20mmol.L-1吐温-80和25mmol.L-1磷酸氢二钾(pH7.8)混合溶液为流动相,在263nm处进行测定,布洛芬的保留时间为5.8min。布洛芬的质量浓度在0.2～1.0g.L-1范围内呈线性关系,检出限(3S/N)为1.1ng,平均回收率达98.3%～102.1%。     

Sample Entropy as a Tool to Assess Lumbo-Pelvic Movements in a Clinical Test for Low-Back-Pain Patients

Low back pain (LBP) obviously reduces the quality of life but is also the world’s leading cause of years lived with disability. Alterations in motor response and changes in movement patterns are expected in LBP patients when compared to healthy people. Such changes in dynamics may be assessed by the nonlinear analysis of kinematical time series recorded from one patient’s motion. Since sample entropy (SampEn) has emerged as a relevant index measuring the complexity of a given time series, we propose the development of a clinical test based on SampEn of a time series recorded by a wearable inertial measurement unit for repeated bending and returns (b and r) of the trunk. Twenty-three healthy participants were asked to perform, in random order, 50 repetitions of this movement by touching a stool and another 50 repetitions by touching a box on the floor. The angular amplitude of the b and r movement and the sample entropy of the three components of the angular velocity and acceleration were computed. We showed that the repetitive b and r “touch the stool” test could indeed be the basis of a clinical test for the evaluation of low-back-pain patients, with an optimal duration of 70 s, acceptable in daily clinical practice.     

Synthesis, Structure and Optical Properties of Cerium(Ⅲ) Triphosphate CeP3O9

The single crystal and crystallized powder of triphosphate CeP3O9 have been synthesized, and the space group of CeP3O9 has been determined to be C2221 with the cell parameters ofa = 8.6059, b = 11.2437, c = 7.3518 (A), V= 711.4(3) (A)3, Z= 4, Dc = 3.520 g/cm3, F(000) = 700,R = 0.0377 and wR = 0.0930. The absorption and emission spectra have been measured, for which the strongest absorption and emission peaks are located at 280 and 320 nm, respectively. The density of state (DOS) and dielectric function have been calculated by the DFT method. The crystal is transparent provided the wavelength is larger than 341 nm, and the observed ultraviolet cut-off edge is at about 350 nm for a polycrystalline power sample. It is possible that the triphosphate CeP3O9 will become an ultraviolet emission material.     

Studies on the Structure and Properties of Cordierite Synthesized by Talc-Magnesite

Homogeneous cordierite has been synthesized at low cost by talc-magnesite and coal gangue as the main raw materials. The mechanism of synthesizing cordierite under such a com- posing system of raw materials, and the effect of temperature on the crystal cell parameters and microstructure and thermal expansion coefficient of cordierite crystal have been studied via testing methods of XRD, SEM, etc. The result shows that the homogeneous cordierite can be synthesized by the systematic composing materials of “talc-magnesite—coal gangue—talc” with heat pre- servation at 1350 ℃ for 1 h; as the keeping time is prolonged, Al3+ and Mg2+ in cordierite crystal are replaced by a few impurity ions such as Fe3+, Fe2+, etc., and the crystal cell parameters of cordierite present an increase trend; as the high-temperature heat preservation is prolonged, the content of glassy phase in the sample is increased, its density is improved, and its thermal expansion coeffi- cient presents an increase trend.     

三相中空纤维式液相微萃取用于快速富集血浆中的尼古丁

建立了一种以三相中空纤维式液相微萃取(TP-HF-LPME)进行样品前处理,采用高效液相色谱快速、准确测定血浆中尼古丁含量的方法。研究表明该方法集萃取、富集、净化为一步,极大地简化了传统血浆成分测定的前处理过程,是一种快速、有效、绿色的前处理方法。方法的线性范围为0.1～50 mg/L,相关系数(r2)为0.9996,检测限为0.05 mg/L (信噪比为3),相对标准偏差小于5%。