Yeast cell microfiltration: Flux enhancement in baffled and pulsatile flow systems

The filtration performance of yeast cell harvesting was greatly improved by using an oscillatory flow mixing technique in both tubular and flat sheet membrane systems; flux increases of several fold were achieved. The effects of various operating parameters such as frequency, amplitude and ratio of net forward flow rate to oscillatory flow rate were investigated. A simple alternative to the dual head pump, which involved the use of solenoid valves for producing flow reversal, was developed. The flux was significantly increased using this new operating mode. As the only increase of power consumption was from inertia loss due to change of flow direction the additional power consumption is minimal.     

纳米CoHCF修饰电极的制备及其对血红蛋白的电化学测定研究

A cobalt hexacyanoferrate （CoHCF） nanoparticle （size ca. 60 nm） chemically modified electrode （CME） was fabricated and the electrochemical behavior of hemoglobin （Hb） at this nanosized CoHCF CME was studied. In comparison with a bare glassy carbon electrode （GCE） and a general CoHCF CME electrodeposited in a traditional manner, the present nanosized CoHCF CME performed efficiently electrocatalytic reduction for Hb with relatively high sensitivity, stability, and longlife, Combined with liquid chromatography （LC）, the nanosized CoHCF CME was used as the electrochemical detector of Hb in the established flow injection analysis-electrochemical determination （FIA-ECD） system. The peak current was a linear function of concentrations in the range from 2.5×10^-8 to 5.0×10^-6mol/L for Hb, with detection limit of 1.4×10^-8 mol/L. The FIA-ECD system has been successfully applied to assess the Hb content of clinic blood samples with advantages of sensitiveness, speediness, easy control and small sample-consumption.     

芯片式流通池顺序注射可更新表面反射光谱法用于酶反应检测

将芯片式流通池顺序注射可更新表面反射光谱法用于酶反应检测。HRP催化H2O2氧化BPR底物的反应用于对H2O2的检测。此反应体系与葡萄糖氧化酶联用，用于对血清中葡萄糖的检测。     

Heat transfer from a rarefied plasma flow to a metallic or nonmetallic particle

Heat transfer from a plasma flow to a metallic or nonmetallic spherical particle is studied in this paper for the extreme case of free-molecule flow regime. Analytical expressions are derived for the heat flux due to, respectively, atoms, ions, and electrons and for the floating potential on the sphere exposed to a two-temperature plasma flow. It has been shown that the local or average heat flux density over the whole sphere is independent of the sphere radius and approximately in direct proportion to the gas pressure. The presence of a macroscopic relative velocity between the plasma and the sphere causes substantially nonuniform distributions of the local heat flux and enhances the total heat flux to the sphere. The heat flux is also enhanced by the gas ionization. Appreciable difference between metallic and nonmetallic spheres is found in the distributions along the oncoming flow direction of the floating potential and of the local heat flux densities due to ions and electrons. The total heat flux to the whole sphere is, however, almost the same for these different spheres. For a fixed value of the electron temperature, the heat flux decreases with increasing temperature ratio T_e/T_h.     

Physicochemical aspects of microbial adhesion — Influence of antibody adsorption on the deposition ofStreptococcus sobrinus in a parallel-plate flow chamber

Deposition of the oral bacteriumStreptococcus sobrinus HG977 onto glass (water contact angle 0°) and onto FEP-Teflon (fluoroethylenepropylene; water contact angle 110°) was studied in a parallel-plate flow chamber in the presence and absence of polyclonal antibodies (pAb) and monoclonal antibodies (mAbs) adsorbed onto the cells. The zeta potentials of the bacteria ranged from −7.1 to −8.5 mV at pH 6.8 and were not affected by the presence of pAb or mAbs. Hydrophobicity (by water contact angles) increased from 30° (no antibodies) to 88° in the presence of pAb adsorbed onto the bacterial cell surface. The untreatedS. sobrinus had a greater tendency to adhere to glass (44.5 × 10⁶ cm⁻²) than to FEP-Teflon (18.3 × 10⁶ cm⁻²), in accordance with thermodynamic modelling. After preincubation ofS. sobrinus with pAb, its clear preference for adhesion to glass disappeared as expected from its increased hydrophobicity. Although forS. sobrinus preincubated with OMVU10 no difference was found in hydrophobicity in comparison to the untreated bacteria, the number of bacteria adhering to glass decreased to 10.2 ¢ 10⁶ cm⁻². Formation of bacterial aggregates was found whenS. sobrinus, preincubated with pAb or OMVU10, adhered to glass and FEP. This was also observed when untreated bacteria adhered to glass coated with OMVU10, or to FEP coaled with OMVU10 or pAb. Adhesion in these experiments is therefore thought to occur via near-neighbour collection induced by the presence of pAb or mAbs. Low numbers of bacteria were removed from glass after draining the flow cell, whereas high numbers of untreated bacteria and bacteria preincubated with OMVU10 were removed from FEP.S. sobrinus cells preincubated with pAb were not removed but piled up. It was concluded that the adhesion of untreatedS. sobrinus andS. sobrinus preincubated with pAb is in accordance with thermodynamic modelling, based on the overall wettability of the cell surfaces, whereas the adhesion ofS. sobrinus preincubated with OMVU10 may be through localized interactions, not expressed in overall surface properties.     

稳态双曲流场中液/液混合的粘性液滴哑铃分散模型

通过对稳态双曲流场中液／液混合体系分散相液滴所受分散作用力的分析，建立了粘性液滴的哑铃分散模型．趋于将两粘性液滴分开的分散作用力与粘度比、流场类型和强度、液滴半径、哑铃取向和尺寸有关．该模型解释了流场类型与分散作用的关系．流场类型对液滴的分散具有很大影响，在纯应变拉伸流场中分散作用力是简单剪切流场中的两倍，因而对于液滴的分散，拉伸流场较简单剪切流场更有效，这与以前的实验结论符合．当体系粘度比趋于无穷大时本模型转化为刚性哑铃分散模型     

流动注射光度法同时测定铜基合金中的铝和铁

提出了同时测定铜基合金中铝和铁的流动注射分析法。以０．０４ｍｏｌ／ＬＨＣｌ作载液，铬天青Ｓ为显色剂，通过测定６２８ｎｍ处铝、铁两配合物的吸光度之和及铝配合物的吸光度，实现了两组分的同时测定。在优化的实验条件下，检测限：Ａｌ和Ｆｅ分别为１．６９×１０－３和１．７３×１０－３ｍｇ／Ｌ，Ａｌ浓度在０～０．８ｍｇ／Ｌ；Ｆｅ浓度在０～１．０ｍｇ／Ｌ时服从比耳定律。进样频率为６０样／ｈ，所拟方法用于实际样品分析，获得满意结果。     

Stability of the FID sensitivity during an analysis in capillary GC

The sensitivity of an FID may change when the carrier gas flow rate changes during a chromatographic run. Sample parts which are eluted at reduced FID sensitivity produce a reduced peak area, hence are discriminated as compared to other components. Sensitivity changes were studied for hydrogen as carrier gas. For the detector tested, differences in the carrier gas flow rates of 1 ml/min shifted the FID sensitivity by 1 to 5% (depending on the fuel gas supply). Thus the stability of the sensitivity is no longer ensured as soon as the carrier gas flow rate is changed manually or by an automatic programmer during an analysis. Sensitivity drifts may also occur during temperature programmed runs with a pressure regulated carrier gas supply since the gas flow through the capillary drops with increasing temperature. Such shifts in the response became noticeable as soon as relatively high carrier gas flow rates combined with long range temperature programmes were used. The typical patterns of such discriminations are shown, closing with a discussion on the possibilities for minimizing such undesired effects.     

A study of preferential solvation of N-alkyl pyridinium iodides in mixed solvents containing acetonitrile

The charge transfer (CT) band maximum of N-alkyl pyridinium iodide (NAPI) has been studied as a function of the composition of binary mixed dipolar aprotic solvents. The deviation from linearity of the energy maximum (E₁₂) and the mole fraction (of a component solvent) plot is explained as due to a preferential solvation by the more polar cosolvent in the binary mixture. The extent of preferential solvation has been observed to vary with the composition, the maximum being towards the less-polar end. The role of hydrogen bond donating ability of a solvent in preferential solvation is discussed.     

Thin layer distillation for matrix isolation in flow analysis

Analyte transfer from the matrix in a thin layer distillation (TLD) cell and its subsequent measurement were investigated in a flow injection configuration. We designed the cell such that the donor and acceptor streams flowed in parallel channels separated by a thin dividing wall. The matrix transfer process involved room-temperature distillation of the analyte into the headspace of the TLD cell and its subsequent condensation/uptake by a concurrently flowing acceptor stream. There are no membranes; hence there are no membrane-related problems. The TLD system design was optimized with respect to its dimensions and operational parameters. Throughput and sensitivity were compared with a conventional pervaporation flow injection (PFI) system for ammonia and five different amines. For the higher molecular mass amines, the TLD approach provided comparable or superior performance. The TLD technique should be an attractive approach for online analysis of volatile chemical species in ‘dirty’ samples, especially for volatile analytes of higher molecular mass.