生产井开发指标的分层分方向定量计算方法

针对注水开发的多层砂岩油藏分层动态分析难度大等问题,在常规井层开发指标计算基础上,结合动、静态劈分方法,综合考虑渗透率、孔隙度、地层系数、含水饱和度、位置系数、措施系数及注水量系数,提出了一种既可将油、水井作为统一整体,又可对小层、方向流动分量开发指标进行定量计算的体现渗流力学本质的方法。用大庆油田N2-O1井组的产液剖面资料进行验证。结果表明,所提方法的计算结果与测量结果吻合度较高,精度平均值达75.11%。用该方法计算开发指标,适用性强,能较真实地反映各小层、各方向的产液情况,对现场应用具有指导意义。     

Lower Energy α Elastic Scattering on ^20Ne and Anomaly of α＋^20Ne Scattering System

The α+²⁰Ne elastic scattering angular distributions at lower incident energies of Eα= 12.7--31.1 MeV have been analyzed by using the α-folding potential based on the α+¹⁶O structure model of the ²⁰Ne nucleus. The α-folding potential with a standard Woods-Saxon type imaginary part, can reasonably describe experimental cross sections and the anomalous large angle scattering (ALAS) features. The anomaly of the α+²⁰Ne scattering system is further confirmed in the lower incident energy region.     

Study of the sintering behaviour of MgB2 superconductor during hot-pressing

The densification behaviour of MgB₂ was studied when commercial powder was hot-pressed in the temperature range 1070–1190 °C. The mechanisms active during sintering were investigated by continuously recording the shrinkage vs. time and elaborating the data on the basis of Kingery’s model for liquid phase sintering. XRD and SEM analysis on final dense bodies were used to evaluate secondary phases formation during sintering and the effect of magnesium sublimation. AC magnetic susceptibility measurements were also performed to correlate the microstructural and morphological modifications induced by hot-pressing and the superconducting properties.     

Physics with large extra dimensions

The recent understanding of string theory opens the possibility that the string scale can be as low as a few TeV. The apparent weakness of gravitational interactions can then be accounted by the existence of large internal dimensions, in the sub-millimeter region. Furthermore, our world must be confined to live on a brane transverse to these large dimensions, with which it interacts only gravitationally. In my lecture, I describe briefly this scenario which gives a new theoretical framework for solving the gauge hierarchy problem and the unification of all interactions. I also discuss a minimal embedding of the standard model, gauge coupling unification and proton stability. On leave from: Centre de Physique Théorique, Ecole Polytechnique, 91128 Palaiseau, Cedex, France.     

基于可见光-近红外光谱的BIF磁性率确定方法研究

铁矿中磁性率是评价铁矿床工业价值和划分矿石工业类型的重要指标。传统的磁性率测定法存在工作量大、效率低、周期长的缺陷,成为经济、合理、高效开采铁矿资源的瓶颈问题。采用便携式地物光谱测试仪对辽宁省鞍钢集团鞍千矿业有限责任公司的BIF实验样品进行可见光-近红外光谱测试,分析了光谱特征,构建了比值指数(RI)、差值指数(DI)和归一化指数(NDI),并确定光谱指数与样品磁性率相关性最显著的敏感波段及对应的相关系数值;优选出与样品磁性率相关性最显著的比值指数(RI),构建实验样品磁性率的定量反演模型,并进行了验证。结果表明,三种光谱指数与样品磁性率敏感波段均位于935与1 050 nm,且该波段处的相关系数均达到0.9以上,其中比值指数与样品磁性率的相关性最高;基于比值指数构建的实验样品磁性率定量反演模型的预测误差为0.038,反演磁性率与实测磁性率的判定系数(R2)为0.964 5,预测结果比较理想。为确定BIF的磁性率提供了一种新方法,该方法具有工作强度小、经济、高效、便捷的优点,且对遥感找矿具有一定指导意义。     

欧姆接触中接触电阻率的计算

从欧姆接触电阻率的定义出发,先从理论上介绍了热离子发射、热离子场发射和场发射三种不同情况下欧姆接触电阻率的计算公式,然后详细地从实验上综合各种测试方法,并讨论了其利弊．     

应用分离涡模型计算斜圆柱孔气膜冷却

分离涡模型(DES,Detached eddy simulation)兼有雷诺时均湍流模型计算量较小和大涡模拟计算精度高的优点。本文利用DES对平板单斜圆柱孔的气膜冷却进行了数值模拟,并将结果同RANS湍流模型的计算结果以及实验数据相比较,表明DES能有效弥补RANS湍流模型在计算三维不均匀非定常湍流场的不足,更接近实际地反映了气膜冷却中的流动和换热的本质规律。     

基于Contourlet域隐马尔可夫树模型的图像融合算法

本文提出一种基于Contourlet域隐马尔可夫树(HMT)模型的图像融合算法。由于Contourlet变换能克服小波变换在处理高维信号时的不足,它比小波变换具有更好的方向性、较高的逼近精度和更好的稀疏表达性能。而HMT模型能有效捕获尺度间、尺度内的contourlet系数特性。因此将Contourlet域HMT模型应用于图像融合领域,能充分挖掘数据之间的相关性,更好的提取图像边缘特征,为融合提取更多的特征信息。实验结果表明本文的算法获得的融合图像视觉效果良好,是一种有效且可行的融合算法。     

器件效应数值模拟中漂移扩散模型的误差分析

为了确定数值模拟过程中的误差来源,并针对误差来源改进软件,减小计算误差,对半导体器件数值模拟中的采用的漂移扩散模型进行了研究。结合自主开发的半导体器件效应软件GSRES,分析了软件中漂移扩散模型的理论近似,对计算模型中由于温度分布、载流子复合/产生率、载流子迁移率等项采取近似而导致的误差进行了分析。根据误差分析和数值模拟算例,认为误差主要来自于器件内部温度场分布和迁移率模型的近似,给出了软件的适用范围。结合半导体器件的研究热点和发展趋势,对该模型中需要进行改进的近似项进行了分析。