Melt‐state polymer chain dimensions as a function of temperature

The unperturbed chain dimensions (〈R²〉_o/M) of cis/trans‐1,4‐polyisoprene, a near‐atactic poly(methyl methacrylate), and atactic polyolefins were measured as a function of temperature in the melt state via small‐angle neutron scattering (SANS). The polyolefinic materials were derived from polydienes or polystyrene via hydrogenation or deuteration and represent structures not encountered commercially. The parent polymers were prepared via lithium‐based anionic polymerizations in cyclohexane with, in some cases, a polymer microstructure modifier present. The polyolefins retained the near‐monodisperse molecular weight distributions exhibited by the precursor materials. The melt SANS‐based chain dimension data allowed the evaluation of the temperature coefficients [dln 〈R²〉_o/dT(κ)] for these polymers. The evaluated polymers obeyed the packing length (p)‐based expressions of the plateau modulus, G = kT/np³ (MPa), and the entanglement molecular weight, M_e = ρN_anp³ (g mol^?1), where n_t denotes the number (～21) of entanglement strands in a cube with the dimensions of the reptation tube diameter (d_t) and ρ is the chain density. The product np³ is the displaced volume (V_e) of an entanglement that is also expressible as pd or kT/G. © 2002 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 40: 1768–1776, 2002     

Sample evaporation in conventional split/splitless GC injectors. Part 3: Retaining the liquid in the vaporizing chamber

As most sample liquids tend to pass through an empty injector insert at a speed which is too high to enable complete evaporation, movement of the liquid must be arrested before it reaches the column entrance. Stopping the liquid means deposition on to a surface; this, however, is possible only after the temperature of the surface has been cooled to (or below) the boiling point of the liquid (solvent). The performance of different means of stopping the liquid has been tested visually (by the method described in Part 2). Baffles on the wall of the injector insert had hardly any effect on evaporation: the band of liquid leaving the syringe needle performed a perfect slalorn around them. The inverted cup proved more efficient, but the best performance was obtained from a light plug of glass wool: owing to its low thermal mass, the first fibers to be met by the liquid are immediately cooled to the solvent boiling point, allowing the liquid to wet it. The sample liquid is sucked up by the glass wool, from where the sample evaporates relatively slowly, often over a period of several seconds.     

Determination of total heterogeneity and fractal dimensions of high-temperature superconductors

Using thermo-analytical and sorptometric methods physicochemical properties and especially surface heterogeneity of HgBa₂Ca₂Cu₃O₈₊, (Hg-1223) was investigated. The desorption energy distribution was derived from mass loss Q-TG and differential mass loss Q-DTG curves of thermodesorption in quasi-isothermal conditions of pre-adsorbed n-octane and water vapour. It is shown that the superconducting Hg-1223 phase is highly sensitive to water vapours. The mechanism of water adsorption depends largely on the activation time. By water vapour saturation in a period of 90 min, physisorption takes place. Prolonged periods result in a chemical decomposition. From nitrogen ad- and desorption isotherms the fractal dimension of superconductors were calculated. A new approach is proposed to calculate fractal dimension from Q-TG curves.This revised version was published online in November 2005 with corrections to the Cover Date.     

Orthokinetic Aggregation in Two Dimensions of Monodisperse and Bidisperse Colloidal Systems

Orthokinetic aggregation of colloids trapped at the air–liquid interface was studied by direct imaging in a couette cell. This method allowed us to follow the temporal evolution of both the cluster-mass distribution and the cluster structure at a shear rate where Brownian aggregation is suppressed. The interactions between the monodisperse latex particles floating at the air–liquid interface were controlled either by varying the electrolyte concentration or by creating a bidisperse system through the addition of small particles. The results show that the clusters in all of the systems are characterized by a high fractal dimension, indicating that the clusters are rearranged and densified by the shear. Kinetic analysis suggests that aggregation of monodisperse systems mainly proceeds through homogeneous aggregation, i.e., large clusters sticking to other large clusters. The bidisperse system, finally, with a size ratio around 10, favored a more heterogeneous aggregation among small and large clusters throughout the aggregation process; a slightly lower fractal dimension was observed compared to the strongly aggregated monodisperse system.     

烟草三维荧光特征和品质评吸的关系

研究不同品种烟草石油醚冷萃取物的三维荧光光谱，包括烟草所共在的荧光性质和各自的荧光特性，寻找它们与烟草香味，颈头等吃味之间的关系，选择合适的量值指标，为烟草品质的 观感官评估提供了一个实用的对照方法。     

表面分散过程的分形研究

盐类和氧化物等活性组分在一定条件下,可在高比表面载体上自发分散。研究这些过程对多相催化剂、吸附剂的制备过程理解和控制无疑是重要的。这类分散过程已被系统地研究,并提出了单层分散模型,对CuCl_2/γ-Al_2O_3、HgCl_2/活性炭等多种体系,测定了单层分散阈值。表面化学习惯上理解为就是二维的化学。早在1931年Tayor就指出表面是不均匀的,但这种不均匀性是作为对理想二维表面的修正而引入的,如TLK模型。表面科学的这些基本概念其数学基础是欧基里德几何学,其物理背景是晶体结构,不规则性就是指晶体结     

Topotactic reversible phase transition between room-temperature and a new low-temperature modification in the MCl3(THF)3 system

Both single crystals of VCl₃(THF)₃ as well as isotypic cocrystals of the composition MCl₃(THF)₃, M=Ti/V 1/3, undergo a topotactic reversible phase transition to a hitherto unknown low-temperature modification. The close relationship between this new structure and the room-temperature phase determined by Cottonet al. is discussed from the molecular and the intermolecular point of view: Both modifications are built up by conformationally very similar molecules which change their arrangement during the phase transition. Lattice energy calculations confirm that these two alternative arrangements correspond to minima of almost the same packing energy.Dedicated to Professor Dr. G. E. Herberich on the occasion of his 60th birthday.     

On the structure formation of hydrophobed particles in the boundary layer of water and octane phases

Two-dimensional aggregation of the surface modified glass beads was carried out in the boundary layer of water and octane phases. The effect of particles' hydrophobicity was investigated on the structure of forming aggregates and the growth process. The structure of the aggregates and their growth were characterized by a density function which demonstrates the change of mean particle density as a function of aggregate size. The growth yielded fractal or nonfractal structures in the investigated systems. The fractal structure of the aggregates was observed to be dependent on restructuring processes controlled by the surface properties of the beads.The experimental results are compared with earlier findings for aggregation of hydrophobic beads in the boundary layer of water and air phases.On leave from Loránd Eötvös University, Budapest, Hungary     

High-density properties of hard spheres within a modified Percus-Yevick theory: The role of thermodynamic consistency

Using an integral-equation approach based upon an approximation for the tail function, the equilibrium properties of a system of hard spheres are studied with special concern for the behavior in the region of close packing. The closure adopted is such that full, internal consistency is ensured in the thermodynamics of the model with respect to both the two zero-separation theorems as well as to the more standard virial and fluctuation routes to the equation of state. The scheme also makes use of the continuity properties of the tail function and of the cavity distribution function at contact. These properties are explictly tested in the low-density limit up to the fourth derivative. The theory generates an equilibrium branch bounded on the high-density side by a point corresponding to a packing fraction0.78, a value which closely matches Rogers' least upper bound for the densest packing of spheres. The pair structure of the fluid in the state of random close packing is also compared to the type of local order predicted by the theory at similar densities.     

Local Intrinsic Dimensionality,Entropy and Statistical Divergences

Properties of data distributions can be assessed at both global and local scales. At a highly localized scale, a fundamental measure is the local intrinsic dimensionality (LID), which assesses growth rates of the cumulative distribution function within a restricted neighborhood and characterizes properties of the geometry of a local neighborhood. In this paper, we explore the connection of LID to other well known measures for complexity assessment and comparison, namely, entropy and statistical distances or divergences. In an asymptotic context, we develop analytical new expressions for these quantities in terms of LID. This reveals the fundamental nature of LID as a building block for characterizing and comparing data distributions, opening the door to new methods for distributional analysis at a local scale.