油脂低场核磁(LF-NMR)检测参数的优化试验

适当的低场核磁共振(LF-NMR)检测条件对于保障数据的可靠性具有重要意义.该文研究了大豆油LF-NMR检测过程中仪器参数、样品温度及体积等对检测结果稳定性及重现性的影响.结果表明,将2.5mL油脂样品置于核磁试管中,并在32℃恒温10 min,采样前稳定1min,在TR =2000 ms,τ=200μs,EchoCount=5000个,NS =4次,TD=500050,SW=250 kHz参数条件下采集信号,可保证检测结果稳定可靠.研究结果可为后期应用LF-NMR技术进行油脂品质检测提供适当的检测条件参考.     

驱油用聚丙烯酰胺分子量测试的光散射研究

利用旋转流变仪分析了超高分子量部分水解聚丙烯酰胺溶液的流变性质,并根据光散射动态模式分析了其在不同浓度和不同盐离子浓度下的尺寸分布.建立了利用多角度激光光散射准确测量驱油用超高分子量聚丙烯酰胺重均分子量(Mw)、均方根回转半径()和第二位力系数值(A2)的方法.准确测量了商品化驱油用超高分子量聚丙烯酰胺FP3630S的这3个参数,分别为Mw=(1.33±0.06)×107,     

润滑油对轮胎主要成分催化裂解行为的影响

本文研究了润滑油对轮胎的重要组成原料:天然橡胶、聚丁二烯橡胶和丁苯橡胶催化裂解行为的影响.研究发现润滑油的加入明显增强了催化剂ZSM-5对聚丁二烯橡胶的催化裂解作用:液体收率从69.0％提高到83.4％,残渣收率从17.0％降至3.2％;润滑油的加入也提高了丁苯橡胶催化裂解的反应速率,液体产物中的轻油组分由67.5％增...     

液相色谱-串联质谱法测定食用植物油中的棉酚

建立了食用植物油中棉酚的液相色谱-串联质谱（LC-MS/MS）分析方法。待测物经无水乙醇涡旋振荡提取,C18色谱柱分离,以乙腈和0.1%（v/v）甲酸水溶液为流动相进行梯度洗脱,LC-MS/MS测定,外标法定量。方法的测定低限（S/N>10）为1 mg/kg;在添加浓度为1、2和200 mg/kg水平下,棉酚的加标回收率为87.4%~100%,相对标准偏差为3.9%~12.2%。结果表明,本方法灵敏度高,测定结果准确,回收率稳定,可用于食用植物油中棉酚残留的确证检测。     

对流层大气过氧自由基实地测量的技术进展及其在化学机理研究中的应用

大气过氧自由基化学是对流层大气化学的重要组成部分,对于理解大气氧化性、光化学臭氧和二次有机气溶胶生成等核心科学问题具有重要意义。基于实地测量,准确掌握大气过氧自由基的浓度水平、进行相关化学行为分析以及实测结果模拟分析一直是大气过氧自由基化学研究的重点和难点。本文总结了大气过氧自由基实地测量的技术方法,回顾了涉及大气过氧自由基的大型实地观测实验,分析了已有观测实验中大气过氧自由基的浓度水平和差异,归纳了实地测量数据在化学机理研究中的应用,讨论了模拟分析实地测量结果中的主要科学发现。最后,提出该领域中尚存在的问题及可能的重点研究方向。     

Large Zero‐Field Splittings of the Ground Spin State Arising from Antisymmetric Exchange Effects in Heterometallic Triangles

[Ru₂Mn(O)(O₂CtBu)₆(py)₃] has an S=⁵/₂ ground state with a very large zero‐field splitting (ZFS) of D=2.9 cm^?1, as characterized by EPR spectroscopy at 4–330 GHz. This is far too large to be due to the Mn^II ion (D <0.2 cm^?1), as shown from the {Fe₂Mn} analogue, but can be modeled by antisymmetric exchange effects.     

Effects of Oil on Aqueous Foams: Electrical Conductivity of Foamed Emulsions

Three‐phase foams containing dispersed oils (also called foamed emulsion) are usually encountered in such areas as enhanced oil recovery, food foams, and in foams containing antifoams. The presence of oil causes these complex fluids to exhibit extraordinary properties in contrast to aqueous foams. We experimentally investigated, for the first time, the conductive properties of the foamed emulsions and found that the electrical conductivity increases monotonically with the volumetric liquid fraction, presenting a linear relationship. Combined with the analysis on the foaming capacity and microstructure of this complex fluid, the conductive mechanism is revealed. In these foamed emulsions, the whole conductive network is comprised of two levels of structural hierarchy, which displays a different mechanism from those of the conventional aqueous foams. The lamella of emulsions is taken as primary electrical channel, whereas the secondary electrical channel occurs in the lamella between two bubbles. This conductive behaviour is attributed to the microstructure properties of the foamed emulsions. We believe that such findings are potentially important for a better understanding of the fundamentals of these tri‐phase dispersion systems.     

Cs的覆盖度对Cs/石墨烯的结构稳定性和场发射性能影响

采用密度泛函理论方法,对Cs以不同覆盖度吸附在石墨烯表面时系统的结构稳定性和场发射性能进行了研究。计算结果表明单原子Cs吸附在石墨烯表面的碳六元环的中心位置时系统的能量最低。随着Cs的覆盖度增加,碱金属Cs与石墨烯之间的吸附作用逐渐增强,(4×4)R 0°和(2×2)R 0°结构是稳定的。由于碱金属Cs的修饰作用,Cs/石墨烯体系的功函明显下降,且随着碱金属Cs的覆盖度增大,系统的功函逐渐减小。态密度的计算结果表明功函的下降主要与Cs和石墨烯之间的电子转移有关。随着覆盖度的增大,石墨烯的电子态逐渐向低能方向移动,系统的费米能级升高并导致材料的功函下降。     

低场核磁共振结合化学计量学方法快速检测掺假核桃油

以掺假核桃油样品为低场核磁共振检测对象,利用主成分分析法(PCA)和偏最小二乘回归法(PLSR)分析处理Carr-Purcell-Meiboom-Gill(CPMG)序列的核磁共振弛豫数据,旨在探求一种能快速检测核桃油品质的新方法。对几种常见掺假形式(掺入大豆油、玉米油、葵花油)的核桃油样品和纯核桃油样品进行检测和评价。实验结果表明:纯核桃油和掺入不同种类食用油的掺假核桃油在主成分得分图上可以得到很好的区分,且掺假样品随掺假比例在图中呈规律性分布;采用PLSR法对CPMG数据和实际掺假率进行回归,可实现对核桃油掺假水平的准确定量测定。方法快速、无损、准确,在食用油制品的品质控制及评价方面具有很大的应用潜力。     

Electrospray ionization mass spectrometry and partial least squares discriminant analysis applied to the quality control of olive oil

Direct infusion electrospray ionization mass spectrometry in the positive ion mode [ESI(+)‐MS] is used to obtain fingerprints of aqueous–methanolic extracts of two types of olive oils, extra virgin (EV) and ordinary (OR), as well as of samples of EV olive oil adulterated by the addition of OR olive oil and other edible oils: corn (CO), sunflower (SF), soybean (SO) and canola (CA). The MS data is treated by the partial least squares discriminant analysis (PLS‐DA) protocol aiming at discriminating the above‐mentioned classes formed by the genuine olive oils, EV (1) and OR (2), as well as the EV adulterated samples, i.e. EV/SO (3), EV/CO (4), EV/SF (5), EV/CA (6) and EV/OR (7). The PLS‐DA model employed is built with 190 and 70 samples for the training and test sets, respectively. For all classes (1–7), EV and OR olive oils as well as the adulterated samples (in a proportion varying from 0.5 to 20.0% w/w) are properly classified. The developed methodology required no ions identification and demonstrated to be fast, as each measurement lasted about 3 min including the extraction step and MS analysis, and reliable, because high sensitivities (rate of true positives) and specificities (rate of true negatives) were achieved. Finally, it can be envisaged that this approach has potential to be applied in quality control of EV olive oils. Copyright © 2013 John Wiley & Sons, Ltd.