Nanoporous TiO2 Coatings for Infrared Detectors

In GaAs based infrared detectors, a considerable part of the incident light will be reflected at the surface, thus it decreases the detectors sensitivity considerably. In this paper, a TiO₂ nanoporous coating was prepared successfully on the GaAs substrate by sol-gel method. The optical parameters of the coating were also controlled successfully. It was proved that the coating could greatly improve the transmittance of the incident light, which agrees with the theoretical results quite well. In the 2.5–6.0 m waveband, the maximum transmittance of GaAs substrate is 56%, while the transmittance of the GaAs substrate coated with a nanostructured TiO₂ coating is about 94%.     

Complexation of Some Amino Acids and Peptides by p-Sulfonatocalix[4]arene and Hexasodium p-Sulfonatocalix[6]arene in Aqueous Solution

The stability constants (log K), the reaction enthalpy( H) and entropy ( S) of the complexesformed between some amino acids (glycine, L-alanine,L-valine, L-leucine, L-phenylalanine, L-tryptophan,L-threonine, and L-lysine) and peptides (glycyl-glycine,glycyl-L-alanine, glycyl-L-leucine, glycyl-L-phenylalanine,L-leucyl-glycine, L-leucyl-L-alanine, glycyl-L-valine,L-leucyl-glycyl-glycine, and glycyl-glycyl-glycine) withp-sulfonatocalix[4]arene and hexasodiump-sulfonatocalix[6]arene in aqueous solutions by meansof calorimetric titration have been investigated. The reportedresults demonstrate that the amino acids and peptides under studyform complexes with both p-sulfonatocalix[4]areneand hexasodium p-sulfonatocalix[6]arene. In the case of theamino acids and peptides the complexation with water-solublecalixarenes in aqueous solution is favored by enthalpiccontributions and disfavored by entropic contributions. However,no influence of the ring size of the calixarenes upon thecomplexation is observed. By comparison with the reaction ofthe sodium salt of phenol-4-sulfonic acid with amino acids amacrocyclic effect in case of the calixarenes is possible.     

超声提取-超高效液相串联质谱分析沉积物中15种抗生素

在现有方法基础上对沉积物中磺胺类、喹诺酮类、大环内脂类和四环素类抗生素的提取、富集、净化以及仪器分析方法进行了优化。以EDTA-Mcllvaine缓冲溶液与乙腈(V:V,1:1)混合液作为提取液,利用超声波细胞破碎仪进行超声提取,串联强阴离子交换柱(SAX)和HLB固相萃取柱进行固相萃取(SPE),通过超高效液相/串联质谱(UPLC-MS/MS)测定沉积物中抗生素的含量。抗生素基质加标回收率在56.4%~110%,相对标准偏差为1.1%~24.3%,方法检出限0.0055~0.716 ng/g。本方法有效地提高了沉积物中抗生素的提取效率,并应用于实际样品的测定中。     

单相Ba2Ti9O20柠檬酸凝胶法制备、表征及介电性能

采用柠檬酸凝胶法两步热处理工艺制备了单相Ba₂Ti₉O₂₀。干凝胶在750 ℃热处理得到了物相为BaTi₅O₁₁和Ba₄Ti₁₃O₃₀、尺寸为30～50 nm的前驱体粉体。纳米前驱体具有高表面活性，促使单相Ba₂Ti₉O₂₀在1 200 ℃热处理温度下形成。两步热处理所得的粉体比一步热处理所得的粉体具有更好的烧结和介电特性，两步热处理所得的粉体，在1 250 ℃烧结4 h，可获得理论密度为97%的Ba₂Ti₉O₂₀微波介质陶瓷，其介电性能：ε_r=38.5，Qf=19 320 GHz，τ_f=8.7×10^-6 ℃^-1。     

配合物Zn(Phe)(NO3)2·H2O(s)的低温热容和标准摩尔生成焓

利用精密自动绝热热量计直接测定了配合物Zn(Phe)(NO3)2·H2O(s) (Phe:苯丙氨酸)在78-370 K温区的摩尔热容. 通过热容曲线的解析得到该配合物的起始脱水温度为, T0=(324.27±0.37) K. 将该温区的摩尔热容实验值用最小二乘法拟合得到摩尔热容(Cp, m)对温度(T)的多项式方程, 并且在此基础上计算出了它的舒平热容值和各种热力学函数值. 依据Hess定律, 通过设计热化学循环, 选择体积为100 mL浓度为2 mol·L-1 的盐酸作为量热溶剂, 利用等温环境溶解-反应热量计分别测定混合物{ZnSO4·7H2O(s)+2NaNO3(s)+L-Phe(s)}和{Zn(Phe)(NO3)2·H2O(s)+Na2SO4(s)}的溶解焓为, ⊿dH0m,1 =(69.42±0.05) kJ·mol-1, ⊿dH0 m,2 =(48.14±0.04) kJ·mol-1, 进而计算出该配合物的标准摩尔生成焓为, ⊿fH0m =-(1363.10±3.52) kJ·mol-1. 另外, 利用紫外-可见(UV-Vis)光谱和折光指数(refractiveindex)的测量结果检验了所设计的热化学循环的可靠性.     

Thermally reversible light scattering films based on the melting/crystallization of organic crystals dispersed in an epoxy matrix

Films that can be reversibly switched from opaque to transparent states by varying temperature (TRLS films), have potential applications in thermal sensors, optical devices, recording media, etc. A dispersion of organic crystals in a thermoset may be used for these purposes provided that at temperatures higher than the melting point there is a matching of refractive indices of both phases. A model system consisting on a dispersion of diphenyl (DP) crystals in an epoxy matrix based on diglycidyl ether of bisphenol A and m-xylylenediamine, was analyzed as a possible TRLS film encapsulated between transparent covers to avoid sublimation of DP. To obtain a uniform dispersion of DP-rich domains in the epoxy matrix by polymerization-induced phase separation, it was necessary to add 5 wt% of polystyrene (PS) to the initial formulation. Phase separation induced by polymerization at 80 °C led to a dispersion of PS/DP domains in the epoxy matrix due to the low compatibility of PS with the epoxy and its high compatibility with DP. Crystallization and melting processes were confined to the interior of dispersed domains leading to an excellent reproducibility of the optical properties of TRLS films in the course of successive heating-cooling cycles.     

Dynamic Study of Gemini Surfactant and Single-chain Surfactant at Air／Water Interface

Molecular dynamics (MD) simulation are used to study the properties of gemini surfactant of ethyl-α,ω-bis(dodecyldimethylammonium bromide) (C12C2C12) and dodecyl-trimethylammonium bromide (DTAB) at the air/water interface, respectively. In the two systems,t he surfactant concentrations are both 28 wt.%, and other conditions are also the same. After reaching the thermodynamic equilibrium, the concentration profiles, the radial distributions functions (RDF) and the mean squared displacement (MSD) are investigated. The results reveal that the surface activity of C12C2C12 surfactant is higher than DTAB surfactant.     

丙醇-氯化钠双水相体系萃取分离铂、钯、铑、金中的铱及其吸收光谱分析研究

提出了一种丙醇－氯化钠双水相体系萃取铱的分离－吸收光谱分析方法，在HCl介质中基于铱生成三氯亚锡酸络阴离子动力学速率与铂、钯、铑、金差异使铱与铂、钯、铑、金分离，其后在KI介质中萃取铱使其与贱金属基体分离，研究了在丙醇萃取相中铱的吸收光谱分析，并应用于实际样品中铱的测定。     

水溶性含C_(60)聚电解质的制备及其与重氮树脂自组装膜AFMFFM的初步研究

通过BPO引发的溶液聚合 ,合成了水溶性的星状C6 0 苯乙烯 苯乙烯磺酸钠的三元共聚物 [Star shapedC6 0 poly(St SS) ],运用自组装技术 ,在水溶液中 ,含C6 0 的三元共聚物与重氮树脂 (Diazoresin)通过正负离子间的吸附力在云母基片上交替一层一层有序地组装成固体膜 .自组装膜经紫外光幅照反应 ,通过重氮基的分解 ,层间连接的离子键转变成共价键 ,从而增加薄膜的稳定性和堆砌密度 .用原子力显微镜 摩擦力显微镜(AFM FFM)考察了C6 0 在膜中的承载作用及比较不同链结构、不同链长、不同层数自组装膜的表面形貌和微摩擦性能 .初步的研究结果显示了聚合物薄膜的微摩擦性能与聚合物的化学结构、链长和膜的层数有密切关系