High performance Zn–Sn–O thin film transistors with Cu source/drain electrode

Zn–Sn–O (ZTO) thin film transistors (TFTs) were fabricated with a Cu source/drain electrode. Although a reasonably high mobility (μ_FE) of 13.2 cm²/Vs was obtained for the ZTO TFTs, the subthreshold gate swing (SS) and threshold voltage (V_th) of 1.1 V/decade and 9.1 V, respectively, were inferior. However, ZTO TFTs with Ta film inserted as a diffusion barrier, exhibited improved SS and V_th values of 0.48 V/decade and 3.0 V, respectively as well as a high μ_FE value of 18.7 cm²/Vs. The improvement in the Ta‐inserted device was attributed to the suppression of Cu lateral diffusion into the ZTO channel region. (© 2013 WILEY‐VCH Verlag GmbH & Co. KGaA, Weinheim)     

Preferential etching of ion bombarded GaAs

Abrupt changes in the near-band-edge luminescence of n-type undoped GaAs after implantation with 400 keV Zn ions and vacuum annealing at 580°C are reported. The good agreement of the spectral position, half-width and temperature dependence of the emission obtained after implantation and annealing with that of melt-doped GaAs: Zn indicates that implanted Zn ions have been incorporated at Ga lattice sites. The larger number of Zn substitutions obtained when bombardment is made on the Ga face than for an equivalent fluence on the As face demonstrates the existence of a polar implant effect.     

Many-body braiding phases in a rotating strongly correlated photon gas

We present a theoretical study of fractional quantum Hall physics in a rotating gas of strongly interacting photons in a single cavity with a large optical nonlinearity. Photons are injected into the cavity by a Laguerre–Gauss laser beam with a non-zero orbital angular momentum. The Laughlin-like few-photon eigenstates appear as sharp resonances in the transmission spectra. Using additional localized repulsive potentials, quasi-holes can be created in the photon gas and then braided around in space: an unambiguous signature of the many-body Berry phase under exchange of two quasi-holes is observed as a spectral shift of the corresponding transmission resonance.     

Numerical study of influence of molecular diffusion in the Mild combustion regime

In this paper, the importance of molecular diffusion versus turbulent transport in the moderate or intense low-oxygen dilution (Mild) combustion mode has been numerically studied. The experimental conditions of Dally et al. [Proc. Combust. Inst. 29 (2002) 1147–1154] were used for modelling. The EDC model was used to describe the turbulence–chemistry interaction. The DRM-22 reduced mechanism and the GRI 2.11 full mechanism were used to represent the chemical reactions of an H₂/methane jet flame. The importance of molecular diffusion for various O₂ levels, jet Reynolds numbers and H₂ fuel contents was investigated. Results show that the molecular diffusion in Mild combustion cannot be ignored in comparison with the turbulent transport. Also, the method of inclusion of molecular diffusion in combustion modelling has a considerable effect on the accuracy of numerical modelling of Mild combustion. By decreasing the jet Reynolds number, decreasing the oxygen concentration in the airflow or increasing H₂ in the fuel mixture, the influence of molecular diffusion on Mild combustion increases.     

3-D simulation of soot formation in a direct-injection diesel engine based on a comprehensive chemical mechanism and method of moments

Here, we propose both a comprehensive chemical mechanism and a reduced mechanism for a three-dimensional combustion simulation, describing the formation of polycyclic aromatic hydrocarbons (PAHs), in a direct-injection diesel engine. A soot model based on the reduced mechanism and a method of moments is also presented. The turbulent diffusion flame and PAH formation in the diesel engine were modelled using the reduced mechanism based on the detailed mechanism using a fixed wall temperature as a boundary condition. The spatial distribution of PAH concentrations and the characteristic parameters for soot formation in the engine cylinder were obtained by coupling a detailed chemical kinetic model with the three-dimensional computational fluid dynamic (CFD) model. Comparison of the simulated results with limited experimental data shows that the chemical mechanisms and soot model are realistic and correctly describe the basic physics of diesel combustion but require further development to improve their accuracy.     

Analytical predictions of shapes of laminar diffusion flames in microgravity and earth gravity

Flame shape is an important observed characteristic of flames that can be used to scale flame properties such as heat release rates and radiation. Flame shape is affected by fuel type, oxygen levels in the oxidiser, inverse burning and gravity. The objective of this study is to understand the effect of high oxygen concentrations, inverse burning, and gravity on the predictions of flame shapes. Flame shapes are obtained from recent analytical models and compared with experimental data for a number of inverse and normal ethane flame configurations with varying oxygen concentrations in the oxidiser and under earth gravity and microgravity conditions. The Roper flame shape model was extended to predict the complete flame shapes of laminar gas jet normal and inverse diffusion flames on round burners. The Spalding model was extended to inverse diffusion flames. The results show that the extended Roper model results in reasonable predictions for all microgravity and earth gravity flames except for enhanced oxygen normal diffusion flames under earth gravity conditions. The results also show trends towards cooler flames in microgravity that are in line with past experimental observations. Some key characteristics of the predicted flame shapes and parameters needed to describe the flame shape using the extended Roper model are discussed.     

Effect of Pt on interdiffusion and mechanical properties of the γ and γ′ phases in the Ni–Pt–Al system

The effect of Pt on the growth kinetics of the γ′-[Ni(Pt)]₃Al ordered intermetallic phase and the γ-Ni(Pt, Al) solid solution diffusion rates of the species, hardness and elastic modulus was examined by employing the diffusion couple experimental technique. Experiments were conducted by using the β-Ni(Pt)Al phase and Ni(Pt) alloy couples, each of which had a fixed amount of Pt (5, 10 and 15 at. %) in both the end members so that the Pt content is more or less constant throughout the interdiffusion zone. The results suggest that the growth kinetics of both phases and the average effective interdiffusion coefficients of Ni and Al increase with the increase in Pt content. Nanoindentation studies across the compositional gradients show that the mechanical properties of the intermetallic phase in the superalloy are relatively insensitive to the presence of Pt but are more sensitive to the Ni/Al ratio. In contrast, the marked variation in the hardness of the γ phase were noted, increasing markedly with Al concentration in a given couple and also increasing with increasing Pt content. Possible causes for the observed variations are discussed.     

Long-range chemical interactions in solid-state reactions: effect of an inert Ag interlayer on the formation of L10-FePd in epitaxial Pd(0 0 1)/Ag(0 0 1)/Fe(0 0 1) and Fe(0 0 1)/Ag(0 0 1)/Pd(0 0 1) trilayers

The effect of 0, 0.5, and 1?μm-thick Ag interlayers on the chemical interaction between Pd and Fe in epitaxial Pd(0?0?1)/Ag(0?0?1)/Fe(0?0?1)/MgO(0?0?1) and Fe(0?0?1)/Ag(0?0?1)/Pd(0?0?1)/MgO(0?0?1) trilayers has been studied using X-ray diffraction, ⁵⁷Fe Mössbauer spectroscopy, X-ray photoelectron spectroscopy, and magnetic structural measurements. No mixing of Pd and Fe occurs via the chemically inert Ag layer at annealing temperatures up to 400?°C. As the annealing temperature is increased above 400?°C, a solid-state synthesis of an ordered L1₀-FePd phase begins in the Pd(0?0?1)/Ag(0?0?1)/Fe(0?0?1) and Fe(0?0?1)/Ag(0?0?1)/Pd(0?0?1) film trilayers regardless of the thickness of the buffer Ag layer. In all samples, annealing above 500?°C leads to the formation of a disordered Fe_xPd_1?x(0?0?1) phase; however, in samples lacking the Ag layer, the synthesis of Fe_xPd_1?x is preceded by the formation of an ordered L1₂-FePd₃ phase. An analysis of the X-ray photoelectron spectroscopy results shows that Pd is the dominant moving species in the reaction between Pd and Fe. According to the preliminary results, the 2.2?μm-thick Ag film does not prevent the synthesis of the L1₀-FePd phase and only slightly increases the phase’s initiation temperature. Data showing the ultra-fast transport of Pd atoms via thick inert Ag layers are interpreted as direct evidence of the long-range character of the chemical interaction between Pd and Fe. Thus, in the reaction state, Pd and Fe interact chemically even though the distance between them is about 10⁴ times greater than an ordinary chemical bond length.