On‐line Determination of Particle Size Distributions in Flowing Dispersions

Emulsions are of great importance to industry. They are involved in many engineering operations, including chemical reactions, extraction, emulsification and suspension polymerization, etc. However, an important problem for these processes is how to control the size distribution of the dispersed phase. Indeed, off‐line analysis of the emulsion may generate uncertainties due to sampling and dilution of the product, which are likely to change the dispersion state and physico‐chemical properties. In this work, an on‐line optical method is proposed to characterize dispersed media in real flowing conditions. This method is based on the time‐analysis of back‐scattered light fluctuations. The present paper deals with the development of this method and its application to dispersions of alumina in water. The results obtained with the on‐line optical method are compared with those acquired by classical laser light scattering and microscopy.     

超稳Y沸石制备技术对沸石铝分布的影响 Ⅱ.均匀铝分布的超稳Y沸石的制备

对水热处理后得到的USY沸石作进一步的酸处理以及采用改进的氟硅酸盐溶液骨架富硅工艺,分别得到了经XPS剖面分析证实为铝分布均匀的超稳Y沸石HAY-Ⅰ和HAY-Ⅱ。IR分析表明,在酸处理过程中从USY沸石中去掉的那部分非骨架铝类与3690cm~(-1)处羟基有关,仍残留在HAY-Ⅰ沸石中的那部分非骨架铝类与3670cm~(-1)和3600cm~(-1)处羟基有关。XRD和化学分析表明HAY-Ⅰ沸石仍含有约50％的非骨架铝类,而HAY-Ⅱ沸石则基本上不含非骨架铝类,HAY-Ⅱ沸石还显示更高的结晶保留度。DTA分析表明,HAY-Ⅰ和HAY-Ⅱ两种沸石的热稳定性均高于USY沸石。     

Gelation of poly(n-butylisocyanate) in benzene

Poly (n-butylisocyanate)-benzene solutions prepared by solubilization at 45°C, followed by aging at room temperature were found to be metastable for months, although, eventually, they separated into a birefringent polymer-rich phase and an isotropic solution. These metastable solutions, as well as isothermally phase-separated biphasic samples, flowed and exhibited dynamic moduli indicative of low polymer connectivity. By contrast samples prepared by a freeze-thaw cycle were uniformly and highly birefringent and showed network (gel) behavior at room temperature. The mechanism of gel formation is most likely the exclusion of the polymer from the benzene crystal during crystallization, forcing the polymer to align and exist at grain boundaries. Films formed from solutions have different moduli than those formed from gels, and are consistent with the proposed mechanism.     

Kinetic features of ethylene polymerization over supported catalysts [2,6‐bis(imino)pyridyl iron dichloride/magnesium dichloride] with AlR3 as an activator

The effects of polymerization temperature, polymerization time, ethylene and hydrogen concentration, and effect of comonomers (hexene‐1, propylene) on the activity of supported catalyst of composition LFeCl₂/MgCl₂‐Al(i‐Bu)₃ (L = 2,6‐bis[1‐(2,6‐dimethylphenylimino)ethyl] pyridyl) and polymer characteristics (molecular weight (MW), molecular‐weight distribution (MWD), molecular structure) have been studied. Effective activation energy of ethylene polymerization over LFeCl₂/MgCl₂‐Al(i‐Bu)₃ has a value typical of supported Ziegler–Natta catalysts (11.9 kcal/mol). The polymerization reaction is of the first order with respect to monomer at the ethylene concentration >0.2 mol/L. Addition of small amounts of hydrogen (9–17%) significantly increases the activity; however, further increase in hydrogen concentration decreases the activity. The IRS and DSC analysis of PE indicates that catalyst LFeCl₂/MgCl₂‐Al(i‐Bu)₃ has a very low copolymerizing ability toward propylene and hexene‐1. MW and MWD of PE produced over these catalysts depend on the polymerization time, ethylene and hexene‐1 concentration. The activation effect of hydrogen and other kinetic features of ethylene polymerization over supported catalysts based on the Fe (II) complexes are discussed. © 2007 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 45: 5057–5066, 2007     

Quantitative theory of living free‐radical polymerization. III. Calculation of copolymerization products' spinodal

The problem of finding conditions of the loss of thermodynamic stability by the reaction system was solved on the basis of the developed theory of living free‐radical copolymerization. The spinodal's calculations were carried out for a significant number of systems differing in the values of kinetic, stoichiometric, and thermodynamic parameters. Analysis of the results of such calculations revealed some regularities in the spinodal curves' behavior and permitted us to classify their possible topological types. © 2003 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 41: 892–902, 2003     

Insight into chain dimensions in PEO/water solutions

Small‐Angle Neutron Scattering has been performed from poly(ethylene oxide) in deuterated water at temperature ranging from 10 to 80 °C. A simple fitting model was used to obtain a correlation length and a Porod exponent. The correlation length L characterizes the average distance between entanglements in the semidilute region and is proportional to the individual coil sizes in the dilute region. L was found to increase with temperature in the semidilute region but it decreases with temperature in the dilute region. This decrease is the precursor to the single‐chain collapse which applies to very dilute polymer solutions. © 2007 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 45: 2196–2200, 2007     

Graphitic nanofillers in PMMA nanocomposites—An investigation of particle size and dispersion and their influence on nanocomposite properties

Mechanical, thermal, and electrical properties of graphite/PMMA composites have been evaluated as functions of particle size and dispersion of the graphitic nanofiller components via the use of three different graphitic nanofillers: “as received graphite” (ARG), “expanded graphite,” (EG) and “graphite nanoplatelets” (GNPs) EG, a graphitic materials with much lower density than ARG, was prepared from ARG flakes via an acid intercalation and thermal expansion. Subsequent sonication of EG in a liquid yielded GNPs as thin stacks of graphitic platelets with thicknesses of ～10 nm. Solution‐based processing was used to prepare PMMA composites with these three fillers. Dynamic mechanical analysis, thermal analysis, and electrical impedance measurements were carried out on the resulting composites, demonstrating that reduced particle size, high surface area, and increased surface roughness can significantly alter the graphite/polymer interface and enhance the mechanical, thermal, and electrical properties of the polymer matrix. © 2007 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 45: 2097–2112, 2007     

Solvothermal synthesis of TiO2: anatase nanocrystals and rutile nanofibres from TiCl4 in acetone

This work reports a new synthetic approach for single‐phase TiO₂ nanomaterials by solvothermal treatment of titanium tetrachloride in acetone at 80–110 °C. Small, uniform, and yet size‐tunable (5–10 nm) anatase titania nanocrystallites were obtained using a low concentration of TiCl₄ in acetone (i.e., at molar ratios of TiCl₄/acetone ≤ 1:15) in the temperature range of 80–110 °C, while rutile nanofibers were synthesized using a high concentration of TiCl₄ (e.g., TiCl₄/acetone = 1:10) at 110 °C. Copyright © 2007 John Wiley & Sons, Ltd.     

On disjoint configurations in infinite graphs

For a graph A and a positive integer n, let nA denote the union of n disjoint copies of A; similarly, the union of ?₀ disjoint copies of A is referred to as ?₀A. It is shown that there exist (connected) graphs A and G such that nA is a minor of G for all n??, but ?₀A is not a minor of G. This supplements previous examples showing that analogous statements are true if, instead of minors, isomorphic embeddings or topological minors are considered. The construction of A and G is based on the fact that there exist (infinite) graphs G₁, G₂,… such that G_i is not a minor of G_j for all i ≠ j. In contrast to previous examples concerning isomorphic embeddings and topological minors, the graphs A and G presented here are not locally finite. The following conjecture is suggested: for each locally finite connected graph A and each graph G, if nA is a minor of G for all n ? ?, then ?₀A is a minor of G, too. If true, this would be a far‐reaching generalization of a classical result of R. Halin on families of disjoint one‐way infinite paths in graphs. © 2002 Wiley Periodicals, Inc. J Graph Theory 39: 222–229, 2002; DOI 10.1002/jgt.10016