Voltammetric, chronocoulometric and spectroelectrochemical studies of electropolymerized films based on Co(III/II)- and Zn(II)-4,9,16,23-tetraaminophthalocyanine: effect of high pH

Electropolymerized thin films of Co(III/II)- and Zn(II)-4,9,16,23-tetraaminophthalocyanine, immersed in solutions of relatively high pH, have been studied electro- and spectroelectrochemically. Cyclic voltammetry and chronocoulometry were used to characterize films deposited on glassy carbon electrodes. Spectroelectrochemistry and ellipsometry measurements were performed on indium tin oxide (ITO) surfaces coated with the zinc and cobalt complexes and correlated to the electrochemical information collected using glassy carbon electrodes. Studies at high pH are motivated by the efficient increase in luminol chemiluminescence at high OH⁻ concentration, and by potential application in luminescence sensors. Although the films are not removed, some structural changes occur when they are exposed to solutions of high pH. In addition, an estimation of the number of monolayers has also been calculated. The atomic diameters of cobalt and zinc are very close in value, but the estimated number of monolayers, based on cyclic voltammetric data, for a given number of electropolymerization cycles is approximately four-fold higher in the zinc-based film. This would correspond to three-fold thicker films when zinc is the central metal ion. Ellipsometry measurements have been correlated with cyclic voltammetric data to confirm that film thickness varies among the different complexes, even though the conditions of electropolymerization are the same.     

The simultaneous saccharification and fermentation of pretreated woody crops to ethanol

Four promising woody crops (Populusmaximowiczii x nigra (NE388), P.trichocarpa x deltoides (Nll), P.tremuloides, and SweetgumLiquidambar styraciflua) were pretreated by dilute sulfuric acid and evaluated in the simultaneous saccharification and fermentation (SSF) process for ethanol production. The yeastSaccharomyces cerevisiae was used in the fermentations alone, and in mixed cultures with β -glucosidase producingBrettanomyces dausenii. Commercial Genencor 150L cellulase enyme was either employed alone or supplemented with β- glucosidase. All SSFs were run at 37 …C for 8 d and compared to saccharifications at 45…C under the same enzyme loadings.S. cerevisiae alone achieved the highest ethanol yields and rates of hydrolysis at the higher enzyme loadings, whereas the mixed culture performed better at the lower enzyme loadings without β -glucosidase supplementation. The best overall rates of fermentation (3 d) and final theoretical ethanol yields (86–90%) were achieved with P.maximowiczii x nigra (NE388) and SweetgumLiquidambar styraciflua, followed by P.tremuloides and P.trichocarpa xdeltoides (N1l) with slightly slower rates and lower yields. Although there were some differences in SSF performance, all these pretreated woody crops show promise as substrates for ethanol production.     

The number of kekulé structures for rectangle-shaped benzenoids,part VIII: Some perforated rectangles

Summary Classes of coronoids (or degenerate coronoids), r and q are obtained by providing the rectangle-shaped benzenoids R^j (m, 3) with a naphthalenic or pyrenic hole, respectively. The numbers of Kekulé structures (K) are studied. It was found for theK numbers of the classes in question:r=4/5R andq=1/5R. The classes r and q are similar to r and q, respectively, but the naphthalenic or pyrenic hole is oriented in a different way. For these classes it was found:r=3/5R,q=2/5R.

---

Die Anzahl von Kekulé-Strukturen für hochkondensierte Benzenoide mit rechteckigem Umriß, 8. Mitt.: Einige perforierte benzenoide Rechteck-Strukturen

Zusammenfassung Es werden Klassen r und q von Coronoiden (oder degenerierten Coronoiden) erhalten, wobei Benzenoide mit rechteckigem Umriß, R^j(m, 3), mit einem Naphthalin- oder Pyren-Loch versehen werden. Die Anzahl von Kekulé-Strukturen (K) wird untersucht; dabei wurde für die untersuchten Klassenr=4/5R undq=1/5R gefunden. Die Klassen r und q verhalten sich ähnlich, das Naphthalin- oder Pyren-Loch ist jedoch anders orientiert; dafür wurder=3/5R undq=2/5R gefunden.

     

DEHYDROGENATION AND AROMATIZATION OF METHANE IN THE ABSENCE OF OXYGEN OVER DOPED Mo/HZSM-5 CATALYSTS

研究了在Ｍｏ／ＨＺＳＭ－５催化剂上添加助剂以及不同的反应预处理温度对甲烷无氧脱氢芳构化反应的影响。实验结果表明，由于第二组分的添加，Ｍｏ／ＨＺＳＭ－５催化剂的活性和选择性都得到了较大程度的改善。预处理温度是影响催化剂反应性能的关键因素。Ｍｏ－Ｒｕ／ＨＺＳＭ－５催化剂经过８７３Ｋ空气预处理后，甲烷在９７３Ｋ的转化率约为１０％，催化剂的稳定性也得到较大程度的提高。ＴＰＳＲ实验结果表明，Ｒｕ的加入降低了芳烃生成的温度。ＴＰＯ和ＤＴＡ实验结果表明，在Ｍｏ－Ｒｕ／ＨＺＳＭ－５催化剂上可生成较多的碳物种，结合反应结果，可以认为反应过程中生成的碳物种对甲烷的无氧脱氢芳构化反应是起积极作用的     

Structural evolution of calcium-exchanged (NH4)2SiF6-dealuminated Y zeolite after various chemical treatments

The structural evolution of Y zeolite (Si/Al 2.17) weakly dealuminated by hexafluorosilicate (Si/Al 3.13), denoted Y_D, and exchanged with calcium (CaY_D), has been studied after acid–base treatments at 80 °C close to the cation exchange conditions. The stability of the samples was followed by X-ray diffraction and solid-state NMR of ²⁹Si and ²⁷Al; Y_D zeolite was completely destroyed by treatment with acid pH 2.5 and suffered serious degradation on treatment with alkali at pH 11.8. The introduction of calcium improved the stability of the zeolite in acid and base. In acid CaY_D was not destroyed until pH 1. At pH 2, silicon and aluminium were extracted and an amorphous phase was formed. Base treatment at pH 13 did not affect the calcium-exchanged zeolite.     

Sr3(BS3)2 und Sr3(B3S6)2: Zwei neue nicht‐oxidische Chalkogenoborate mit trigonal‐planar koordiniertem Bor

Sr₃(BS₃)₂ and Sr₃(B₃S₆)₂: Two Novel Non‐oxidic Chalcogenoborates with Boron in a Trigonal‐Planar Coordination The thioborates Sr₃(BS₃)₂ and Sr₃(B₃S₆)₂ were prepared from strontium sulfide, amorphous boron and sulfur in solid state reactions at a temperature of 1123 K. In a systematic study on the structural cation influence on this type of ternary compounds, the crystal structures were determined by single crystal X‐ray diffraction. Sr₃(BS₃)₂ crystallizes in the monoclinic spacegroup C2/c (No. 15) with a = 10.187(4) Å, b = 6.610(2) Å, c = 15.411(7) Å, β = 102.24(3)° and Z = 4. The crystal structure of Sr₃(B₃S₆)₂ is trigonal, spacegroup R3¯ (Nr. 148), with a = 8.605(1) Å, c = 21.542(4) Å and Z = 3. Sr₃(BS₃)₂ contains isolated [BS₃]^3— anions with boron in a trigonal‐planar coordination. The strontium cations are found between the layers of orthothioborate anions. Sr₃(B₃S₆)₂ consists of cyclic [B₃S₆]^3— anions and strontium cations, respectively.     

Combinatorial Synthesis and Multidimensional NMR Spectroscopy: An Approach to Understanding Protein–Ligand Interactions

Combinatorial chemistry is a laboratory emulation of natural recombination and selection processes. Strategies in this developing discipline involve the generation of diverse, molecular libraries through combinatorial synthesis and the selection of compounds that possess a desired property. Such approaches can facilitate the identification of ligands that bind to biological receptors, promoting our chemical understanding of cellular processes. This article illustrates that the coupling of combinatorial synthesis, multidimensional NMR spectroscopy, and biochemical methods has enhanced our understanding of a protein receptor used commonly in signal transduction, the Src Homology 3 (SH3) domain. This novel approach to studying molecular recognition has revealed a set of rules that govern SH3–ligand interactions, allowing models of receptor–ligand complexes to be constructed with only a knowledge of the polypeptide sequences. Combining combinatorial synthesis with structural methods provides a powerful new approach to understanding how proteins bind their ligands in general.     

Synthesis and characterisation of bis(pentafluorophenyl)antimony(V) cations, [(C6F5)2SbL3]

Pentacoordinate complex cations of the general formula [(C₆F₅)₂SbL₃]³⁺ stabilized as solid salts in combination with tetraphenylborate (BPh₄), tetrafluorobroate (BF₄) anions, where L=DMSO, Ph₃AsO, PyO, DMF, α-, β- and γ-picoline have been isolated. The newly formed complexes were characterized by elemental analysis, molar conductance measurements, solid-state IR and and NMR. From these results, a five-fold coordination around antimony was required.     

Artificial model for cystathionine β-synthase: efficient β-replacement reaction with thiols employing a novel pyridoxal model compound having an imidazole function

As a second-generation pyridoxal model compound for cystathionine β-synthase, we designed a novel model compound having an ionophore function and an imidazole function, application of which to the β-replacement reaction with various thiols smoothly took place to give S-substituted cysteines. Peptides having a serine-O-carbonate residue at the N-terminal position were also converted to the corresponding peptides having an S-substituted cysteine residue under the catalytic conditions of the novel pyridoxal model compound.     

Photoreaction of 2′-chloro-4-R-benzanilide: synthesis of 2-(4-R-phenyl)-1,3-benzoxazole and 9-R-phenanthridin-6(5H)-one (R=H, CH3, CH3O)

The UV photolysis of 2′-chloro-4-R-benzanilides in acetonitrile solution under nitrogen atmosphere leads to the formation of intramolecular photocyclization products (9-R-phenanthridin-6(5)-one, 20–30%), along with the minor photoreduction, photo-Fries, and intramolecular photosubstitution products. The photoreaction of 2′-chloro-4-R-benzanilide in acetonitrile solution containing 10% of water or aqueous sodium hydroxide however gives 2-(4-R-phenyl)-1,3-benzoxazole as a major product (30%) along with the photoreduction, photo-Fries and intramolecular photocyclization products.