Thermal analysis study of Bi<Subscript>2</Subscript>Sr<Subscript>2</Subscript>Ca<Subscript>2</Subscript>Cu<Subscript>3-x</Subscript>Er<Subscript>x</Subscript>O<Subscript>10+δ</Subscript> glass-ceramic system

Summary We have fabricated glasses in the Bi-2223 HT_c superconductor system with Bi₂Sr₂Ca₂Cu_3-xEr_xO_{10+ δ} nominal composition, where x=0.5 and 1.0, by the glass-ceramic technique. Using an analysis developed for non-isothermal crystallization studies, information on some aspects of crystallization temperature and thermal properties has been obtained. The crystallization studies were made using DTA with several uniform rates. The calculations of crystallization activation energies, E_a, and the Avrami parameters, n, were made based on the non-isothermal kinetic theory of Kissinger and the Ozawa’s equations. The DTA data of the samples showed that the first crystallization temperature, T_x1, increases and the second crystallization temperature, T_x2, decreases by increasing the Er concentration. This suggests that the Er substitution had significant effect on the glassification of the BSCCO material due to change on the surface nucleation and increased ionic activities at high temperature region. The activation energy for crystallization, E_a, of the samples was also showed an increase at high Er concentration case. However, the Avrami parameter, n, decreased from 2.5 to 1.7 for x=0.5 and 1.0 samples, respectively. This suggests that the growth mechanism is diffusion-controlled and three-dimensional parabolic growth takes place near the first crystallization temperature. The oxidization rates and the activation barrier for oxygen out-diffusion process, E, was calculated using the TG data. It was found that the total mass gain in the x=0.5 sample is comparably smaller than that of the x=1.0 sample. This shows that the oxygen absorption of the x=1.0 sample is faster than the x=0.5 sample, leading to increase in the oxidization rate in the x=1.0 material.     

Zr(OH)4的热分解及ZrO2的相变过程

利用TG-TDG-DTA热分析技术研究了由Zr（OH）4热分解制备ZrO2的脱水过程,并结合X射线粉末衍射技术研究了ZrO2的相变过程．发现在82℃的吸热峰对应Zr（OH）4的脱水,而435℃附近出现的放热峰则为四方ZrO2向单斜ZrO2的晶相转变．采用外推法确定了Zr（OH）4脱水过程遵循三维扩散机理,其函数方程为g（α）=[{1／（1-α）}^1/3-1]^2．以实验获得的动力学参数ln A和E为基础,用最小二乘法对ln A和E进行线性拟合,得到动力学补偿效应表达式为ln A=0．437E-20．69．     

Molecular Simulation to Explore the Dissolution Behavior of Sulfur in Carbon Disulfide

Soluble sulfur (S₈) and insoluble sulfur (IS) have different application fields, and molecular dynamics simulation can reveal their differences in solubility in solvents. It is found that in the simulated carbon disulfide (CS₂) solvent, soluble sulfur in the form of clusters mainly promotes the dissolution of clusters through van der Waals interaction between solvent molecules (CS₂) and S₈, and the solubility gradually increases with the increase in temperature. However, the strong interaction between polymer chains of insoluble sulfur in the form of polymer hinders the diffusion of IS into CS₂ solvent, which is not conducive to high-temperature dissolution. The simulated solubility parameter shows that the solubility parameter of soluble sulfur is closer to that of the solvent, which is consistent with the above explanation that soluble sulfur is easy to dissolve.     

激光传输大气参量测量精度要求的数值分析

 就激光大气传输湍流热晕相互作用下大气参量测量误差对激光传输效果（平均功率密度）的影响进行了数值分析,并以典型的激光传输条件为例,分析了对激光大气传输影响最为敏感的3个大气参量——风速、吸收系数以及湍流结构常数的测量精度要求。综合不同传输距离下大气参量测量误差对传输效果的影响,大气风速的测量精度要求为±10%,吸收系数及湍流结构常数的测量精度要求分别为±5%和±15%。     

山姜素与人血清白蛋白相互作用的荧光光谱法研究

利用荧光光谱法和紫外-可见光谱法研究了山姜素与人血清白蛋白(HSA)之间的相互作用。证实了山姜素对HSA的荧光猝灭为动态猝灭过程,并测定了不同温度下的猝灭常数; 根据Fōrster非辐射能量转移理论,计算出山姜素在蛋白质中的结合位置与色氨酸残基间的距离为4.05 nm; 由求得的热力学参数,推断了山姜素与HSA之间主要靠疏水作用力结合;用三维荧光光谱及同步荧光光谱技术探讨了山姜素对HSA构象的影响。     

悬臂梁中开闭裂纹的损伤识别

利用裂纹诱导弦挠度函数,建立了悬臂Euler-Bernoulli中开闭裂纹位置、深度、初始张开角等损伤参数的识别方法。为此,首先将梁中开闭裂纹等效为单向扭转弹簧,给出了考虑裂纹缝隙效应的裂纹梁等效抗弯刚度,并得到悬臂Euler-Bernoulli开闭裂纹梁弯曲挠度的显式闭合解及裂纹诱导弦挠度函数,证明了裂纹诱导弦挠度的分段线性函数。其次,基于单向扭转弹簧的性质,建立了通过多步加载进行梁中开闭裂纹参数及其上下侧属性的识别方法。最后,通过数值算例验证了本文所建立的开闭裂纹损伤识别方法的适用性和可靠性,考察了裂纹分布位置、深度和初始张开角以及裂纹识别区间和挠度测量误差等参数对识别结果的影响,结果表明:当裂纹处于张开状态时,裂纹处裂纹诱导弦挠度斜率改变量随着施加荷载的增加而增加;当裂纹闭合时,其裂纹诱导弦挠度斜率改变量将保持为常量;裂纹损伤参数的识别误差随测量误差的增加而增加,但整体识别结果具有较高的精度,较好的鲁棒性。     

涡旋压缩机不对称双涡旋齿型线的构建与模拟

采用双涡旋齿涡旋盘结构能够有效地提高涡旋压缩机的吸气量,然而存在内容积比小、允许开设的排气口面积小的缺点。针对此问题,本文提出一种涡旋压缩机的新型不对称双涡旋齿,利用中线法得到了涡旋齿型线的设计方法,并且建立其几何模型;通过三维数值模拟研究其工作腔内部的气体流场,并与现有的双涡旋齿涡旋压缩机进行对比。结果表明:所提出的涡旋压缩机的新型不对称双涡旋齿能够有效地提高涡旋压缩机的排气量和内容积比,并且增大了排气口的开设面积,使得压缩机具有更好的工作性能。     

An Uzawa-type algorithm for the coupled Stokes equations

An Uzawa-type algorithm is designed for the coupled Stokes equations discretized by the mixed finite element method. The velocity solved by the presented algorithm is weakly divergence-free, which is different from the one solved by the common Uzawa method. Besides, an optimal relaxation parameter of the presented algorithm is provided.     

稳定分层湍流中逆梯度输运的关联分析研究

本文采用关联分析方法研究了稳定温度分层湍流中的结构特性、输运特性,以及热量、动量逆梯度输运现象的尺度效应及其参数演化.首先采用大涡模拟方法对稳定分层湍流中的结构特性和输运特性进行了分析,将逆梯度输运发生的时间尺度作为已知条件,结合关联量分析方法在波数空间中的解析解,对逆梯度输运现象的尺度效应进行了分析研究.结果发现,稳定分层强度较大的流动中发生垂向热量及动量逆梯度输运现象,发生的结构尺度与关联分析所发现垂向热量、动量逆梯度输运的波数形成了呼应.随着分层强度增加,热量、动量的输运强度均受抑制,与逆梯度输运关联的流场结构尺度减小,同样的效应也发生在流场结构向下游演化的过程中.     

基于无人机高光谱特征参数和株高估算马铃薯地上生物量

地上生物量(above-ground biomass,AGB)是评价作物长势及其产量估测的重要指标,对指导农业管理具有重要的作用.因此,快速准确地获取生物量信息,对于监测马铃薯生长状况,提高产量具有重要的意义.于马铃薯现蕾期、块茎形成期、块茎增长期、淀粉积累期、成熟期获取成像高光谱影像、实测株高(heigh,H)、地上...