磷酸盐聚酯型水性聚氨酯/纳米SiO2的合成与性能

以2-磷酸基-1,2,4-三羧酸丁烷(PBTCA)、新戊二醇(NPG)为原料,制得数均相对分子质量为1500并含有磷酸基团的聚酯多元醇。将其与异佛尔酮二异氰酸酯(IPDI)反应,经1,4-丁二醇(BDO)扩链后得到水性聚氨酯,再以KH550为偶联剂,加入纳米SiO2,合成了纳米改性的磷酸型水性聚氨酯(PWPU)。通过红外光谱(FI-IR)、热重分析(TGA)对PWPU的结构和热稳定性进行了研究,使用透射电子显微镜(TEM)对乳液的形貌进行了观察。通过TEM发现,大量粒径在110 nm左右的化合物合成,并与红外光谱联合分析得出,SiO2通过化学键与PWPU相连接。热重分析、残炭量分析和拉伸测试表明,经过纳米SiO2改性的PWPU其阻燃性、热稳定性以及力学性能均有明显的提升,具有很好的应用前景。     

热裂解气相色谱质谱法分析聚合物中红磷

采用单击热裂解(PY)模式和逸出气体分析(EGA)程序升温两种热裂解模式对红磷样品进行定性分析,利用气相色谱分离技术对红磷进行分离,根据红磷的特征质谱31,62,93,124及特征丰度比,质谱法分析不同材料中的红磷含量。单击热裂解模式下,材质和添加剂有可能对红磷造成干扰,改进后的EGA热裂解模式能排除红磷检测中材质和添加剂的干扰,并采用改进后的EGA裂解程序测定自制阳性样品中红磷的含量。结果表明:通过优化裂解温度和气相色谱条件可以有效改善红磷的分析结果,红磷质量浓度在100~500 mg/kg范围内具有良好线性,加标回收率在90.7%~97.7%,相对标准偏差(RSD)为1.6%~2.3%,定量限为81.27 mg/kg。     

硫酸分离–火试金重量法测定碲化铜中的金和银

建立了用硫酸分离-火试金重量法测定碲化铜中的金和银含量的方法。用硫酸溶解碲化铜样品,过滤,除去铜和碲,得到含金、银的沉淀物,沉淀物经灰化、配料、高温熔融制得铅扣。将铅扣灰吹,得到金银合粒,用硝酸溶解分离金,用重量法测定金含量。用金银合粒的质量扣除金粒的质量和分金液、洗液中杂质的质量即为银含量。采用灰皿、残渣熔融法补正,或用含碲、铜物料做基体加入纯金、纯银同试样方法测定,根据金、银的回收率加以补正,从而得到试样中的碲含量。实验结果表明,浓硫酸的加入量为30 mL,残余量应不少于15 mL。火试金中硅酸度为1左右,试样进炉温度以900℃为宜。该方法金、银测定结果的相对标准偏差分别为0.33%~1.97%,0.28%~1.27%(n=9)。金的回收率为98.5%~100.2%,银的回收率为95.5%~101.4%。该法满足生产控制检测和贸易结算的要求。     

火灾与撞击联合作用下钢管混凝土柱力学性能研究

为研究火灾高温与撞击联合作用下钢管混凝土柱的力学性能,基于ABAQUS建立了高温作用下考虑轴力影响的钢管混凝土柱侧向撞击有限元模型。首先,对高温与撞击联合作用下考虑轴力影响的钢管混凝土柱的破坏模式与受力全过程进行了分析,探讨了高温下钢管混凝土柱的抗撞性能与工作机理;其次,重点研究了受火时间、材料强度、含钢率以及撞击能量对抗撞性能的影响,并给出了相关设计建议。研究结果表明:高温与撞击联合作用下,钢管混凝土柱主要发生受弯破坏;受火15 min后,构件抗撞性能明显降低。轴压力对构件抗撞性能产生不利影响,轴压比从0增加到0.2,受火60 min构件抗撞性能下降了7.8%;混凝土强度对高温下钢管混凝土柱抗撞性能有显著影响,受火90 min后,混凝土强度由30 MPa增加到50 MPa,构件抗撞性能提高约85%;外钢管强度与含钢率对高温下抗撞性能影响不大。     

Influence of Carbon Nanotubes on Phase Composition,Thermal and Post-Heating Behavior of Cementitious Composites

This paper experimentally investigates the influence of carbon nanotubes (CNTs) on phase composition, microstructure deterioration, thermal behavior, and residual mechanical strengths of cementitious composites exposed to elevated temperatures. Cement mortars with small dosages of CNTs, 0.05% and 0.2% by weight of cement, were prepared and then heated at 25 °C, 150 °C, 200 °C, 450 °C, and 600 °C for two hours before being tested. The results show positive impact of the CNTs on the hydration process of cement mortar at room temperature and at higher temperatures up to 200 °C. Decomposition of the hydration products is obvious at 450 °C, whereas sever deterioration in the microstructure occurs at 600 °C. The nano reinforcement and bridging effect of the CNTs are obvious up to 450 °C. Thermal behavior characterization shows that CNTs incorporation enhances the thermal conductivity of the unheated and heat-treated mortar specimens. The decomposition of the hydration products needs more heat in the presence of CNTs. Finally, presence of CNTs significantly enhances the residual compressive and flexural strengths of heated mortar specimens for all studied temperatures.     

火试金法配料过程自动化的探索和应用

火试金法中配料方式采用的是传统的人工配料,针对人工配料方式的不足,设计了一款自动化程度较高的自动配料机,通过对配料机的准确性、效率及可靠性实验,结果表明配料机检测称量误差在±0.2 g以内,效率为人工配料的2~3倍,检测结果与人工配料的相一致。与此同时,应用此设备改善了工作环境,避免了人为失误造成的检测质量问题,降低了复检率,为企业降低了成本,提高了效益,在业内具有广泛应用前景。     

Modeling of pair distribution functions for XAFS in disordered systems

A commonly used expression for modeling the XAFS of highly disordered systems is shown to generate substantial systematic errors in the coordination number in many cases of practical interest. This expression is corrected and generalized. Further, a simpler and more flexible model distribution is proposed, and the corresponding XAFS expression is derived. Comparison with experimental and simulated data show that the new expressions are useful in cases of high disorder for which the cumulant expansion loses its utility, and they explicitly account for the k-dependence of the mean free path.     

空气 - 乙炔火焰原子吸收法连续测定铜粉中微量Fe、Pb、Sb、Zn和Ni

用HNO3-HCl溶解试样,在几个相同量的试液中,分别加入质量浓度依次递增的5种元素的标准溶液,用火焰原子吸收法连续测定了Fe、Pb、Sb、Zn和Ni的含量,建立了优化的仪器测定条件,并对可能存在的元素进行了干扰试验。结果表明,Fe、Pb、Sb等5种元素的回收率为98.0%～102.3%,相对标准偏差为1.4%～2.5%。     

火灾烟气危害性气体在狭长通道内水平方向迁移的模拟实验研究

利用狭长通道的小型实验台模拟研究了火灾烟气毒性成分在水平方向上的迁移规律.结果发现,火灾烟气危害性成分水平方向上的演变非常相似,而不同高度水平面上的烟气成分浓度有些差别,这主要是建筑结构中各种开口或者空气流动造成的.数据表明,CO等气体到达浓度峰值的时间随着高度的降低而逐渐增加.其中,O2和CO2到达峰值的时间比较一致,而CO则与前两者不一致,整体滞后80秒左右,这可能因为热烟气在传播过程又新生成了CO.     

Large eddy simulation of fire plumes

FireFOAM, a new fire modeling code based on the OpenFOAM platform (www.openfoam.org), is developed and applied to model a series of purely buoyant fire plumes with heat release rates from 14 to 58 kW. The calculations are compared with McCaffrey’s (1979) experiments. The simulation results demonstrate good quantitative agreement with experimental measurements, and show the scaling relations of mean temperature and velocity in the continuous flame, intermittent and plume regions. The numerical simulations are shown to be strictly conservative in energy. Predicted flame heights and entrainment rates also compare well with experimental correlations. The good agreements in all aspects examined show that the current CFD model performs well for small-scale fire plumes. Turbulent fluctuation intensities and PDF of mixture fraction are presented to gain more insights into the structure of fire plumes.