Synthesis and crosslinking of cyano-substituted polyamides and polyimides prepared from 1-(2,2-dicyano-1-hydroxyviyl)-3,5-diaminobenzene,sodium salt

3,5-Dinitrobenzoyl chloide was condensed with malononitrile in the presence of sodium hydroxide under phase-transfer conditions to afford 1-(2,2-dicyano-1-hydroxyvinyl)-3,5-dinitrobenzene, sodium salt, which was catalytically hydrogenated to the corresponding diamine. The latter was used as starting material for the preparation of unsaturated cyanosubstituted polyamides and polyimides. The polymers were soluble in polar aprotic solvents, dilute sodium hydroxide, and certain strong inorganic and organic acids. Upon curing at 300°C for 65 h, crosslinked polymers were obtained that were stable up to 392–404°C in N₂ or air and afforded an anaerobic char yield of 60–71% at 800°C. Their glass transition temperatures as determined by thermal mechanical analysis (TMA) were 221–275°C. © 1995 John Wiley & Sons, Inc.     

Determination of hydroxycarbamates in aqueous matrices by direct derivatization and GC-MS analysis in chemical ionization mode

A rapid and effective procedure, developed for the determination of polar compounds in water, has been applied to hydroxycarbamates. In few minutes, it is possible to perform a catalyzed derivatization of such compounds directly in the aqueous medium, using n-hexyl chloroformate. Extraction with n-hexane and injection into a benchtop GC-MS system are the only two further steps to complete the analysis. Chemical ionization proved to be more effective than electron impact to produce valuable mass spectra in terms of selectivity and sensitivity. Linear quantitative responses were demonstrated over a two-order-of-magnitude range. The minimum detectable concentration was 3 ppb for acetohydroxamic acid and 10 ppb for hydroxyurethane, obtained from Po river water samples spiked with the two hydroxycarbamate standards.     

Thermal stability and energy of deactivation of free and immobilized amyloglucosidase in the saccharification of liquefied cassava starch

Amyloglucosidase from Novo (Copenhagen, Denmark) was immobilized in controlled pore silica particles with the silane-glutaraldehyde covalent method. Thermal stability of the free and immobilized enzyme (IE) was determined with 30% (w/v) α-amylase liquefied cassava starch, pH 4.5, temperatures from 35 to 75°C. Free amyloglucosidase maintained its activity practically constant for 240 min and temperatures up to 50°C. The IE has shown higher stability retaining its activity for the same period up to 60°C. Half-life for free enzyme was 20.6, 6.44, 2.07, 0.69, and 0.24 h for 55, 60, 65, 70, and 75°C, respectively, whereas the IE at the same temperatures had half-lives of 116.4, 30.88, 8.52, 2.44, and 0.73 h. The energy of thermal deactivation was thus 50.6 and 57.6 kcal/mol, respectively for the free and IE, confirming stabilization by immobilization.     

K2O对Pt—Sn／Al2O3催化剂表面酸性及MCH脱氢稳定性的影响

利用吡啶吸附－ＩＲ，ＮＨ３吸附－脱附，原位热重积炭，ＤＳＣ等技术并结合甲基环己烷（ＭＣＨ）脱氢活性试验，研究了Ｋ２Ｏ对工业Ｐｔ－Ｓｎ／Ａｌ２Ｏ３催化剂的表面酸性及ＭＣＨ脱氢稳定性的影响，结果表明，Ｋ２Ｏ能有效地调变催化剂的表面酸性，降低其表面酸中心特别是强酸中心的数目；ＭＣＨ脱氢反应的积炭量随Ｋ２Ｏ含量的增加而减少，但催化剂的高温脱氢稳定性与Ｋ２Ｏ含量并不完全呈顺变关系，Ｋ２Ｏ含量应严格控制，当Ｋ     

高水相W／O型乳化膏体油膜稳定性的研究

高水相Ｗ／Ｏ型乳液是指水相体积占７４％以上，属于高度不稳定的分散体系［１，２］．乳化炸药的问世，使这种高水相Ｗ／Ｏ型乳液有了新的实际应用．这种炸药是９０％～９５％重的硝酸铵盐（占水相８０％～９０％重）水溶液高度分散在５％～１０％的油相中构成Ｗ／Ｏ型乳...     

A positive-working photosensitive alkaline-developable polyimide with a highly dimensional stability and low dielectric constant based on poly(amic acid) as a polyimide precursor and diazonaphthoquinone as a photosensitive compound

A positive-working photosensitive polyimide precursor based on fluorinated poly(amic acid) (FPAA) and 2,3,4-tris(1-oxo-2-diazonaphthoquinon-4-ylsulfonyloxy)benzophenone (D4SB) as a photosensitive compound has been developed. FPAA was prepared by ring-opening polyaddition of dianhydrides, pyromellitic dianhydride and biphenyltetracarboxylic dianhydride, with diamine, 2,2′-bis(trifluoromethyl)benzidine, in methanol. The FPAA film showed excellent transparency to UV light and good solubility in a wide range of organic solvents. The dissolution behavior of FPAA containing 30 wt % D4SB after exposure was studied, and it was found that the difference of dissolution rate between exposed and unexposed parts was enough to get high contrast due to the photochemical reaction of D4SB in the polymer film. The photosensitive fluorinated polyimide (FPI) precursor containing 30 wt % D4SB showed a sensitivity of 80 mJ cm⁻² and a contrast of 7.8 with 365 nm light when it was developed with 0.3% aqueous tetramethyl ammonium hydroxide solution at room temperature. The FPI film cured up to 360°C had a low coefficient of thermal expansion of 10.3 ppm °C⁻¹ and a low dielectric constant of 3.04. © 1998 John Wiley & Sons, Inc. J. Polym. Sci. A Polym. Chem. 36: 2261–2267, 1998     

不同添加物和制备方式对Al2O3热稳定性的影响

通过水溶液成胶和丙三醇络事助成胶制备了不同的结构的γ－Ａｌ２Ｏ３,研究了Ｌａ,Ｓｉ,Ｂａ以及Ｌａ,Ｓｉ和Ｌａ,Ｂａ双组分改性对它们结构热稳定的作用,讨论了改性元素的引入方式及硅铝比的影响。结果表明,丙三醇络合助成胶能明显提高Ａｌ２Ｏ３的比表面积和孔径,并能显著改善Ａｌ２Ｏ３的热稳定性。     

循环伏安和现场红外光谱电化学研究镉(Ⅱ)在普鲁士蓝/铂修饰电极上的反应

报道了普鲁士蓝(PB)膜修饰Pt电极在CdCl_2溶液中进行循环伏安(CV)扫描,衍生为含有部分六氰亚铁酸镉(CdHCF)混合修饰膜的电化学反应,并对其反应机理进行了电化学和现场红外光谱电化学(FTIRs)的研究.实验结果表明,这一混合膜中PB和CdHCF两种成分之间的相互影响并不大,两种物质基本上保持了各自为纯物质时的电化学特性.     

电感耦合等离子体质谱(ICP-MS)法结合化学计量学分析比较6种松针中无机元素的含量

为研究甘肃地区松针中无机元素的含量,探究不同品种松针中无机元素的差异,采用HNO₃(65%)对松针样品进行微波消解,电感耦合等离子体质谱(ICP-MS)法测定甘肃两地区6种松针中28种无机元素的含量,结合主成分分析以及偏最小二乘判别分析对松针地区差异进行判别;结果显示松针中无机元素含量丰富,其中Na、Mg、Al、K、Ca、Fe、Zn、Mn、Sr等元素在不同品种松针中均有较高含量,主成分分析结果显示共有7个主成分,累积贡献率达到92.58%,偏最小二乘判别分析显示两地区6种松针在地区上可被明显分开,其中Mg、Fe、Zn、Mn、Sr、K 6种元素为造成地区差异的主要元素。实验结果表明松针中元素种类丰富,人体必需微量元素含量较高,且不同地区松针在地区上具有一定的一致性和特异性。     

Manganese porphyrins/mesoporous amberlyst 15 nanocomposites: Robust biomimetic catalysts for aqueous oxidation of olefins

In this study, the manganese complexes of N-methylated meso-tetra(2-, 3-, or 4 pyridyl)porphyrins, immobilized into the pores of the sodium salt of mesoporous amberlyst 15 nanoparticles (nanoAmbSO₃Na), nanoAmbSO₃@MnT(2-MePy)P (OAc), nanoAmbSO₃@MnT(3-MePy)P (OAc), and nanoAmbSO₃@MnT(4-MePy)P (OAc), were synthesized and characterized by field-emission scanning electron microscopy (FESEM), energy dispersive X-ray spectroscopy (EDX), thermal gravimetric analysis (TGA), nitrogen adsorption/desorption porosimetry analysis, and diffuse reflectance UV–vis spectroscopy. FESEM images revealed a particle size less than ~40 nm for the nanocomposites. The results of BET are in accord with the occupation of the larger pores of the polymer matrix in the case of MnT(2-MePy)P (OAc) as the most sterically demanding metalloporphyrin of the series, and the smaller pores in the case of the other ones. The immobilized manganese porphyrins were used as catalysts for the oxidation of olefins with sodium periodate in the presence of imidazole (ImH) as the co-catalyst. The negligible oxidative destructions of the immobilized manganese porphyrins under the oxidative conditions allowed the comparison of the inherent catalytic activity of the metalloporphyrins, decreased as nanoAmbSO₃@MnT(4-MePy)P (OAc) > nanoAmbSO₃@MnT(3-MePy)P (OAc) ≫ nanoAmbSO₃@MnT(2-MePy)P (OAc). Contrary to the general belief that electron-deficient metalloporphyrins are more efficient catalysts than the electron-rich ones, the most electron-deficient metalloporphyrin of the series, that is, nanoAmbSO₃@MnT(2-MePy)P (OAc), showed the lowest catalytic activity. Due to the high oxidative stability of the immobilized manganese porphyrins, ring opening of epoxide competes with the epoxidation reaction to decrease the yield of epoxide at longer reaction times than the optimized one.