D→Klv～l衰变过程的研究

用光锥QCD求和规则研究D→Klv～_l衰变过程，首先计算D→K跃迁形状因子，通过构造新的关联函数，消除了twist-3波函数的不确定性给计算结果所带来的影响，从而使计算结果更加精确. 计算得到的分支比与最近的实验数据相一致. 关键词： QCD光锥求和规则 D介子半轻衰变 分支比 形状因子     

Fabrication of isotype (p-p) selenium-polyaniline heterojunction diode by electrochemical method

In the present work, for the first time, heterojunction has been fabricated using electrochemically deposited isotype p-selenium-p-polyaniline from a single solution bath. The structural characterization of selenium and polyaniline thin film was carried out using XRD technique. Polyaniline exhibited amorphous structure while selenium offered monoclinic (β) phase. The junction was formed by electrodepositing polyaniline over selenium film and heating at 423 K. The current density versus voltage (J-V) plot showed the formation of a junction with ideality factor of 1.16. From J-V characteristics at different temperatures, static resistance (R_s), dynamic resistance (R_d), and rectification ratio of diodes were determined. Heat treatment above 448 K caused junction breakdown.     

Experimental investigation of the aquatic propulsion caused by localised flexural wave propagation in immersed wedges and plates

This paper describes the results of the experimental verification of the idea of wave-like aquatic propulsion of autonomous and man-inhabited vessels first published about 10 years ago by one of the present authors (V.V.K.). The idea is based on employing the unique type of localised flexural elastic waves propagating along edges of wedge-like structures immersed in water (wedge elastic waves). Such wedge-like structures supporting localised elastic waves can be attached like fish fins to a body of a small ship or a submarine and used for their propulsion. The proposed principle of employing localised flexural waves as a source of aquatic propulsion has been biologically inspired by the specific swimming mode used in nature by stingrays. To verify the idea experimentally, the first working prototype of a small catamaran using the above-mentioned wave-like propulsion via the attached rubber keel has been build and tested in Loughborough University. The tests have been carried out in two phases, in a water tank and then in open water. The test results have shown that the catamaran was propelled very efficiently and could achieve the speed of 36 cm/s, i.e., about one vehicle length per second, thus demonstrating that the idea of wave-like propulsion of small man-inhabited craft is viable. The reported proof of the viability of this idea may open new opportunities for marine craft propulsion, which can have far reaching implications.     

Electrical properties of polypyrrole/p‐InP structure

The polypyrrole/p‐InP structure has been fabricated by the electrochemical polymerization of the organic polypyrrole onto the p‐InP substrate. The current–voltage (I–V), capacitance–voltage (C–V), and capacitance–frequency (C–f) characteristics of the PPy/p‐InP structure have been determined at room temperature. The structure showed nonideal I–V behavior with the ideality factor and the barrier height 1.48 and 0.69 eV respectively. C–f measurements of the structure have been carried out using the Schottky capacitance spectroscopy technique and it has been seen that there is a good agreement between the experimental and theoretical values. Also, it has been seen that capacitance almost show a plateau up to a certain value of frequency, after which, the capacitance decreases. The higher values of capacitance at low frequencies were attributed to the excess capacitance resulting from the interface states in equilibrium with the p‐InP that can follow the a.c. signal. The interface state density N_ss and relaxation time τ of the structure were determined from C–f characteristics. © 2006 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 44: 1572–1579, 2006     

Gas transport through homogeneous and asymmetric polyethersulfone membranes

Both homogeneous and asymmetric polyethersulfone (PES) membranes were prepared by solvent casting. The sorption and permeation behavior of CO₂, O₂, and N₂ using these two kinds of cast PES membranes and commercially available homogeneous PES film was investigated to extract the pressure dependence of gas permeability and the permselectivity for CO₂ relative to N₂, and to confirm the validity of the working assumption that a skin layer in an asymmetric membrane can be essentially replaced by a thick homogeneous dense membrane. The pressure dependence of the mean permeability coefficient to CO₂ in homogeneous membranes obeys the dual-mode mobility model. The ideal separation factor for CO₂ relative to N₂ at an upstream pressure of 0.5 MPa attains ca. 40, while the permeability to CO₂ is about 2.7 Barrer at the same upstream pressure. The same separation factor in asymmetric membranes amounts to 35. The diffusion behavior for the skin layer in an asymmetric membrane with a thin skin layer can be simulated approximately by that in a homogeneous dense membrane. © 1993 John Wiley & Sons, Inc.     

1．5GHz锯材超导腔的研制

介绍铌材超导腔的研制进展，重点讨论了国产铌腔的材料改性，以及相应的超导腔性能的改进．叙述了１．５ＧＨｚ铌腔的腔形设计，分析了铌材的射频性能和机械性能，制定了铌腔制作与后处理的特定工艺．最后给出了１．５ＧＨｚ铌材超导腔的低温实验结果．     

A Monte Carlo method for an objective Bayesian procedure

This paper describes a method for an objective selection of the optimal prior distribution, or for adjusting its hyper-parameter, among the competing priors for a variety of Bayesian models. In order to implement this method, the integration of very high dimensional functions is required to get the normalizing constants of the posterior and even of the prior distribution. The logarithm of the high dimensional integral is reduced to the one-dimensional integration of a cerain function with respect to the scalar parameter over the range of the unit interval. Having decided the prior, the Bayes estimate or the posterior mean is used mainly here in addition to the posterior mode. All of these are based on the simulation of Gibbs distributions such as Metropolis' Monte Carlo algorithm. The improvement of the integration's accuracy is substantial in comparison with the conventional crude Monte Carlo integration. In the present method, we have essentially no practical restrictions in modeling the prior and the likelihood. Illustrative artificial data of the lattice system are given to show the practicability of the present procedure.     

钛合金（TC-6）二阶和三阶弹性常数

 用脉冲回波重叠法测量了钛合金（TC-6）的二阶、三阶弹性常数。实验中发现dμ/dp<0（p<0.17 GPa）,dμ/dp>0（p>0.17 GPa）。     

用透射积分法研究的穆斯堡尔谱学——一个在聚合二茂铁研究中的应用

本文利用透射积分法，在聚合二茂铁研究中发现，这种方法不但能够得到超精细参数，而且能够得到一般拟合方法得不到的另外两个重要参数—样品的无反冲分数和相应的德拜温度，由此能进一步了解到样品在结合中晶格的质量及化学键的强弱，为穆斯堡尔谱研究提供了一条新的途径。     

因子分析—伏安法同时测定波峰重叠的混合物组份

本文将目标因子分析用于伏安分析法同时测定波峰重叠的混合物组份。用此法对Ｐｂ（Ⅱ）、Ｔｌ（Ｉ）混合体系的导数脉冲伏安重叠峰数据进行解析，获得了较理想的结果。