等厚双层涂层材料受集中力作用的平面问题理论解

界面应力的正确评价是分析薄膜涂层材料力学特性的难题之一。利用镜像点法和Dirichlet等值性原理，本文推导了等厚双层薄膜涂层材料受表面集中力作用的平面问题理论解。该显式理论解是以固定在各镜像点上的局部坐标系下的Goursat应力函数的形式给出的。对应于高阶镜像点的应力函数，可通过递推的方法，从对应于低阶镜像点的应力函数求得，而且也易于计算机编程。随着镜像点阶数的增大，它与界面的距离也越来越大，因而相对应的应力函数对界面应力的影响越来越小。最后的算例表明，只需考虑前面有限个镜像点，便可获得足够精度的解。该理论解可作为格林函数，以求解复杂问题的理论解，也可用作边界元法的基本解，提高数值计算的精度和效率。     

Thickness decrease of a grafted polyelectrolyte membrane exposed to shear flow

The effect of the shear flow on the thickness change of a polyelectrolyte membrane grafted onto a glass substrate was directly investigated with a flow cell combined with a confocal laser scanning microscope. The membrane thickness decreased proportionally to an increase in the shear stress of the flow when the shear rate exceeded a critical value of 1 s^?1. The higher the ionic strength was of the fluid, the greater the thinning effect was. The correlation between the critical shear rate and the relaxation of the polymer in the gel membrane was examined. © 2003 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 41: 2808–2815, 2003     

Ferromagnetic Properties of Bond-Dilution and Random Positive or Negative Uniaxial Anisotropy Blume-Capel Model

We study the ferromagnetic properties of spin-1 system, which is considered in the frame of the bond dilution and random positive or negative anisotropy Blume-Capel model in the effective field theory and a cutting approximation. The investigation of phase diagrams displays some rich properties of the trajectory of tricritical point, reentrant henomena at low temperatures. Under certain both bond concentrations and random negative anisotropy, there are new transition lines of double tricritical points. So special emphasis is placed on the influence of the bond dilution and random anisotropy on phase diagrams. The magnetizations of the system are also discussed. Some results have not been evealed in previous reports.     

Emission characteristics of high-powered microwave induced plasma optical emission spectrometry by using nitrogen–oxygen mixture gas

A high-powered, microwave-induced nitrogen–oxygen plasma (N₂–O₂–MIP) generated by using an Okamoto cavity at atmospheric pressure was investigated when the observation height, the flow rate of carrier gas, and the oxygen content were varied as the experimental parameters. The emission characteristics of the plasma were evaluated with regard to the excitation temperature and the intensity ratio of atomic line to ionic line. The excitation temperature of the N₂–O₂–MIP was in the range of 5100–5700 K when the oxygen content was varied from 0 to 30% at the observation height of 7 mm and the carrier gas flow rate of 0.6 l/min. The intensity ratio of atomic line to ionic line was elevated with an increase in the oxygen content.     

Use of a Dual-Marker Form of Analysis to Estimate Binding Constants Between Receptors and Ligands by Affinity Capillary Electrophoresis

This work describes the use of a dual-standard analysis approach termed the time-average ratio (TAR) in affinity capillary electrophoresis (ACE) to estimate binding constants of receptors to ligands. In this form of analysis the TAR is the migration time of the receptor divided by the average of the sum of the migration times of two non-interacting standards. This change in TAR as a function of the concentration of ligand yields a value for the binding constant. This concept is demonstrated using three model systems: carbonic anhydrase B (CAB, EC 4.2.1.1) and arylsulfonamides, vancomycin (Van) and ristocetin (Rist) from Streptomyces orientalis and Nocardia lurida, respectively, and d-Ala- d-Ala terminus peptides. Three ACE techniques are used to examine the three systems: standard ACE, flow-through partial-filling ACE (FTPFACE), and on-column derivatization coupled to ACE. The findings described here demonstrate that ACE data analyzed using the TAR form of analysis yield binding constants between receptors and ligands comparable to those estimated using other ACE forms of analysis. A comparison to three other forms of analysis is described.     

用电子散斑干涉法测量材料热膨胀系数

 利用双光束电子散斑干涉法（ESPI）对试件受热变形进行了实时观测，针对一次实验过程中得到的图片较多（300～500幅）的特点，在图像处理时摒弃了以往的手动识别等位移线的办法，用MATLAB语言编写了批处理程序，能够在采集的大量散斑图片中自动快速准确地标定等位移线，得到相应的位移和应变，并结合实时测量的温度值，获得了45钢和LY12铝合金在不同温升率下的热膨胀系数及其随温度的变化。实验结果表明，在涉及的温升率范围内，温升率的改变对材料热膨胀系数的影响不明显，材料的热膨胀系数随温度的升高略有上升。     

微波大气吸收衰减特性分析及分层数值算法

 给出了微波在大气中传输受气体分子吸收导致衰减的较精确计算模型，该模型扩展了传统计算模式忽略温度、湿度、压力变化及传播距离受限制的近似算法。结合我国某地区的实测气象数据模拟计算了该地区的大气吸收衰减，最后根据数值计算结果分析了微波随频率、发射角度以及月份（季度）变化的传播特性，并简要说明了此研究在微波遥感中的实际意义。     

基于有限元模拟的超声应力系数标定及分析*

应力系数的标定作为超声应力检测最为关键的环节,直接决定应力检测结果的准确性。传统的应力系数试验标定对于被测物的表面粗糙度、耦合剂厚度、声匹配块与被测物接触力等因素十分敏感,但缺少基本参照值。基于COMSOL建立多物理场耦合的超声应力检测模型,施加不同的拉伸载荷,计算临界折射纵波到达时间与不同应力值之间的关系,模拟标定45#钢的超声应力系数为13.7MPa/ns。单轴水平拉伸试验标定的45#钢应力系数为16.5MPa/ns。结果表明,通过两种方法标定的应力系数较为接近,试验标定的应力系数偏大,这是由于有限元方法能够消除试验过程中各种不确定因素对声时精确测量所造成的影响,能够更加纯粹的反映材料的声弹性效应,因此具有作为基础数据的参考价值。有限元方法作为传统试验方法的补充,可以减小试验标定数据的离散性,提高超声应力检测结果的可信度。     

Interplay Between Quark-Antiquark and Diquark Condensates in Vacuum in a Two-Flavor Nambu-Jona-Lasinio Model

By means of a relativistic effective potential, we analytically research competition between the quark- antiquark condensates （qq） and the diquark condensates （qq） in vacuum in ground state of a two-flavor Nambu Jona Lasinio （NJL） model and obtain the Gs-Hs phase diagram, where Gs and Hs are the respective four-fermion coupling constants in scalar quark-antiquark channel and scalar color anti-triplet diquark channel. The results show that, in the chiral limit, there is only the pure （qq） phase when Gs/Hs 〉 2/3, and as Gs/Hs decreases to 2/3 〉 Gs/Hs ≥ 0 one will first have a coexistence phase of the condensates （qq） and （qq） and then a pure （qq） phase. In non-zero bare quark mass case, the critical value of Gs/Hs at which the pure （qq） phase will transfer to the coexistence phase of the condensates （qq） and （qq） will be less than 2/3. Our theoretical results, combined with present phenomenological fact that there is no diquark condensates in the vacuum of QCD, will also impose a real restriction to any given two-flavor NJL model which is intended to simulate QCD, i.e. in such model the resulting sma/lest ratio Gs/Hs after the Fierz transformations in the Hartree approximation must be larger than 2/3. A few phenomenological QCD-like NJL models are checked and analyzed.     

Acrylamide-Derived Ionome,Metabolic, and Cell Cycle Alterations Are Alleviated by Ascorbic Acid in the Fission Yeast

Acrylamide (AA), is a chemical with multiple industrial applications, however, it can be found in foods that are rich in carbohydrates. Due to its genotoxic and cytotoxic effects, AA has been classified as a potential carcinogen. With the use of spectrophotometry, ICP-OES, fluorescence spectroscopy, and microscopy cell growth, metabolic activity, apoptosis, ROS production, MDA formation, CAT and SOD activity, ionome balance, and chromosome segregation were determined in Schizosaccharomyces pombe. AA caused growth and metabolic activity retardation, enhanced ROS and MDA production, and modulated antioxidant enzyme activity. This led to damage to the cell homeostasis due to ionome balance disruption. Moreover, AA-induced oxidative stress caused alterations in the cell cycle regulation resulting in chromosome segregation errors, as 4.07% of cells displayed sister chromatid non-disjunction during mitosis. Ascorbic acid (AsA, Vitamin C), a strong natural antioxidant, was used to alleviate the negative impact of AA. Cell pre-treatment with AsA significantly improved AA impaired growth, and antioxidant capacity, and supported ionome balance maintenance mainly due to the promotion of calcium uptake. Chromosome missegregation was reduced to 1.79% (44% improvement) by AsA pre-incubation. Results of our multiapproach analyses suggest that AA-induced oxidative stress is the major cause of alteration to cell homeostasis and cell cycle regulation.