Electrospinning synthesis and photocatalytic property of CaFe2O4/MgFe2O4 heterostructure for degradation of tetracycline

CaFe₂O₄/MgFe₂O₄ nanowires with heterostructure had been successfully synthesized by electrospinning method. The obtained samples were systematically characterized by scanning electron microscopy (SEM), X‐Ray diffraction (XRD), UV–Vis diffuse reflectance spectra (UV‐Vis DR) and Environment scanning electron microscopy (ESEM). The novel CaFe₂O₄/MgFe₂O₄ nanowires exhibit an enhanced photocatalytic activity for degrading of tetracycline (TC) under visible light. Compared with bare CaFe₂O₄ or MgFe₂O₄ samples, the prepared CaFe₂O₄/MgFe₂O₄ (Ca:Mg:Fe = 3:2:10) composited nanowires show the best photocatalytic performance with a degradation efficiency of 40% after 150 min reaction time. This enhancement is attributed to the heterostructure of CaFe₂O₄/MgFe₂O₄ nanowires, which effectively repress the recombination of photo‐generated electrons and holes. Based on heterostructure and energy band positions, the enhancement of mechanism under visible‐light enhances the photocatalytic activity.     

Improved Photobleaching for (1,10-phenanthroline)tris[4,4,4-trifluoro-1-(2-thienyl)-1,3-butanedionato]europium(III) Particle Embedded in Sol-Gel Derived Glass Film

In this research, we investigated improved photobleaching characteristics of (1,10-phenanthroline)tris[4,4,4-trifluoro-1-(2-thienyl)-1,3-butanedionato]europium(III) by forming nano-particles embedded into a sol-gel derived silica glass film by a conventional sol-gel process. The relative photoluminescence intensities after the UV irradiation for 90 min were 88, 76, and 67% for nano-particles in the sol-gel derived glass film, powders in the sol-gel derived glass film, and raw powders, respectively. This result indicates that the phtobleaching of this Eu-complex can improved by forming nano-partcile structures by a reprecipitation method and embedding in the sol-gel derived silica glass.     

新型复合共沉淀法制备高能量/高功率型锂离子二次电池用5V正极材料LiNi_(0.5)Mn_(1.5)O_4及其电化学性能

在传统的固相法的基础上开发了新型复合共沉淀法制备LiNi0.5Mn1.5O4材料.新型复合共沉淀法采用(NH4)2CO3和(NH4)2C2O4共同作为沉淀剂,通过控制共沉淀反应条件,得到了具有均匀球形形貌的沉淀物颗粒.再通过与饱和氢氧化锂溶液的水热反应及高温反应,最终制备出具有球形次级形貌和纯相尖晶石结构的LiNi0.5Mn1.5O4材料.电化学测试表明,制备的LiNi0.5Mn1.5O4具有优异的电化学性能,其初始容量达到了141.4mAh·g-1.在0.3C、1C和3C倍率下经过200次循环后的容量分别为136.0 mAh·g-1(96.3%)、128.6 mAh·g-1(94.4%)和113.9 mAh·g-1(91.1%).通过高温反应及特殊的冷却处理,LiNi0.5Mn1.5O4在4.0 V低压区平台的容量损失得到了有效抑制.更重要的是,通过控制合成过程中的关键步骤,可实现半定量化控制材料结构中的原子有序排布程度,进而得到具有高能量密度和高功率密度的两种LiNi0.5Mn1.5O4材料,其能量密度和功率密度分别达到了648.6 mWh·g-1和7000 mW·g-1以上.     

水热-溶胶-凝胶法合成多壁碳纳米管-Na3V2（PO4）3复合物及其作为锂离子电池正极材料的性能

采用水热和溶胶-凝胶相结合的方法,制备了具有良好电化学性能的新型多壁碳纳米管-Na₃V₂（PO₄）₃（MWCNT-NVP）复合材料（MWCNT的质量分数为8.74%）. 通过场发射扫描电子显微镜表征可知,MWCNT分散在NVP纳米颗粒之间,并起到“电子导电线”的作用. 与纯Na₃V₂（PO₄）₃相比,MWCNT-NVP具有更高的比容量和更优异的循环性能. 在0.2C（35.2 mA·g^-1）的电流密度下,3.0-4.5 V的电压范围内,MWCNT-NVP的初始比容量为82.2 mAh·g^-1. 循环100次以后,比容量为72.3 mAh·g^-1. 在1.0-3.0 V充放电时,MWCNT-NVP的初始容量为100.6 mAh·g^-1. 100次循环以后,其容量保持率高达90%. 同时,交流阻抗测试表明,由于MWCNT的存在,MWCNT-NVP的导电性有了显著的提高. 以上结果表明,MWCNT-NVP是一种良好的锂离子电池电极材料.     

BiOI/Bi_2WO_6对甲基橙和苯酚的光催化降解及光催化机理(英文)

采用简单的沉积方法制备了不同碘化氧铋含量的BiOI/Bi2WO6光催化剂,通过X射线衍射(XRD)、扫描电子显微镜(SEM)、高分辨透射电子显微镜(HR-TEM)、紫外-可见漫反射光谱(UV-Vis DRS)和BET比表面积测量对其进行了表征。在紫外和可见光的照射下,使用甲基橙和苯酚的光催化降解评价了BiOI/Bi2WO6催化剂的光催化性能。结果表明:与商业P25和纯Bi2WO6相比,13.2%BiOI/Bi2WO6光催化剂具有更高的紫外和可见光催化性能。这明显增加的光催化活性主要归功于光生电子和空穴在Bi2WO6和BiOI界面上的有效转移,降低了电子-空穴对的复合。基于BiOI和Bi2WO6的能带结构,提出了光生载流子的一种转移过程。自由基清除剂的实验表明,·OH,h+,·O2-和H2O2,特别是h+,共同支配了甲基橙和苯酚的光催化降解过程。     

低温溶剂热法制备5V级性能优异的LiCr_(0.2)Ni_(0.4)Mn_(1.4)O_4正极材料(英文)

通过低温溶剂热的方法成功制备出了LiCr0.2Ni0.4Mn1.4O4尖晶石正极材料。通过此法,溶液的饱和蒸汽压急剧降低且在室温(25℃)下即可沸腾。所有的金属离子可在随后的热聚合过程中均匀分散且煅烧后所得材料无杂质相生成。采用了热重分析,X射线衍射,扫描电镜、循环伏安,交流阻抗等测试手段对材料进行了表征。结果表明:此法所得材料含有Mn3+,为Fd3m晶型,且其形貌规则、粒度分布均一。1C和10C下放电容量为140.5和121.0 mAh·g-1,10C下100次循环容量保持率高达96.9%。其优异的电化学性能可归因于均相的前驱体制备过程,高结晶度且无杂相生成,以及较高的锂离子扩散系数诸因素的共同作用。     

不同形貌纳米CoWO_4的水热法制备及气敏性能(英文)

以Co(NO3)2·6H2O、Na2WO4·2H2O为主要原料,去离子水为溶剂,利用水热法在不同条件下制备了一系列的纳米CoWO4,用XRD、TEM和比表面分析仪对产品的物相、形貌和比表面积进行了表征。较系统地探讨了水热条件(反应混合物pH值、反应时间、反应温度等)对产物物相和形貌的影响,并研究了不同形貌产品对甲醛、乙醇、氨气、苯和丙酮等的敏感性能。结果表明:水热条件对产品的物相和形貌有影响,在不同水热条件下,可成功制备CoWO4纳米颗粒、纳米立方体及纳米棒;以纳米颗粒、纳米立方体及纳米棒样品制成的气敏元件对被试气体有不同程度的响应,其中以纳米颗粒为基的元件在210℃对1 000μL·L-1NH3灵敏度为3.3。     

Synthesis and acaricidal activity of strobilurin-pyrimidine derivatives简

Pyriminostrobin, a new acaricide, was discovered in our previous studies. Because introducing fluorine into organic compounds can increase bioactivity, pyriminostrobin was modified as a series of strobilurin-pyrimidine derivatives for biological screening. The compounds were characterized by 1H NMR, MS and elemental analysis. Preliminary bioassays demonstrated that compounds 7e and 7i exhibited significant control against Tetranychus cinnabarinus （Boisd.） at 0.625 mg L^-1, and their acaricidal potencies were higher than pyriminostrobin in a greenhouse. The relationship between structure and acaricidal activity was also studied.     

Graphene oxide assisted facile hydrothermal synthesis of LiMn0.6Fe0.4PO4 nanoparticles as cathode material for lithium ion battery

Assisted by graphene oxide（GO）,nano-sized LiMn0.6Fe0.4PO4 with excellent electrochemical performance was prepared by a facile hydrothermal method as cathode material for lithium ion battery.SEM and TEM images indicate that the particle size of LiMn0.6Fe0.4PO4（S2）was about 80 nm in diameter.The discharge capacity of LiMn0.6Fe0.4PO4 nanoparticles was 140.3 mAh-g^1 in the first cycle.It showed that graphene oxide was able to restrict the growth of LiMn0.6Fe0.4PO4 and it in situ reduction of GO could improve the electrical conductivity of LiMn0.6Fe0.4PO4 material.     

ZnO/Ag复合纳米粒子的制备与表征

以乙酸锌为前驱物,乙醇为溶剂,油酸钠为表面修饰剂,采用溶液化学法,在乙醇体系中制得纳米Zn O。然后缓慢加入一定量的硝酸银乙醇溶液,在乙醇的还原作用下将Ag+还原为Ag纳米粒子,制得Zn O/Ag复合纳米粒子。通过紫外-可见吸收光谱(UV-Vis)、荧光光谱(FL)、透射电子显微镜(TEM)和X射线衍射(XRD)等方法对所制备的氧化锌-银复合纳米粒子样品进行表征。结果表明,所合成的Zn O/Ag复合纳米粒子为球形,尺寸为20-30nm且粒径分布较窄。Ag纳米粒子附着于Zn O纳米粒子表面,并起到良好的表面修饰作用。对制备Zn O/Ag复合纳米粒子的机理进行了初步探究。