水中溶解氧的微量滴定

将微量滴定技术应用于常规的碘量法测定水中溶解氧。在实验中采用了WD-CO3型微量滴定装置,并使用自行设计制成的高精度微量移液管（移液的体积可准确至0．001mL）,作为转移标准溶液及试样溶液的工具。对微量滴定及微量移液与常量滴定和常量移液作了对比试验,结果表明两者的分析结果完全吻合,微量滴定（其中包括微量移液）所得结果的精密度也在定量分析允许范围之内。由此,微量滴定技术应用于水中溶解氧的日常分析的可行性得到了验证。     

Effect of the nonlinearity of the CCD in Fourier transform profilometry on spectrum overlapping and measurement accuracy

In Fourier transform profilometry (FTP), we must restrain spectrum overlapping caused by the nonlinearity of the charge coupled device (CCD) and increase the measurement accuracy of the object shape. Firstly, the causes of producing higher-order spectrum components and inducing spectrum overlapping are analysed theoretically, and a simple physical explanation and analytical deduction are given. Secondly, aiming to suppress spectrum overlapping and improve measurement accuracy, the influence of spatial carrier frequency of projection grating on them is analysed. A method of increasing the spatial carrier frequency of projection grating to restrain or reduce the spectrum overlapping significantly is proposed. We then analyze the mechanism of how the spectrum overlapping is reduced. Finally, the simulation results and experimental measurements verify the correction of the proposed theory and method.     

Theoretical description of improving measurement accuracy for incoherence Mie Doppler wind lidar

For the nonlinearity of Fabry-Perot interferometer(FPI) transmission spectrum,the measurement uncertainty of incoherent Mie Doppler wind lidar based on it increases evidently with the increase of backscattering signal Doppler shift.A method of repeating the use of the approximate linear part of FPI transmission spectra for reducing the high uncertainty of a big Doppler shift is proposed.One of the ways of realizing this method is discussed in detail,in which the characteristics of FPI transmission spectrum changing with thickness and incident angle are utilized simultaneously.Under different atmosphere conditions,it has been proved theoretically that the range of measurement uncertainty drops to one-sixth while its minimum has no serious change.This method can be used not only to guide the new system design,but also as a new working way for the fabricated system.     

动力学晶格蒙特卡洛方法模拟Cu薄膜生长

利用动力学晶格蒙特卡洛方法模拟了Cu薄膜在Cu(100)面上的三维生长过程。模型中考虑了四个动力学过程:原子沉积、增原子迁移、双原子迁移和台阶边缘原子迁移,各动力学过程发生的概率由多体势函数确定。讨论了基底温度、沉积速率及原子覆盖率对Cu原子迁移、成核和表面岛生长等微观生长机制的影响;获得了Cu薄膜的表面形貌图并计算了表面粗糙度。模拟结果表明,随基底温度升高或沉积速率下降,岛的平均尺寸增大,数目减少,形状更加规则。低温时,Cu薄膜表现为分形的离散生长,高温时,Cu原子迁移能力增强形成密集的岛。Cu薄膜表面粗糙度随着基底温度的升高而迅速减小;当基底温度低于某一临界温度时,表面粗糙度随原子覆盖率或沉积速率的增大而增大;当基底温度超过临界温度时,表面粗糙度随原子覆盖率或沉积速率的变化很小,基本趋于稳定。     

Computer Simulation of a 3-D Sensing System with Structured Illumination

A computer simulation system of three-dimensional sensing with structured illumination is presented. It includes the generation of deformed fringe patterns from 3-D shapes and the reconstruction of 3-D shapes, conversely. Some experimental results of the deformed fringe pattern and the reconstructed object shapes are presented. We have also discussed the effect of some major system parameters on the measurement results and considered how to correct these parameters according to the measurement result of the standard plane. Using this simulation system, the major system parameters: environmental conditions, measurement accuracy and algorithm evaluation of the 3-D shape measurement system based on PMP, FTP, SPM, etc., can be researched. © 1997 Elsevier Science Ltd. All rights reserved.     

Zur Berechnung von Geometriefaktoren bei der Kernstrahlungsmessung

Der Geometriefaktor von radioaktiven umschlossenen oder offenen Strahlenquellen hängt bei der Messung mittels einer Kernstrahlungsmeßsonde von der räumlichen Anordnung der Strahlenquelle zu der strahlenexponierten wirksamen Fläche des Detektors und von der Geometrie der Strahlenquelle selbst ab. Fūr punktförmige Strahler in verschiedenen Positionen, Geraden, Kreisflächen und Zylinder wurde in möglichst einheitlicher Vorgehensweise die Berechnung der Geometriefaktoren bezüglich kreisförmiger ebener Detektionsflächen vorgenommen und rechentechnisch in Form von BESM 6-Algolprogrammen realisiert. Die Berechnungsergebnisse sind untereinander konsistent und wurden möglichst durch unabhängige Verfahren oder experimentelle Werte kontrolliert. Die Rechengenauigkeit kann gemäß den vorliegenden Anforderungen frei gewählt werden.     

变系数情形下Criss-Cross三角形线性元的渐近展式与超收敛

本文讨论了二阶椭圆方程变系数情形下Criss-Cross三角形线性元的超收敛性质,得到了有限元的渐进展式、外推及高精度组合公式等结果.     

高精度近场动力学方法:一维键型研究

近些年发展起来的近场动力学方法对于模拟复杂的断裂破坏问题具有显著优势.然而,计算精度不高一直是影响该方法进一步发展的瓶颈问题之一.区域积分不精确和键缺失导致的边界效应是降低该方法计算精度的两个主要原因.针对一维键型近场动力学模型,本文通过修正微模量提高区域积分的精度,通过理性构建固定边界和力边界虚拟键改善边界效应,建立...     

光纤光栅法布里-珀罗腔的V-I传输矩阵法研究

快速有效地获得多级联光纤光栅法布里-珀罗(F-P)腔的光谱特性,是优化设计基于上述结构建立的级联多波长激光器、放大器等各种光器件以及复杂分布式传感网络的重要基础和保障.将V-I传输矩阵法用于光纤光栅F-P腔反射光谱特性的分析,并建立了V-I传输矩阵模型.采用该模型对三种不同结构的光纤光栅F-P腔在不同参数下的光谱特性进行分析,并与传统多层膜法的分析结果相比较,表明V-I传输矩阵法能够在保证分析精度的前提下大大节省运算时间.实验结果表明,V-I传输矩阵法对光纤光栅F-P腔谱特性的分析结果比耦合模法更准确.     

求解Schrdinger方程的高阶紧致差分格式

基于Richardson外推法提出了一种求解Schrdinger方程的高阶紧致差分方法.该方法首先利用二阶微商的四阶精度紧致差分逼近公式对原方程进行求解,然后利用Richardson外推技术外推一次,得到了Schrdinger方程具有O(r~4+h~4)精度的数值解.通过Fourier分析方法证明了该格式是无条件稳定的.数值实验验证了该方法的高阶精度及有效性.