Determination by LC of Polyphenols in Italian Red Wine

A reversed-phase liquid chromatographic method, optimised for the separation of trans-, and cis-resveratrol, catechin, epicatechin, quercetin and rutin, is reported. Separation was achieved using a C18 column and a gradient elution with acetonitrile and 5% formic acid aqueous solution. The analyses required an equilibration period of 10 min and a run time of 25 min for completion. Identification was based on retention characteristics and by relative UV spectra, obtained by photodiode array detector and were compared with commercial standards. Analyses were performed without any sample pre-treatment. Detection was carried out by UV–Vis detector at three different wavelengths. The detection limit ranged from 0.16 μgm L⁻¹ (cis-resveratrol) to 1.5 μgm L⁻¹ (+)-catechin. Investigation was extended to quantitative determination of phenol compounds in Italian red wine and to investigate the stability of the six antioxidants.     

GC–MS analysis of phenolic compounds in fuels after conversion to trifluoroacetate esters

The GC–MS characteristics of trifluoroacetate esters of phenolic compounds are discussed. Linear temperature programmed retention indices and total ion current MS response factors of over 120 phenolic esters are reported. The main GC advantages from analysis of trifluoroacetate esters as compared to plain phenols are enhanced volatility and improved resolution. For example, the elution temperature of a given phenol is typically 50 °C greater than that of the corresponding trifluoroacetate ester. Also, while retention of compounds with two trifluoroacetate groups is only moderately greater than mono esters, underivatized dihydroxy compounds are very difficult to elute from any GC column. Complete resolution of isomeric C₀-, C₁- and C₂-alkylphenol esters is readily achieved on conventional fused silica GC columns; resolution of the corresponding underivatized compounds requires specialized GC columns with low temperature limits. In general, mass spectra of trifluoroacetate esters are more characteristic of a given structure than those of the corresponding phenols and may be more rigorously interpreted towards structural elucidation. A table in the report summarizes some of the more important spectral features used in compound identification. Example applications in analysis of coal-, shale- and petroleum-derived materials are presented. Selected ion monitoring is used to determine individual phenolic components in whole distillates; reconstructed ion chromatograms are used to illustrate distributions of selected species as a function of fuel storage and thermal stress.     

Stoichiometric and catalytic methods of asymmetric synthesis of nonproteinogenic α-and β-amino acids via transition metal coordination compounds

The complexes of glycine, -alanine, and -alanine with (S)-[N-(N-benzylprolyl)amino] benzophenone formed by Ni(II) and Cu(II) ions and Schiff bases enter into different nucleophilic and electrophilic reactions with the formation of diastereoisomeric complexes which decompose into proteinogenic and nonproteinogenic L-amino acids with a high chemical yield and elevated optical purity (70–90%). Optically pure amino acids can be obtained from diastereoisomerically pure complexes after the complexes are separated by recrystallization of the mixture of diastereoisomeric complexes formed. A new type of interphase catalysts of C-alkylation of achiral Schiff bases was proposed. The catalysts are positively charged Ni(II) and Cu(II) complexes of Schiff bases of chiral diamines. In some cases, these complexes have a higher activity and capacity to execute asymmetric alkylation than traditional chiral interphase catalysts based on cinchonidine.Based on materials in the section report by Yu. N. Belokon' to the 7th European Symposium on Organic Chemistry, ESOC-7.A. N. Nesmeyanov Institute of Organoelemental Compounds, Russian Academy of Sciences, 117813 Moscow. Translated from Izvestiya Akademii Nauk, Seriya Khimicheskaya, No. 5, pp. 1106–1127, May, 1992.     

Determination of the Enthalpies of Vaporization of Cyclic Organic Peroxides by Correlation of Changes in Gas Chromatographic Retention Times

Liquid and solid cyclic peroxides derived from aliphatic ketones are explosive materials so their enthalpies of vaporization and other thermodynamic or condensed-phase properties cannot be measured directly. In this work the enthalpies of vaporization of peroxides at 298.15 K were estimated simply from gas chromatographic retention times measured at different temperatures. The technique correlates changes in the retention times of compounds whose enthalpies of vaporization are known (called the reference series), with those of the compounds of interest. If t _R′ is the adjusted retention time (retention time of each compound minus the retention time of unretained diethyl ether, used as solvent) a plot of ln t _R′ against 1/T for each compound (reference compounds and cyclic peroxides) results in a straight line (r ² > 0.99 for all compounds). The enthalpy of transfer from solution to the vapor state (Δ_sol^g H _m) can be obtained by multiplying the slope by the gas constant (R). A second plot correlates the enthalpies of transfer from solution to the vapor state (Δ_sol^g H _m), as measured by gas–liquid chromatography (GLC), with enthalpies of vaporization of reference materials (Δ_vap H _m at 298.15 K) available in the literature. C₉–C₁₅ fatty acid methyl esters and hydrocarbons were used as reference compounds. The enthalpies of vaporization of the cyclic organic peroxides were calculated from the equation of the line obtained in this second correlation, the slope of which was Δ_vap H _m (at 298.15 K)/Δ^g _sol H _m. The experiments were performed under isothermal conditions with a DB-5 capillary column, flame-ionization detection (FID), and nitrogen as carrier gas. The column temperature was varied over a range of at least 30–70 K between 403 and 473 K, with chromatograms being acquired at 10 K intervals. Enthalpies of vaporization of cyclic organic peroxides are not available in the literature, and the values given in this paper, obtained by gas chromatography, are the first to be reported.     

Supercritical Propanol-Water Synthesis and Comprehensive Size Characterisation of Highly Crystalline anatase TiO2 Nanoparticles

Highly crystalline anatase TiO₂ nanoparticles have been synthesised in less than 1 min in a supercritical propanol-water mixture using a continuous flow reactor. The synthesis parameter space (T, P, concentration) has been explored and the average particle size can be accurately controlled within 10-18 nm with narrow size distributions (2-3 nm). At subcritical conditions amorphous products are obtained, whereas a broad range of T and P in the supercritical regime gives 11-14 nm particles. At high temperature and pressure, the particles size increase to 18 nm. The nanoparticles have been extensively characterised with powder X-ray diffraction (PXRD), transmission electron microscopy (TEM) and small-angle X-ray scattering (SAXS) with excellent agreement on size and size distribution parameters. The SAXS analysis suggests disk-shaped particles with diameters that are approximately double the height. For comparison, a series of conventional autoclave sol-gel syntheses have been carried out. These also produce phase-pure anatase nanoparticles, but with much broader size distributions and at much longer synthesis times (hours). The study demonstrates that synthesis in supercritical fluids is a very promising method for manipulating the size and size distribution of nanoparticles, thus removing one of the key limitations in many applications of nanomaterials.     

Highly selective conversion of N-aroyl-α-dehydronaphthylalaninamides into 3,4-dihydrobenzoquinolinone derivatives via photoinduced intermolecular electron transfer

The irradiation of substituted (Z)-N-aroyl-α-dehydronaphthylalaninamides [(Z)-1] in methanol containing triethylamine (TEA) with Pyrex-filtered light was found to give 3,4-dihydrobenzoquinolinone derivatives (2) in high yields along with minor amounts of 4,5-dihydrooxazole derivatives (3). Analysis of the substituent effects on product composition revealed that both the photoreactivity of 1 and the selectivity of 2 are decreased with increasing electron-withdrawing ability of the substituent introduced at the para-position on the N-benzoyl benzene ring. From the analysis of the dependence of the quantum yield for the formation of 2 on the TEA concentration, it was found that back electron transfer occurs efficiently within an (E)-1 anion radical-TEA cation radical pair intermediate.     

Variation of physicochemical properties in the aggregates of structual isomers

The regions of variation of density, enthalpy of formation, and detonation velocity of all of the formally possible structual isomers were determined for several molecular formulas of C,H,N,O-containing explosives. The histograms of the distribution of the structual isomers over these parameters were constructed.Translated fromIzvestiya Akademii Nauk. Seriya Khimicheskaya, No. 5, pp. 859–862, May, 1995.The authors are grateful to Mrs. I. D. Solodukhina for the design of the graphical material.The work was carried out with the financial support of the Russian Foundation for Basic Research (Project No. 94-03-09323).     

Significance of Non-isothermal Kinetic Data. A statistical study

Arrhenius parameters values, in non-isothermal kinetic vaporisation processes for a series of compounds with related structures, have been calculated. This was made using a method of calculation that allows to find the most probable vaporisation mechanisms. According to this method DTG curves were compared with some theoretical ones reported in literature, whose shape results to be only a function of the mechanisms. In this way the choice of the mathematical functions which can be inserted in the kinetic equations, was influenced by the shape of the DTG plots and other thermal analysis signals thus allowing to choose the most probable mechanisms. The kinetic parameters derived from these mechanisms were compared, using statistical analysis, with those obtained from another method of calculation based on ‘a priori’ vaporisation mechanism chosen for the investigated liquid–gas transition. The standard deviations of the slope and of the intercept, together with the standard deviation and the square correlation coefficient (r ²) of the linear regression equations related to the mechanisms of the two methods were calculated. Student t-test, Fisher F-test, confidence intervals (c.i.) and residuals valueswere also given. Statistical analysis shows that the mechanisms obtained with the former method (diffusive and geometrical models) and the related Arrhenius parameters result to be more significant (in terms of probability) than the corresponding quantities of the latter for which a first-order model was chosen. This revised version was published online in August 2006 with corrections to the Cover Date.     

Ab initio studies of the protonation of CO,N2 and NO+: Calculation of the minimum energy reaction paths

Ab initio molecular orbital calculations employing a 4-31G basis set have been used to study the minimum energy paths for the formation of HCO⁺, COH⁺, and HCOH²⁺ from CO by protonation. The protonation of N₂ to give NNH⁺ and HNNH²⁺ and of NO⁺ to form HNO²⁺ and NOH²⁺ have also been investigated. All species formed have linear equilibrium geometries and the minimum energy path for approach of the proton is along the line-of-centers of the heavy atoms. Energy barriers to the formation of the various species are given, where appropriate, and changes in geometry, ordering of molecular orbitals and orbital occupancy are discussed.