Two-parameter failure criterion for elastoplastic bodies with mode I cracks

The generalized Dugdale crack model is used to formulate two-parameter failure criteria for the cases of quasibrittle state and developed plastic zones at a mode I crack tip. The failure criteria relate the fracture strength characteristics and the stress mode at the crack tip through the plastic constraint factor. The critical state of bodies with cracks under uni-and biaxial loading is analyzed in the cases of plane stress and plane strain using the Tresca and von Mises yield criteria. A small-scale yield criterion, which is an analytic relation between the critical stress intensity factor and T-stresses, is established __________ Translated from Prikladnaya Mekhanika, Vol. 43, No. 7, pp. 47–57, July 2007.     

紧凑拉剪试样中Ⅰ/Ⅱ复合型穿透裂纹的三维特性分析

进行了Ⅰ/Ⅱ复合型载荷作用下航空结构铝合金CTS试样线弹性的全场三维有限元计算,分析了复合型离面应力约束因子Tz和面内约束T应力的分布特性,研究了厚度和载荷条件对应力各分量及应力三轴性水平Rσ、应变能密度U0的影响以及这些量在实验中观察到的裂纹起裂方向上的特点。结果表明：（1）平面内约束T应力在此种试样形式下为零;（2）复合型裂纹的三维效应区与厚度成正比,为0.4-0.5B,与载荷条件基本无关,但是厚度效应随着载荷角的减小逐渐变小,到II型载荷时基本消失;（3）离面约束因子Tz随着径向和厚度尺寸的增加逐渐减小,但在周向基本不发生变化;（4）最小应变能密度U0min的方位能够表征此种材料三维复合型断裂的裂纹起裂方向。研究结果为建立三维复合型断裂准则提供了理论基础。     

一类多体系统非完整运动最优规划的拟牛顿算法

研究带有非完整约束的一类多体系统运动规划问题。多体系统中的非完整约束通常是由不可积的速度约束或不可积的守恒律引起。在系统动量和动量矩守恒情况下,动力学方程降阶为非完整形式约束方程,系统的控制问题可转化为无漂移系统的非完整运动规划问题。文中首先导出具有多体开链系统的非完整运动模型。利用最优控制理论和最优化技术,采用输入参数化的方法将连续的最优控制问题转化为离散的最优控制问题,提出一种非完整多体系统运动规划的拟牛顿算法。最后将该方法用于自由漂浮的空间三连杆机构,仿真结果验证了该方法的有效性。     

V型缺口裂端的三维应力状态及约束分析

利用三维有限元方法,研究了有限厚度板中V型缺口根部穿透裂纹前沿的三维弹性应力场。对不同厚度、不同缺口张开角和裂纹长度对应力强度因子及裂尖附近的三维约束程度的影响进行了分析,同时还讨论了三维约束区的大小。研究结果显示：当缺口张开角小于60度时,不同缺口的应力强度因子和离面约束因子的分布基本一致,角度的影响不明显。应力强度因子是厚度的函数,板中面的应力强度因子随厚度的增加逐渐减小趋近干平面值,最大为1．08倍的平面值。当板厚超过15倍的缺口深度时,应力强度因子最大值将从中面转移至接近自由表面位置,距中面约0．4倍板厚。三维约束非常明显的区域在裂尖前沿约0.45倍厚度的范围内．二维到三维的过渡区在裂尖前沿1.5倍厚度的区域内;在中面上三维效应影响区最大,随着离中面距离的增加逐渐减小,在自由表面上降为0。     

带有控制-状态混合约束的时滞Volterra型积分系统的最优控制问题

对带有控制-状态混合约束的一类受控时滞Volterra型积分系统,导出了其最优控制的一组必要条件和一组充分条件．     

A note on spectrum distribution of constraint preconditioned generalized saddle point matrices

In this note, results concerning the eigenvalue distribution and form of the eigenvectors of the constraint preconditioned generalized saddle point matrix and its minimal polynomial are given. These results extend previous ones that appeared in the literature. Copyright © 2009 John Wiley & Sons, Ltd.     

LOCAL BENDING OF THIN FILM ON VISCOUS LAYER

Effects of deposition layer position film are systematically investigated. Because the and number/density on local bending of a thin deposition layer interacts with the thin film at the interface and there is an offset between the thin film neutral surface and the interface, the deposition layer generates not only axial stress but also bending moment. The bending moment induces an instant out-of-plane deflection of the thin film, which may or may not cause the socalled local bending. The deposition layer is modeled as a local stressor, whose location and density are demonstrated to be vital to the occurrence of local bending. The thin film rests on a viscous layer, which is governed by the Navier-Stokes equation and behaves like an elastic foundation to exert transverse forces on the thin film. The unknown feature of the axial constraint force makes the governing equation highly nonlinear even for the small deflection chse. The constraint force and film transverse deflection are solved iteratively through the governing equation and the displacement constraint equation of immovable edges. This research shows that in some special cases, the deposition density increase does not necessarily reduce the local bending. By comparing the thin film deflections of different deposition numbers and positions, we also present the guideline of strengthening or suppressing the local bending.     

A trust-region and affine scaling algorithm for linearly constrained optimization

A new trust-region and affine scaling algorithm for linearly constrained optimization is presented in this paper. Under no nondegenerate assumption, we prove that any limit point of the sequence generated by the new algorithm satisfies the first order necessary condition and there exists at least one limit point of the sequence which satisfies the second order necessary condition. Some preliminary numerical experiments are reported. The work was done while visiting Institute of Applied Mathematics, AMSS, CAS.     

Soft Constraint Logic Programming and Generalized Shortest Path Problems

In this paper we study the relationship between Constraint Programming (CP) and Shortest Path (SP) problems. In particular, we show that classical, multicriteria, partially ordered, and modality-based SP problems can be naturally modeled and solved within the Soft Constraint Logic Programming (SCLP) framework, where logic programming is coupled with soft constraints. In this way we provide this large class of SP problems with a high-level and declarative linguistic support whose semantics takes care of both finding the cost of the shortest path(s) and also of actually finding the path(s). On the other hand, some efficient algorithms for certain classes of SP problems can be exploited to provide some classes of SCLP programs with an efficient way to compute their semantics.