利用液晶空间光调制器产生高阶拉盖尔高斯光束

本文采用反射式纯相位液晶空间光调制器产生了实验需要的高阶拉盖尔高斯光束。理论上详细计算了生成高阶拉盖尔高斯(Laguerre-Gaussian)光束的最优参数选择,用MATLAB编写程序,制作产生高阶LG光束的相息图。通过CCD采集图像数据,观测了以平面波入射生成拉盖尔高斯光束的强度分布,并利用干涉法验证了产生高阶拉盖尔高斯光束的螺旋相位分布。在此基础上,对实验测得一维强度轮廓进行拟合分析并估算了实验产生LG光束的纯度。     

GC–MS with photoionization of cold molecules in supersonic molecular beams—Approaching the softest ionization method

A new type of photoionization ion source was developed for the ionization of cold molecules in supersonic molecular beams (named Cold PI). The system was based on a GC–MS with supersonic molecular beams and its fly‐through EI of cold molecules ion source (Cold EI) plus quadrupole mass analyzer. A continuously operated deuterium VUV photoionization lamp was added and placed above and between the supersonic nozzle and skimmer whereas the Cold EI ion source served only as a portion of the ion transfer ion optics. The supersonic nozzle and skimmer were voltage biased and the VUV light crossed the supersonic expansion about 10 mm from the nozzle. We obtained over three orders of magnitude enhancement in the relative abundance of the molecular ion of squalane in Cold PI versus in photoionization of this compound as a thermal compound. Accordingly, we also proved that standard photoionization is not as soft ionization method as previously perceived for large compounds. We found that Cold PI is as soft as and possibly softer than field ionization; thus, it could be the softest known ionization method. The ionization yield was about 200–300 times weaker than with Cold EI yet our limit of detection was about 200 femtogram in SIM mode for cholesterol and pyrene which is reasonable. Practically, all hydrocarbons gave only molecular ions with rather uniform response whereas alcohols gave some molecular ions plus major fragment ions particularly with a loss of water (similarly to field ionization). We tested Cold PI in the GC–MS analysis of diesel fuels and analyzed the time averaged data for group type information. We also found that we can analyze the diesel fuels by fast under 20‐s flow injection analysis in which the generated averaged mass spectrum of molecular ions only could serve for the characterization of fuels.     

Analysis of impurities in pharmaceuticals by LC‐MS with cold electron ionization

Pharmaceuticals require careful and precise determination of their impurities that might harm the user upon consumption. Although today, the most common technique for impurities identification is liquid chromatography‐mass spectrometry (LC‐MS/MS), it has several downsides due to the nature of the ionization method. Also, the analyses in many cases are targeted thus despite being present, some of the compounds will not be revealed. In this paper, we propose and show a new method for untargeted analysis and identification of impurities in active pharmaceutical ingredients (APIs). The instrument used for these analyses is a novel electron ionization (EI) LC‐MS with supersonic molecular beams (SMB). The EI‐LC‐MS‐SMB was implemented for analyses of several drug samples spiked with an impurity. The instrument provides EI mass spectra with enhanced molecular ions, named Cold EI, which increases the identification probabilities when the compound is identified with the aid of an EI library like National Institute of Standards and Technology (NIST). We analyzed ibuprofen and its impurities, and both the API and the expected impurity were identified with names and structures by the NIST library. Moreover, other unexpected impurities were found and identified proving the ability of the EI‐LC‐MS‐SMB system for truly untargeted analysis. The results show a broad dynamic range of four orders of magnitude at the same run with a signal‐to‐noise ratio of over 10 000 for the API and almost uniform response.     

3D X-ray Micro-CT Analysis of Rebar Corrosion in Reinforced Concrete Subjected to a Chloride-Induced Environment

The paper presents experimental investigations of the concrete covers’ protective ability to counteract rebar corrosion in reinforced concrete cubes. The concrete sample was subjected to a chloride-induced environment to get corroded and combined with an un-corroded sample. The chloride-accelerated technique can induce a high degree of corrosion within a controlled time. Moreover, detailed and thorough experimental measurements and analyses of reinforcement loss due to corrosion and its influence on concrete microstructure, were studied through 3D X-ray micro-computed tomography. The rebar outside the concrete was heavily corroded due to the chloride-accelerated test, whereas, only local surface corrosion products appeared inside the concrete. It turned out that the concrete cover showed protective ability to counteract the reinforcing-steel corrosion mechanism despite the accelerated corrosion environment. Moreover, the bond strength between the reinforcement rebar and concrete was not visibly affected since the failure force in the pull-out test and failure mechanisms, observed by 3D X-ray micro-CT, were similar for corroded and un-corroded samples. The failure occurred due to radial cracks with a maximum width equal to approximately 0.25 mm.     

基于修正压力场理论的再生混凝土梁抗剪承载力计算方法研究

基于修正压力场理论分析有腹筋再生混凝土梁的剪切破坏机理,建立了更接近有腹筋再生混凝土梁实际受力的抗剪模型,并通过考虑再生骨料有效粒径和受箍筋作用下的裂缝宽度与构件裂缝处应力的联系,分析了再生骨料咬合力对梁斜截面抗剪性能的影响,提出了再生混凝土梁极限抗剪承载力的计算方法.此外,本文将理论结果与课题组自制的6根再生混凝土梁...     

不同材料弹体超声速侵彻钢筋混凝土靶的结构破坏对比实验

设计了超声速钻地结构弹,采用203 mm口径的火炮,开展了25 kg量级弹体在1100~1300 m/s速度范围内侵彻钢筋混凝土靶的实验研究,应用数值仿真对弹体侵彻钢筋混凝土靶的过程进行了模拟计算。基于实验和仿真结果,对超声速侵彻条件下两种金属材料弹体的结构响应、质量损失等问题进行了分析。结果表明:在超声速侵彻钢筋混凝土靶的过程中,两种金属材料的弹体结构变形破坏形式主要为头部侵蚀和侧壁磨蚀,头部侵蚀量的大小与弹体壳体材料有关,高强度G50钢材料更适合用于1200 m/s速度量级的超声速侵彻环境。对出现的“径缩”现象作了初步分析,并对今后工程应用的结构弹体设计提出了指导意见。     

组合式十字形钢管混凝土柱偏压力学性能试验研究

设计了一种由槽钢和方形钢管拼焊形成的组合式十字形钢管混凝土柱,将其灵活地布置在框架结构的中节点,可使柱肢与填充墙等厚,有效地提高建筑使用面积。共制作了6根组合式十字形钢管混凝土柱试件,考虑了偏心距和长细比两种变化参数。通过对其进行偏心受压试验研究,考察了试件的破坏形态和荷载-挠度曲线,并分析了其在不同偏心距和长细比下的荷载-应变曲线发展规律。结果表明:组合式十字形钢管混凝土柱中钢管和槽钢对混凝土的约束作用强,表现为较高的延性系数;偏心距或长细比越大,试件的极限承载力及弹性刚度越小,且偏心距越大延性越好,长细比对延性影响不显著;在受拉侧纵向应变基本上符合平截面假定,在受压侧纵向应变不符合平截面假定。     

F−(H2O)+CH3I配体交换反应动力学

本文介绍F^?(H₂O)+CH₃I→[FCH₃I]^?+H₂O在交叉分子束碰撞能量0.3∽2.6 eV的配体交换动力学成像结果. 产物的动能受到弱键结合配合物的稳定性的影响,大量水分子的内部激发不利于中间物有效的能量重新分配,随着碰撞增加,低动能受到抑制. 在0.3 eV时,内部亲核取代非常重要,为形成I^?和I^?(H₂O)的竞争性亲核取代途径提供了依据.     

Paraxial propagation of cosh-Airy vortex beams in chiral medium

Propagation dynamics of the cosh-Airy vortex(CAiV) beams in a chiral medium is investigated analytically with Huygens–Fresnel diffraction integral formula. The results show that the CAiV beams are split into the left circularly polarized vortex(LCPV) beams and the right circularly polarized vortex(RCPV) beams with different propagation trajectories in the chiral medium. We mainly investigate the effect of the cosh parameter on the propagation process of the CAiV beams.The propagation characteristics, including intensity distribution, propagation trajectory, peak intensity, main lobe's intensity, Poynting vector, and angular momentum are discussed in detail. We find that the cosh parameter affects the intensity distribution of the CAiV beams but not its propagation trajectory. As the cosh parameter increases, the distribution areas of the LCPV and RCPV beams become wider, and the side lobe's intensity and peak intensity become larger. Besides, the main lobe's intensity of the LCPV and RCPV beams increase with the increase of the cosh parameter at a farther propagation distance, which is confirmed by the variation trend of the Poynting vector. It is significant that we can vary the cosh parameter to control the intensity distribution, main lobe's intensity, and peak intensity of the CAiV beams without changing the propagation trajectory. Our results may provide some support for applications of the CAiV beams in optical micromanipulation.     

泡沫铝防护钢筋混凝土板的抗爆性能

为研究多孔吸能材料泡沫铝板对工程结构的抗爆防护作用,开展室外爆炸破坏实验,分别对设置不同泡沫铝防护层的钢筋混凝土(reinforced concrete,RC)板在爆炸荷载下的动态响应及破坏模式进行了研究,并运用LS-DYNA软件建立了有限元模型。通过与实验对照,验证了模型的可行性,对比分析了有、无泡沫铝防护层钢筋混凝土板的损伤破坏规律,并讨论了泡沫铝密度梯度分布和纵筋配筋率的影响。结果表明:有限元模型能够有效分析含泡沫铝防护层RC板的动态响应及其破坏形态;泡沫铝防护层能够有效减小钢筋混凝土板的挠度变形,降低试件的破坏程度;泡沫铝密度由下到上递增情况对RC板的减爆效果最好;增大配筋率可以提升泡沫铝防护RC板整体抗爆性能。