Pulse plating effect on microstructure and corrosion properties of Zn–Ni alloy coatings

The influence of pulse plating parameters on the surface morphology, grain size, lattice imperfection and corrosion properties of Zn–Ni alloy has been studied. The coatings were electrodeposited in an alkaline cyanide-free solution. AFM was applied for surface morphology examination, XRD measurements were carried out for phase composition and texture analysis, electron probe microanalysis was used for alloy chemical composition studies, while electrochemical techniques were applied for corrosion performance evaluation. The pulse plated Zn–Ni coatings appeared to consist of the γ-Zn₂₁Ni₅ phase and the composition of the alloy depended on the plating parameters. The grain size, lattice imperfection and homogeneity of grain distribution were established to be the main factors determining corrosion behaviour of the coating. Presented at the 4th Baltic Conference on Electrochemistry, Greifswald, March 13–16, 2005     

Voltammetric, chronocoulometric and spectroelectrochemical studies of electropolymerized films based on Co(III/II)- and Zn(II)-4,9,16,23-tetraaminophthalocyanine: effect of high pH

Electropolymerized thin films of Co(III/II)- and Zn(II)-4,9,16,23-tetraaminophthalocyanine, immersed in solutions of relatively high pH, have been studied electro- and spectroelectrochemically. Cyclic voltammetry and chronocoulometry were used to characterize films deposited on glassy carbon electrodes. Spectroelectrochemistry and ellipsometry measurements were performed on indium tin oxide (ITO) surfaces coated with the zinc and cobalt complexes and correlated to the electrochemical information collected using glassy carbon electrodes. Studies at high pH are motivated by the efficient increase in luminol chemiluminescence at high OH⁻ concentration, and by potential application in luminescence sensors. Although the films are not removed, some structural changes occur when they are exposed to solutions of high pH. In addition, an estimation of the number of monolayers has also been calculated. The atomic diameters of cobalt and zinc are very close in value, but the estimated number of monolayers, based on cyclic voltammetric data, for a given number of electropolymerization cycles is approximately four-fold higher in the zinc-based film. This would correspond to three-fold thicker films when zinc is the central metal ion. Ellipsometry measurements have been correlated with cyclic voltammetric data to confirm that film thickness varies among the different complexes, even though the conditions of electropolymerization are the same.     

光解碎片平动谱中二级过程的运动学及化学动力学

本文发展了一套分析处理分子束光解反应实验中二级分解产物飞行谱的方法, 它改进了Kroger和Riley的最初讨论。本文表明许多重要的信息都可以从高度平均的实验数据中得出。这包括二级分解产物的平均平动能分布、空间各向异性参数、平行竞争通道间的反应比。模拟的结果可以表现二级分解反应的一些主要特征。     

The simultaneous saccharification and fermentation of pretreated woody crops to ethanol

Four promising woody crops (Populusmaximowiczii x nigra (NE388), P.trichocarpa x deltoides (Nll), P.tremuloides, and SweetgumLiquidambar styraciflua) were pretreated by dilute sulfuric acid and evaluated in the simultaneous saccharification and fermentation (SSF) process for ethanol production. The yeastSaccharomyces cerevisiae was used in the fermentations alone, and in mixed cultures with β -glucosidase producingBrettanomyces dausenii. Commercial Genencor 150L cellulase enyme was either employed alone or supplemented with β- glucosidase. All SSFs were run at 37 …C for 8 d and compared to saccharifications at 45…C under the same enzyme loadings.S. cerevisiae alone achieved the highest ethanol yields and rates of hydrolysis at the higher enzyme loadings, whereas the mixed culture performed better at the lower enzyme loadings without β -glucosidase supplementation. The best overall rates of fermentation (3 d) and final theoretical ethanol yields (86–90%) were achieved with P.maximowiczii x nigra (NE388) and SweetgumLiquidambar styraciflua, followed by P.tremuloides and P.trichocarpa xdeltoides (N1l) with slightly slower rates and lower yields. Although there were some differences in SSF performance, all these pretreated woody crops show promise as substrates for ethanol production.     

DEHYDROGENATION AND AROMATIZATION OF METHANE IN THE ABSENCE OF OXYGEN OVER DOPED Mo/HZSM-5 CATALYSTS

研究了在Ｍｏ／ＨＺＳＭ－５催化剂上添加助剂以及不同的反应预处理温度对甲烷无氧脱氢芳构化反应的影响。实验结果表明，由于第二组分的添加，Ｍｏ／ＨＺＳＭ－５催化剂的活性和选择性都得到了较大程度的改善。预处理温度是影响催化剂反应性能的关键因素。Ｍｏ－Ｒｕ／ＨＺＳＭ－５催化剂经过８７３Ｋ空气预处理后，甲烷在９７３Ｋ的转化率约为１０％，催化剂的稳定性也得到较大程度的提高。ＴＰＳＲ实验结果表明，Ｒｕ的加入降低了芳烃生成的温度。ＴＰＯ和ＤＴＡ实验结果表明，在Ｍｏ－Ｒｕ／ＨＺＳＭ－５催化剂上可生成较多的碳物种，结合反应结果，可以认为反应过程中生成的碳物种对甲烷的无氧脱氢芳构化反应是起积极作用的     

Structural evolution of calcium-exchanged (NH4)2SiF6-dealuminated Y zeolite after various chemical treatments

The structural evolution of Y zeolite (Si/Al 2.17) weakly dealuminated by hexafluorosilicate (Si/Al 3.13), denoted Y_D, and exchanged with calcium (CaY_D), has been studied after acid–base treatments at 80 °C close to the cation exchange conditions. The stability of the samples was followed by X-ray diffraction and solid-state NMR of ²⁹Si and ²⁷Al; Y_D zeolite was completely destroyed by treatment with acid pH 2.5 and suffered serious degradation on treatment with alkali at pH 11.8. The introduction of calcium improved the stability of the zeolite in acid and base. In acid CaY_D was not destroyed until pH 1. At pH 2, silicon and aluminium were extracted and an amorphous phase was formed. Base treatment at pH 13 did not affect the calcium-exchanged zeolite.     

电化学氟化的新进展

电化学氟化是利用电极反应将氟直接引入有机或无机物的一种重要方法。有机物的电化学氟化方法有两种: 一是Simons于1941年发明的, 用镍作阳极, 在无水氟化氢溶液中, 电解制备全氟化合物的方法。此方法在近年来有不少改进。另一是1970年Rozhkov提出的, 以有机溶剂(如含Et3N.3HF的MeCN)为介质, 在铂阳极上,氧化得到单氟化产物的方法。本文全面地综述了这两种方法, 并着重于最新民发展。     

Synthesis and characterisation of bis(pentafluorophenyl)antimony(V) cations, [(C6F5)2SbL3]

Pentacoordinate complex cations of the general formula [(C₆F₅)₂SbL₃]³⁺ stabilized as solid salts in combination with tetraphenylborate (BPh₄), tetrafluorobroate (BF₄) anions, where L=DMSO, Ph₃AsO, PyO, DMF, α-, β- and γ-picoline have been isolated. The newly formed complexes were characterized by elemental analysis, molar conductance measurements, solid-state IR and and NMR. From these results, a five-fold coordination around antimony was required.     

Artificial model for cystathionine β-synthase: efficient β-replacement reaction with thiols employing a novel pyridoxal model compound having an imidazole function

As a second-generation pyridoxal model compound for cystathionine β-synthase, we designed a novel model compound having an ionophore function and an imidazole function, application of which to the β-replacement reaction with various thiols smoothly took place to give S-substituted cysteines. Peptides having a serine-O-carbonate residue at the N-terminal position were also converted to the corresponding peptides having an S-substituted cysteine residue under the catalytic conditions of the novel pyridoxal model compound.     

Photoreaction of 2′-chloro-4-R-benzanilide: synthesis of 2-(4-R-phenyl)-1,3-benzoxazole and 9-R-phenanthridin-6(5H)-one (R=H, CH3, CH3O)

The UV photolysis of 2′-chloro-4-R-benzanilides in acetonitrile solution under nitrogen atmosphere leads to the formation of intramolecular photocyclization products (9-R-phenanthridin-6(5)-one, 20–30%), along with the minor photoreduction, photo-Fries, and intramolecular photosubstitution products. The photoreaction of 2′-chloro-4-R-benzanilide in acetonitrile solution containing 10% of water or aqueous sodium hydroxide however gives 2-(4-R-phenyl)-1,3-benzoxazole as a major product (30%) along with the photoreduction, photo-Fries and intramolecular photocyclization products.