Upper and lower bounds for the energy of bipartite graphs

Using Lagrange's multiplier rule, we find upper and lower bounds of the energy of a bipartite graph G, in terms of the number of vertices, edges and the spectral moment of fourth order. Moreover, the upper bound is attained in a graph G if and only if G is the graph of a symmetric balanced incomplete block design (BIBD). Also, we determine the graphs for which the lower bound is sharp.     

S[a,b]类中边界Nevanlinna-Pick插值(Ⅱ)

继续作者最近的研究,用所谓的Hankel向量方法建立S[a,b]函数类中带边界插值数据的Nevanlinna-Pick插值问题与[a,b]上的某种带约束条件的Hausdorff矩量问题之间解集之间明确的一一对应关系.通过N[a,b]函数类与S[a,b]函数类之间的联系,从而由BNP(N[a,b])问题的可解性准则和解的参数化描述获得BNP(S[a,b)问题的可解性准则和解的参数化表示.     

Electrochemical characterization of poly(vinylidenefluoride)-zinc triflate gel polymer electrolyte and its application in solid-state zinc batteries

Gel polymer electrolyte (GPE) films comprising of poly(vinylidenefluoride), propylene carbonate, ethylene carbonate and zinc trifluoromethane sulfonate are prepared and characterized. The composition of GPE is optimized to contain minimum liquid components with a maximum specific conductivity of 3.94×10⁻³ S cm⁻¹ at (25±1) °C. A detailed investigation on the properties such as ionic conductivity, transport number, electrochemical stability window, reversibility of Zn/Zn²⁺ couple and Zn/gel electrolyte interfacial stability have been carried out. The ionic conductivity follows a VTF behaviour with an activation energy of about 0.0014 eV. Cationic transport number varies from 0.51 at 25 °C to 0.18 at 70 °C. Several cells have been assembled with GPE as the electrolyte, zinc as the anode, γ-MnO₂ as the cathode and their charge–discharge behaviour followed. Capacity values of 105, 82, 64 and 37 mAh/g of MnO₂ have been achieved at 10, 50, 100 and 200 μA/cm² discharge current densities, respectively. The discharge capacity values are almost constant for about 55 cycles for all values of current densities. Cyclic voltammetric study of MnO₂ electrode in Zn/GPE/MnO₂ cell clearly shows intercalation/deintercalation of Zn²⁺.     

Pressure induced transitions in calcium: a tight-binding approach

A tight-binding (TB) hamiltonian for calcium is built with a high precision parametrization technique based on density functional calculations of the energy bands and the total energy at various lattice volumes. The new set of TB parameters is appropriate to study phenomena under pressures as high as 20 GPa. Specifically, both the metal to nonmetal transition at 4 GPa and the structural transition fcc to bcc at 19 GPa are well reproduced. These transitions and several static properties are in excellent agreement with experiments. Phonon frequencies, plasmon energy, melting temperature and the coefficient of thermal expansion were calculated with a molecular dynamics scheme of this TB hamiltonian.     

Microwave‐improved polymerization of ϵ‐caprolactone initiated by carboxylic acids

The ring‐opening polymerization of ε‐caprolactone (ε‐CL), initiated by carboxylic acids such as benzoic acid and chlorinated acetic acids under microwave irradiation, was investigated; with this method, no metal catalyst was necessary. The product was characterized as poly(ε‐caprolactone) (PCL) by ¹H NMR spectroscopy, Fourier transform infrared spectroscopy, ultraviolet spectroscopy, and gel permeation chromatography. The polymerization was significantly improved under microwave irradiation. The weight‐average molecular weight (M_w) of PCL reached 44,800 g/mol, with a polydispersity index [weight‐average molecular weight/number‐average molecular weight (M_w/M_n)] of 1.6, when a mixture of ε‐CL and benzoic acid (25/1 molar ratio) was irradiated at 680 W for 240 min, whereas PCL with M_w = 12,100 and M_w/M_n = 4.2 was obtained from the same mixture by a conventional heating method at 210 °C for 240 min. A degradation of the resultant PCL was observed during microwave polymerization with chlorinated acetic acids as initiators, and this induced a decrease in M_w of PCL. However, the degradation was hindered by benzoic acid at low concentrations. © 2002 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 41: 13–21, 2003     

An optical bridge reflectometer for sensitive measurement of ion implantation dose

An instrument is described that can be used to monitor, with unprecedented sensitivity, changes in the optical reflectivity due to crystailine damage incurred during ion implantation. It is shown that at the shot-noise limit, changes in the optical reflectivity of silicon as small as 5·10^–7 can be measured in a 10 Hz bandwidth with a signal-to-noise ratio of 100, corresponding to an extrapolated uniform implantation dose of 5·10⁸ cm^–2 for ¹¹B⁺ at 50 keV in silicon.     

Analysis of heterojunction resonant cavity-enhanced Schottky photodiodes by using two-valley transport model

The article concerns heterojunction resonant cavity-enhanced (RCE) Schottky photodiodes with GaAs in the absorption layer. The quantum efficiency and linear pulse response have thoroughly been analysed. For the first time, the response of a heterojunction photodiode has been modelled by the phenomenological model for a two-valley semiconductor. The results obtained have shown that the satellite valleys, as well as the parasitic time constant, significantly influence the response and, accordingly, have to be taken into account when analysing and optimizing RCE photodetectors.     

Study of adsorption of oxygen on β-Al2O3 + Au and β-Al2O3 + Pt: Work function measurements—proposition of a model

To improve the understanding of the electrochemical effects observed on an original potentiometric gas sensor, interactions of oxygen with the device were investigated. This gas sensor is made of a solid electrolyte (treated Na-β-alumina) associated with two metallic electrodes (gold and platinum) located in the same gas mixture. Adsorption of charged oxygen species, considered responsible for the electrical response developed by the sensor, was investigated by work function measurements. Results showed that charged oxygen species only form on partially gold or platinum covered solid electrolyte. Comparison of these results with those obtained in a previous calorimetric study of interactions between oxygen and the same materials suggests the existence of at least two different oxygen species adsorbed on the surface of the sensitive element. The first one, located on the solid electrolyte surface, is neutral and characterized by an endothermal reaction of formation. The second one is charged and probably produced at the gas/solid electrolyte/metallic electrode interface. A mechanism based on the concept of “three phase boundary” and similar to the “reverse spillover” phenomenon is proposed to account for the adsorption of these oxygen species.     

On an approach to the study of the Jaynes–Cummings sum in quantum optics

A new approach to the study of the Jaynes–Cummings sum, which determines the atomic inversion in quantum model of a single two-level atom interacting with a single mode of the quantized radiation field, based on the number theory theorems on approximation of trigonometric sums is presented.      

Study of local lattice relaxation of substitutional impurities in silicon and germanium

Local lattice relaxation of substitutional donors in silicon investigated using self‐consistent multiple scattering Xα (MSXα) method within the framework of the standard muffin‐tin potential approximation is extended to substitutional donors in germanium and substitutional acceptors in both silicon and germanium. Incorporating the effect of lattice relaxation surrounding the impurity makes the model suitable for both shallow and deep levels. Chemical trends of some aspects of impurity states, such as local lattice relaxation and charge transfer, of the impurities both in silicon and germanium are inferred. © 2004 Wiley Periodicals, Inc. Int J Quantum Chem, 2004