Coupling between polymer adsorption and colloidal particle aggregation

Studies of the adsorption of high molecular weight polymers on colloidal latex and silica particles and their subsequent flocculation were carried out. Neutral polyethylene oxide samples with both a narrow and a broad molecular weight distribution were used together with low charged cationic copolymers. The influence of the particle concentration and polymer dose on the flocculation were systematically investigated under quiescent conditions.Equilibrium bridging only occurred with polyelectrolyte, even in very dilute suspensions, at high particle coverage. In contrast to this, non-equilibrium bridging occurred with both neutral polymer and polyelectrolytes but only for more concentrated suspensions and small amounts of adsorbed polymer. Polymer adsorption in dilute suspensions, which did not show particle aggregation was measured an electrophoretic technique. In more concentrated suspensions, where flocculation takes place, we found that aggregation prevents further polymer adsorption and induces both an excluded volume and a surface effect. The consequences on the shape of the isotherms differ according to the aggregation mechanism.A significant decrease of the amount, , of adsorbed polymer is observed with non-equilibrium bridging. When both mechanisms simultaneously contribute to the aggregation, the value of depends on their relative importance. In the intermediate range of copolymer dose their respective contributions are critically sensitive to the details of the mixing step and stirring, leading to non reproducible experimental results.     

Na2SeO3在Fe电极上还原和吸附机理

采用循环伏安法、恒电势电解法、恒电流阶跃法及交流阻抗法研究Na2SeO3提高锌锰合金电沉积电流效率的作用机理.证明在锌锰合金电沉积的条件下，Na2SeO3 阴极被还原为Se32－并吸附在阴极表面上，从而阻止了氢原子在阴极表面的吸附，因而减少了氢离子的阴极还原.拟定了Na2SeO3的反应和吸附机理，用交流阻抗法进一步证明了所拟机理的正确性.     

Molecular structure of mixed adsorption layers surfactant—polymer at a liquid—liquid interface

Isotherms of the binding of dodecyl sulfate anions (DDS^–)and Na⁺ counterions during their coadsorption with a nonionic polymer. proxanol (PR). at the interface of dodecane-water emulsions have been measured by conductometry and Na-selective potentiometry. The adsorption of DDS^– and PR is concurrent. The affinity constant of PR to the interface determined by the Langmuir model decreases as the concentration of PR increases, and the surface concentration of DDS^– tends to a nonzero limiting value at high concentrations of PR. The surface (_o) and electrokinetic () potentials at the interface have been determined at various polymer concentrations by the spin probe and electrophoresis methods. The average dielectric permeability and density of polymer segments in We adsorption layer have been determined by ESR. The lower boundary of the hydrodynamic thickness of the polymer adsorption layer at the interface has been estimated from the dependences of _o and on the ionic strength.Translated fromIzvestiya Akademii Nauk. Seriya Khimicheskaya, No. 7, pp. 1653–1661, July, 1996.     

黄孢展齿革菌菌丝球同时吸附铅镉离子的动力学

采用间歇法，利用黄孢展齿革菌菌丝球吸附溶液中的Pb^2 和Cd^2 ，研究Pb^2 和Cd^2 共存体系中吸附初速率随初始浓度的变化规律。实验结果表明，少量Cd^2 的存在促进其对Pb^2 的吸附，并提高吸附初速率，但随着Cd^2 初始浓度的增加，促进作用逐渐减弱并转为抑制作用；Cd^2 的吸附初速率随着Pb^2 初始浓度增大而减小；Pb^2 和Cd^2 的吸附初速率都随自身初始浓度的增加而增大。     

Comments on surface structure analysis by water and nitrogen adsorption

Specific surface area and pore size distribution are determined usually from adsorption isotherms at low temperatures using nitrogen or noble gases. These are not absolute parameters and the measuring methods are fraught with serious difficulties. General problems of sorption measurements and recent developments are discussed. To obtain information for practical purposes these measurements need to be supplemented by investigations of the sorbate/sorbent system used in practice. Results of the measurement of nitrogen and water vapour adsorption on different materials are compared. This revised version was published online in July 2006 with corrections to the Cover Date.     

THE SEPARATION,PURIFICATION AND DECOLORIZATION OF NEW ANTIBIOTICS-MILUPEINAN USING ADSORPTION RESIN

1. INTRODUCTION Fig.1 The Chemical Structure of Milupeinan As a new type of antibiotics Milupeinan, not only possesses antibacterial activities against a wide range of Gram-positive and Gram-negative bacteria, but also higgh stability under th…     

聚四氟乙烯纤维辐照接枝制备弱酸性离子交换剂及其对Cu~(2+)的吸附

以聚四氟乙烯纤维为基体通过6 0 Co辐射引发与丙烯酸接枝制备弱酸性阳离子交换纤维 .产物功能基含量为 3 0 6mmol g,在pH =5时该纤维达到对Cu2 + 的最大动态吸附量为 10 7 4 8mg g.使用不同浓度HCl对饱和吸附铜的接枝纤维进行洗脱 ,证实该纤维对铜离子具有优异的解吸性能     

超临界状态下炭基材料的储氢

评介了目前各种储氢方法，指出了炭基材料作为储氢材料的优势，综述了近年来纳米炭材料在储氢方面的进展，详细探讨了超临界状态下氢气在纳米孔隙中的吸附机理，并在此基础上提出了研究中的问题及进一步的研究方向。     

Structural and Magnetic Study of N2, NO,NO2, and SO2 Adsorbed within a Flexible Single‐Crystal Adsorbent of [Rh2(bza)4(pyz)]n

The crystalline one‐dimensional compound, [Rh^II₂(bza)₄(pyz)]_n ( 1 ) (bza=benzoate, pyz=pyrazine) demonstrates gas adsorbency for N₂, NO, NO₂, and SO₂. These gas‐inclusion crystal structures were characterized by single‐crystal X‐ray crystallography as 1 ?1.5 N₂ (298 K), 1 ?2.5 N₂ (90 K), and 1 ?1.95 NO (90 K) under forcible adsorption conditions and 1 ?2 NO₂ (90 K) and 1 ?3 SO₂ (90 K) under ambient pressure. Crystal‐phase transition to the P space group that correlates with gas adsorption was observed under N₂, NO, and SO₂ conditions. The C2/c space group was observed under NO₂ conditions without phase transition. All adsorbed gases were stabilized by the host lattice. In the N₂, NO, and SO₂ inclusion crystals at 90 K, short interatomic distances within van der Waals contacts were found among the neighboring guest molecules along the channel. The adsorbed NO molecules generated the trans‐NO???NO associated dimer with short intermolecular contacts but without the conventional chemical bond. The magnetic susceptibility of the NO inclusion crystal indicated antiferromagnetic interaction between the NO molecules and paramagnetism arising from the NO monomer. The NO₂ inclusion crystal structure revealed that the gas molecules were adsorbed in the crystal in dimeric form, N₂O₄.     

Fixed-bed adsorption of carbon dioxide/methane mixtures on silicalite pellets

The adsorption of carbon dioxide and methane on silicalite pellets packed on a fixed bed has been studied. Equilibrium and kinetic measurements of the adsorption of carbon dioxide and methane have been performed, and a binary adsorption isotherm for carbon dioxide/methane mixtures has been obtained. A model based on the LDF approximation for the mass transfer has been used to describe the breakthrough curves obtained experimentally. A PSA cycle has been proposed for obtaining methane with purity higher than 98% from carbon dioxide/methane mixtures containing 38% and 50% methane, and its performance has been simulated using the proposed model. The simulation results show that silicalite can be a suitable adsorbent for employment in a PSA separation process for carbon dioxide removal from coalseam and landfill gases.