The absorption spectrum of phosphine (PH3) between 2.8 and 3.7 μm: Line positions, intensities, and assignments

Over 8000 line positions and intensities of phosphine (PH₃) at 3 μm have been measured at 0.0115 cm⁻¹ resolution with the McMath-Pierce Fourier Transform spectrometer at Kitt Peak. The observed line intensities ranged from 4.13 × 10⁻⁶ to 4.69 × 10⁻² cm⁻² atm⁻¹ at 296 K, for line positions between 2724.477 and 3601.652 cm⁻¹. This region spans eight interacting vibrational states: 3ν₂ (2940.8 cm⁻¹), 2ν₂ + ν₄ (3085.6 cm⁻¹), ν₂ + 2ν₄ (3214.9 cm⁻¹), ν₁ + ν₂ (3307.6 cm⁻¹), ν₂ + ν₃ (3310.5 cm⁻¹), 3ν₄ (∼3345 cm⁻¹), ν₁ + ν₄ (3426.9 cm⁻¹), and ν₃ + ν₄ (3432.9 cm⁻¹). Assignments have been determined for all the bands except 3ν₄ (a weak band in a highly congested area) for a total of 4232 transitions. The total integrated intensity for this region is 5.70 cm⁻² atm⁻¹ near 296 K, and assigned lines account for 79% of the observed absorption. The two strongest bands in the region are ν₁ + ν₄ and ν₃ + ν₄ with band strengths at 296 K of 1.61 and 2.01 cm⁻² atm⁻¹, respectively. An empirical database of PH₃ line parameters (positions, intensities, and assignments) is now available. Lower state energies (corresponding to assignments from this study) and line widths from the literature are included; default values are used for unassigned features.     

Bulk Sn1−xMnxO2 magnetic semiconductors without room-temperature ferromagnetism

Polycrystalline Sn_1−xMn_xO₂ (0≤x≤0.05) diluted magnetic semiconductors were prepared by solid-state reaction method and their structural and magnetic properties had been investigated systematically. The three Mn-doped samples (x=0.01, 0.03, 0.05) undergo paramagnetic to ferromagnetic phase transitions upon cooling, but their Curie temperatures are far lower than room temperature. The magnetization cannot be attributed to any identified impurity phase. It is also found that the magnetization increases with increasing Mn doping, while the ratio of the Mn ions contributing to ferromagnetic ordering to the total Mn ions decreases.     

A comparison between optically active CdZnSe/ZnSe and CdZnSe/ZnBeSe self-assembled quantum dots: effect of beryllium

The composition and size of optically active Cd_xZn_1−xSe/ZnSe quantum dots are estimated with a previously developed method. The results are then compared with those obtained for Cd_xZn_1−xSe/Zn_0.97Be_0.03Se QDs. We show that introducing Be into the barrier material enhances both Cd composition and quantum size effect of optically active quantum dots.     

The effects of crystal structure on optical absorption/photoluminescence of bis(8-hydroxyquinoline)zinc

In this paper, the transformation processes of two types of bis(8-hydroxyquinoline)zinc: Znq₂ dihydrate and anhydrous (Znq₂)₄ were investigated by X-ray diffraction (XRD), infrared spectra (IR), scanning electron microscope (SEM), differential scanning calorimetry (DSC) and thermogravimetry (TG). The effects of crystal structure on optical properties of bis(8-hydroxyquinoiline)zinc were analyzed. Znq₂ dihydrate can be transformed into anhydrous (Znq₂)₄ during heating under vacuum. Reversal transformation occurs by the interaction between chloroform and (Znq₂)₄. But (Znq₂)₄ was partially transformed into Znq₂ dihydrate by the interaction between ethanol and (Znq₂)₄. The different molecular structure results in different crystal stacking and electronic structure, thereby affect its optical properties.     

Low-loss, compact waveguiding with TE mode in metal/dielectric waveguides for planar lightwave circuit

We propose a low-loss metal/dielectric waveguide for compact planar lightwave circuit. The basic waveguide structure is a metal-defined high-index-contrast strip waveguide based on silicon/silica. As the guide is designed for TE single mode waveguiding, extremely low propagation loss (e.g. <0.04 dB/cm), very low bend loss (e.g. 0.0043 dB/90°-turn) and small waveguide pitch of zero-crosstalk are theoretically achievable, and can be further improved by compromising with component size and density. Examples of multi-bends and device integration are demonstrated with numerical simulations. The proposal is compatible with silicon technology and appealing for development of silicon-based planar lightwave circuit.     

Luminescent characteristics of CaTiO3:Pr thin films prepared by pulsed laser deposition method with various substrates

CaTiO₃:Pr³⁺ films were deposited on different substrates such as Al₂O₃ (0 0 0 1), Si (1 0 0), MgO (1 0 0), and fused silica using pulsed laser deposition method. The crystallinity and surface morphology of these films were investigated by XRD and SEM measurements. The films grown on the different substrates have different crystallinity and morphology. The FWHM of (2 0 0) peak are 0.18, 0.25, 0.28, and 0.30 for Al₂O₃ (0 0 0 1), Si (1 0 0), MgO (1 0 0), and fused silica, respectively. The grain sizes of phosphors grown on different substrates were estimated by using Scherrer's formula and the maximum crystallite size observed for the thin film grown on Al₂O₃ (0 0 0 1). The room temperature PL spectra exhibit only the red emission peak at 613 nm radiated from the transition of (¹D₂ → ³H₄) and the maximum PL intensity for the films grown on the Al₂O₃ (0 0 0 1) is 1.1, 1.4, and 3.7 times higher than that of the CaTiO₃:Pr³⁺ films grown on MgO (1 0 0), Si (1 0 0), and fused Sillica substrates, respectively. The crystallinity, surface morphology and luminescence spectra of thin-film phosphors were highly dependent on substrates.     

XYZ particles at Belle

In this paper, I review recent progress in the study of the XYZ particles at Belle. I only focus on studies with charmonium and one or more light mesons in the final states. This covers the X（3872）, X（3915）, Y（4140）, X（4350）, and the charged Z states.     

An asymmetric imidazole derivative as potential fluorescent chemosensor for Fe in aqueous solution

A novel conjugated molecule, L, based on 2,4,5-triphenylimidazole and 6-phenyl-2,2′-bipyridine (HC^∧N^∧N) was synthesized in two steps. The molecule can recognize Fe³⁺ in aqueous solution (THF/H₂O, 1/1, v/v) by the appearance of new emission bands at 416 and 442 nm, which can be attributed to the emission of the newly formed L-Fe³⁺ complex. The binding constant of the complex was calculated to be (6.6±0.39)×10³ M⁻¹, and its formation was also confirmed by the appearance of isosbestic points at 312 and 381 nm in the UV-visible spectral titration experiment. While other transition and rare-earth metal ions, such as Mn²⁺, Fe²⁺, Co²⁺, Ni²⁺, Zn²⁺, Cd²⁺, Hg²⁺, Pb²⁺, Eu³⁺ and Nd³⁺, can only cause some decrease of L's fluorescence, alkali and alkaline earth metal ions, such as Li⁺, Na⁺, K⁺, Mg²⁺ and Ca²⁺, almost have no effect on L's fluorescence. The fluorescence of L can be recovered by the addition of EDTA to the L-Fe³⁺ system just due to EDTA's stronger chelating ability than that of L.     

A roe-average algorithm for a granular-gas model with non-conservative terms

A Roe-average algorithm has been derived for a granular-gas model, proposed by Goldshtein and Shapiro [Goldshtein, Shapiro, Mechanics of collisional motion of granular materials: Part 1. General hydrodynamic equations, J. Fluid Mech. 282 (1995) 75–114], which contains non-conservative terms in the Euler-like hyperbolic governing equations apart from sink terms, which arise from inelastic collision of granules and are present only in the energy equation. The non-conservative terms introduce non-isentropic effects in acoustic-wave propagation within granular media and they also contribute to the Rankine–Hugoniot relations across a discontinuity. A Roe-average algorithm, based on the same granular-gas model, was derived in the literature [V. Kamenetsky, A. Goldshtein, M. Shapiro, D. Degani, Evolution of a shock wave in a granular gas, Phys. Fluids, 12 (2000) 3036–3049] which then required the implementation of a shock-fitting technique at a discontinuity. In the present work, Roe-averaged variables have been obtained from the Rankine–Hugoniot jump relations and the non-conservative terms have been incorporated in the numerical flux formula consistent with upwind principles associated with the granular speed of sound. Results for unsteady one-dimensional granular flows, colliding with a wall, demonstrate the capability of the proposed algorithm to capture strong shocks in addition to flow features not found in molecular gases, such as a fluidized region downstream of the shock and a compacted solid-block region adjacent to the wall.