射束有效宽度与成像系统MTF关系的研究

射线成像系统的射线有效宽度是评定系统成像分辨率的重要成像指标。以试验的方法,通过测试系统成像的MTF,通过对成像分辨率与射线有效宽度的关系进行研究,为射线数字成像(DR)及工业CT系统设计提供了参考。     

毛细管放电X光激光装置中的预脉冲电源

 针对目前毛细管放电X 光激光装置产生的预脉冲电流幅值过大、持续时间较短的问题，提出了增加预脉冲开关抑制原有预脉冲，再外加由脉冲成形网络组成的预脉冲发生器，产生所需预脉冲的改造方案。可在主脉冲来临之前产生幅度10~50A，持续时间约17μs的方波预脉冲电流，来满足毛细管放电泵浦类氖氩X光激光实验的需要。     

Formulation for XPS spectral change of oxides by ion bombardment as a function of sputtering time

XPS measurement revealed that the original state of TiO₂ was changed to Ti₂O₃ and TiO by ion bombardment. TiO₂ decreased and Ti₂O₃ increased at the initial stage. TiO increased at a later stage than Ti₂O₃. Each of them saturated after enough sputtering time.A formulation was proposed in order to explain the change of XPS spectra for oxides as a function of ion sputtering time. This formulation was based on reaction equations that contain two reduction processes (from TiO₂ to Ti₂O₃ and from Ti₂O₃ to TiO), and sputtering effects. Using four fitting parameters (two reduction coefficients, sputtering yield and information depth), the present formula was fitted to the experimental results. The fitting results agree satisfactorily with the experimental results. The calculation shows that the reduction coefficient from TiO₂ to Ti₂O₃ is about ten times larger than that from Ti₂O₃ to TiO. This calculation predicts that surface composition of an oxide that is changed by ion bombardment will reach a different value depending on its bulk composition. Moreover, the present formulation can determine the chemical states of compounds changed by ion bombardment.     

超稳Y沸石制备技术对沸石铝分布的影响 Ⅱ.均匀铝分布的超稳Y沸石的制备

对水热处理后得到的USY沸石作进一步的酸处理以及采用改进的氟硅酸盐溶液骨架富硅工艺,分别得到了经XPS剖面分析证实为铝分布均匀的超稳Y沸石HAY-Ⅰ和HAY-Ⅱ。IR分析表明,在酸处理过程中从USY沸石中去掉的那部分非骨架铝类与3690cm~(-1)处羟基有关,仍残留在HAY-Ⅰ沸石中的那部分非骨架铝类与3670cm~(-1)和3600cm~(-1)处羟基有关。XRD和化学分析表明HAY-Ⅰ沸石仍含有约50％的非骨架铝类,而HAY-Ⅱ沸石则基本上不含非骨架铝类,HAY-Ⅱ沸石还显示更高的结晶保留度。DTA分析表明,HAY-Ⅰ和HAY-Ⅱ两种沸石的热稳定性均高于USY沸石。     

室温下压致铁钴镍合金的bcc→hcp相变

 本文采用高压X光衍射方法在金刚石对顶压砧中在位地（in situ）研究了Fe₆₈Co₂₄Ni₈（wt%）合金在室温下的压致bcc→hcp结构相变和直到40.5 GPa的等温压缩行为。实验结果表明该合金在常压下为bcc结构，晶格常数a₀=(0.287 0±0.000 1) nm，体积V₀=(7.119±0.007) cm³/mol，密度ρ₀=(7.981±0.008) g/cm³；在20.9 GPa附近出现bcc→hcp结构相变，两相共存压力区约10 GPa，在此区域内有晶面间距d(002)_hcp=d(110)_bcc，且原子平面(002)_hcp//(110)_bcc，hcp相比bcc相体积减小(0.33±0.02) cm³/mol；高压相hcp结构的晶格参数比值c/a=1.608±0.004；相变后原子配位数的增加使得hcp相(002)平面内及(002)平面间的最近邻原子间距比bcc相最近邻原子间距分别增大约1.6%和0.5%；用Murnaghan状态方程对实验数据进行最小二乘法拟合，得到bcc相B₀=(130±13) GPa，B₀'=12.6±0.5；hcp相V₀=(6.62±0.04) cm³/mol，B₀=(243±21) GPa，B₀'=6.8±0.3；对于该合金的bcc→fcp相变时的结构转变机制做了详细的讨论。     

Structural phase transition in substituted La2CuO4 and Pr2CuO4−y

The structural phase transition from orthorhombic (T) phase to tetragonal (T′) phase in substituted La_2−x R _x CuO₄ (R = Pr, Nd, Sm, Eu and Gd) and T′ to T-phase in Pr_2−x M _x CuO_4−y (M = Sr, Ca) has been studied by X-ray diffraction technique. The T-phase of La₂CuO₄ is transferred to T′ phase abruptly atx=0.8, 0.4, 0.4, 0.3 and 0.4 respectively for substitution of Pr, Nd, Sm, Eu and Gd for La in La₂CuO₄ without evidence of the T* phase. The T′ structure of Pr₂CuO₄ (x = 0.0) gets transformed to the T* structure at 30% Ca doping (x=0.6) and then to the T structure at 50% Ca doping (x=1.0), while for Sr-contentx=0.0, 0.4 and 1.0 it shows T′, T* and T structure respectively.     

AFM, SEM and GIXRD studies of thin films of red polycarbazolyldiacetylenes

In this paper we report the results of a morphological and structural investigation on film properties of a soluble polydiacetylene, the poly[1,6-bis(3,6-dihexadecyl-N-carbazolyl)-2,4-hexadiyne] (polyDCHD-HS). The red films of this polymer, prepared by standard spin-coating techniques, revealed absence of linear dichroism and birefringence in contrast with the ordered mesophases detected by powder X-ray studies. In order to interpret the optical behavior of this polymer, we performed AFM and SEM studies of polyDCHD-HS films spun on hydrophylic and hydrophobic glass substrates. We found the presence of surfaces organized in rod-like particles, more regularly oriented on the hydrophylic substrate. GIXRD studies, carried out on films sufficiently thick to allow the observation of the diffraction pattern, reveled the presence of a lamellar structure with a spacing of 3.22 nm. The low intensity of the diffraction peaks and the isotropic linear optical properties of the films show that the lamellar mesophases are not extended over large areas. These findings were compared with the data obtained from AFM and SEM studies on films of two other polydiacetylenes, the poly[1-(3,6-dihexadexyl-N-carbazolyl)-6-(N-carbazolyl)-2,4-hexadyine] (polya-DCHD) and the poly[1,6-bis(3,6-dipalmitoyl-N-carbazolyl)-2,4-hexadyine] (polyDPCHD), spun on hydrophylic glass substrate. The results confirmed the presence of nodular morphologies which seem to be a general characteristic of this class of materials. The particles organization appears instead related to the chemical nature of the substituents on the carbazolyl rings.     

Construction of self-assembled monolayer terminated with N-heterocyclic carbene-rhodium(I) complex moiety

Functionalization of self-assembled monolayer (SAM) of alkanethiolate with metal containing unit is one of the versatile methods to obtain functional surfaces such as heterogeneous catalysts. However, organic molecules that strongly bind to transition metals at SAM terminal are limited. Recently N-heterocyclic carbenes (NHCs) such as cyclic diaminocarbenes have emerged as strongly σ-donating ligands forming a robust bond with broad spectrum of transition metals. In the present study, for the purpose of establishment of a new robust basement for heterogeneous metal catalysts, a SAM of the alkanethiolate terminated with NHC-rhodium(I) complex moiety was prepared by utilizing a newly designed disulfide molecule bearing NHC-metal complex terminals. X-ray photoelectron spectroscopy (XPS) analysis and angle resolved XPS measurement revealed successful formation of the Rh-complex-terminated SAM on a gold substrate. Infrared reflection absorption spectroscopy (IRRAS) analysis suggested that the linker methylene chains connecting the rhodium complex moiety and the gold surface are in a loosely packed structure. This unique chemical species, NHC, would be a promising candidate as a basement for the construction of functional surface.     

Nuclear Excitation by X-Ray Emission of Femtosecond Laser Plasma

The proposed model of laser plasma emission spectrum formation enables us to determine the absolute value of the laser pulse to plasma emitted radiation conversion factor, profile of the emission spectrum, and frequency distribution of the intensity and energy in the emitted spectra. This is of interest for laser plasma diagnostics and provides a means for direct calculation of the number of excited nuclei in dependent on the parameters of laser pulse. This revised version was published online in August 2006 with corrections to the Cover Date.     

Local algorithms in exterior tomography

Exterior tomographic data are taken over lines outside a central region, and such data occur in the industrial nondestructive evaluation of large objects such as rockets. We explain, using microlocal analysis, which singularities are well reconstructed from exterior data, and we explain how this phenomenon is reflected in the singular value decomposition for the exterior transform [E.T. Quinto, Singular value decompositions and inversion methods for the exterior Radon transform and a spherical transform, J. Math. Anal. Appl. 95 (1983) 437–448]. We extend Lambda Tomography to exterior data and to limited angle exterior data. The algorithm is tested on industrial data from Perceptics, Inc.