刚柔相嵌液晶高分子的赝二级相变温度

讨论了刚柔相嵌液晶高分子的向列相一各向同性相转变与其分子结构的关系．给出了该一级相变的赝二级相变温度Ｔ＊与这类液晶高分子的液晶基元和间隔基的长度、柔顺性（相关长度）以及它们之间的相互作用的关系的解析表示式．分析了液晶基元与间隔基连接处的表观弯曲（接口效应）对Ｔ＊的影响．文中的结论与实验相符．     

Long-range magnetic ordering of quasi-one-dimensional S=1/2 Heisenberg antiferromagnet Sr2Cu(PO4)2

Magnetic properties of quasi-one-dimensional S=1/2 Heisenberg antiferromagnet Sr₂Cu(PO₄)₂ were investigated by temperature and field dependence of AC susceptibility down to 0.03 K. A sharp peak was observed at on the temperature dependence of AC susceptibility indicating long-range magnetic ordering. Taking into account the exchange constant, (Hamiltonian =J∑S_iS_i+1), the ratio k_BT_N/J is 0.06%. Sr₂Cu(PO₄)₂ is, therefore, one of the best one-dimensional Heisenberg antiferromagnet known so far.     

Transport properties of separating membranes MF-4SK during alkaline electrolysis of water

The transport properties of separating membranes MF-4SK are studied during electrolysis of H₂O in solutions of KOH. The effective diffusion coefficients of molecules of KOH and H₂O and the transfer coefficients of ions K⁺ and OH^? and molecules of H₂O are measured at KOH concentrations reaching 11 M, currents reaching 0.31 A cm^?2, at ambient temperature and at 80°C. In contact with a KOH solution in the concentration interval 0.1 to 11 M, the membranes that initially swelled in H₂O lose a considerable fraction of water that was present in them and the overall volume of clusters and solution-filled channels in them noticeably decreases. The coefficients of transfer by current of ions K⁺ out of anodic compartment into cathodic and the OH^? ions in the reverse direction, respectively, happen to be equal to about 0.6 and 0.4 at ambient temperature and 0.8 and 0.2 at 80°C. The coefficients of transfer of water molecules out of the anodic volume into the cathodic volume in the process of electrolysis happen to be in the limits 1.6–1.9 at ambient temperature and in the limits 2.2–2.8 at 80°C. The effective diffusion coefficients of molecules of KOH and H₂O at moderate concentrations of KOH (5.6 M) amount to ～2.6 × 10^?7 and 30 × 10^?7 cm²s^?1 at ambient temperature and ～4 × 10^?7 and 61 × 10^?7 cm²s^?1 at 80°C, respectively. At a high concentration of KOH (～10 M) these quantities substantially diminish.     

Flow system to gas capture from a nebulized solution

The use of aerosol produced in a nebulization chamber is proposed as an alternative to gas sample capture in flow systems. This paper describes the coupling of a sampling interface with a flow system, for in situ gas monitoring. Aspects related with the behavior of aerosol formation and gas solubilization in liquid drops are discussed. The method is applied to the determination of residual lime in acidic soils. Aliquots of 5.0 ml of 1.0 mol l⁻¹ HCl were mixed with soil samples (1 g). The CO₂ released from these samples was captured by a nebulized aerosol and determined conductivity. The analytical curve from 1.0×10⁻² to 5.0×10⁻² mol kg⁻¹ CaCO₃ was ploted applying the matrix matching approach. This proposition, allowed an increase in the sensibility with detection limit of 6.0×10⁻³ mol kg⁻¹. The precision was good (R.S.D. <3%) for an analytical frequency of 22 determinations per hour. A fair agreement, at 95% confidence level, was found between the results from the proposed method and certified values of the investigated samples.     

Epoxy‐functionalized,low‐glass‐transition‐temperature latex. II. Interdiffusion versus crosslinking in the presence of a diamine

This article describes the results of experiments examining the competition between the polymer diffusion rate and the crosslinking rate in low‐glass‐transition‐temperature, epoxy‐containing latex films in the presence of a diamine. We examined films formed from donor‐ and acceptor‐labeled poly(butyl acrylate‐co‐methyl methacrylate‐co‐glycidyl methacrylate) copolymer latex and studied the influence of several parameters on the growth rate of gel content and the rate of polymer diffusion. These factors include the molecular weight of the latex polymer, the presence or absence of a diamine crosslinking agent, and the cure protocol. The results were compared to the predictions of a recent theory of the competition between crosslinking and polymer diffusion across interfaces. In the initially formed films, polymer diffusion occurs more rapidly than the chemical reaction rate. Therefore, these films fall into the fast‐diffusion category of this model. In our system (unlike in the model), the latex polymer has a broad distribution of molecular weights and a distribution of diffusivities. The shortest chains contribute to the early time diffusion that we measure. At later stages of our experiment, slower diffusing species contribute to the signal that we measure. The diffusion time decreases substantially, and we observe a crossover to a regime in which the chemical reaction dominates. The increases in chain branching and gel formation bring polymer diffusion to a halt. © 2002 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 40: 4098–4116, 2002     

Analysis of B3LYP and MP2 conformational population distributions in trans‐nicotine,acetylcholine, and ABT‐594

This work presents an analysis of the equivalence of MP2 and DFT (B3LYP functional) conformational populations. As a test case, we select three cholinergic agents (trans‐nicotine, acetylcholine, and the nicotinic analgesic ABT‐594), where the minima on the conformational energy hypersurfaces expand a large range of energies (～0–30 kJ mol^?1). From energetic and structural data obtained in vacuo at the MP2 and B3LYP/cc‐pVDZ levels, we build conformational partition functions, including the effect of the conformational kinetic energy and the rotovibrational coupling. Our results at a physiological temperature (37°C) show qualitative agreement in all cases. Quantitative agreement, however, is only found for trans‐nicotine and ABT‐594. In the first case, energy minima differ by <0.2 kJ mol^?1. Therefore, the equivalence of structural results translates in the equivalence of the conformational distribution. For ABT‐594, the minima are separated by as much as 8.0 kJ mol^?1, and the conformational energy determines the conformational distribution. In this case, the slight relative variation of conformational energy, between B3LYP and MP2, does not affect the population, since the secondary minima are high in energy and very low in population. © 2005 Wiley Periodicals, Inc. Int J Quantum Chem, 2005     

Methods for research on immune complement activation on modified sensor surfaces

We have developed a methodological system consisting of a new surface sensitive quartz crystal microbalance with dissipation monitoring (QCM-D) sensor surfaces together with different surface modification methods for the investigation of surface associated complement activation in human sera. The QCM-D surface, 10 mm in diameter, was modified by spin-coating of poly(urethane urea) (PUUR) and polystyrene (PS). Some sensor surfaces were also sputtered with titanium (Ti) or modified by hydrophobic self-assembled monolayer (SAM) of an 18-carbon alkane thiol with a ---CH₃ end group. The amount of surface deposited complement protein was investigated by incubation of the modified sensor surfaces in human sera, followed by incubation with antibodies directed against complement factor 3c (C3c). The amounts of bound anti-C3c were then used as an arbitrary measure of surface induced complement activation. The order of complement activation of the different surfaces, as judged by three separate measurements per surface modification, was PUUR>PS=SAM>Ti. The Ti surface had a similar low degree of anti-C3c binding as the negative controls (heat inactivated sera). The novel QCM-D methodology was found to be very simple, accurate, sensitive and well suited as a screening method for complement activation and protein adsorption on different materials. We also compared the sensitivity of QCM-D method with surface plasmon resonance (SPR) for the quantification of protein adsorption and complement activation on gold sensor surfaces. The QCM-D method was equally sensitive as the SPR for the detection of protein adsorption from a solution independently if low flow rate (5 μl/min) was used. A slight increase in sensitivity was found at higher flow rate (30 μl/min). However, we found it difficult to use the SPR method on the Ti, PS and PUUR surfaces due to decreased light penetration of the modified SPR sensor chip.     

Über Reaktionen von Arylbiguaniden mit Benzoin beimpH der Biguanidbasen

Summary Arylbiguanides2 a–e react with benzoin (1) at thepH of the base to two different products.1 undergoes in presence of the base2 a–e oxidation to benzil and benzoic acid, which reacts fast with the arylbiguanides2 a–e to yield N-[4-(arylamino)-6-phenyl-1,3,5-triazine-2-yl]benzamides3 a–d. After lowering thepH of the reaction mixture, the bases2 b–e react with benzil to yield 2-[1-aryl-5-oxo-4,4-diphenyl-2-imidazoline-2-yl]guanidine4 b–e. The mechanism of the formation is discussed. The structure of4b was established from a single crystal x-ray structure analysis. The analysis was carried out at 100K: C₂₃H₂₁N₅O,M _r=383.5, monoclinic, C 2/c,a=15.842(6),b=8.419(3),c=30.223(10) Å, =98.44(3)°,V=3 987.3(9) ų,Z=8,d _x=1.277 g/cm³, =0.81 cm^–1,R=5.89%R _w=4.97% (1 537 observations, 233 parameters).

     

水／AOT／正庚烷微乳体系中磺酸根水化作用的FT—IR研究

运用傅立叶变换红外光谱（FT－IR）对水／琥珀酸（乙基已基）磺酸钠（AOT）／正庚烷微乳体系中磺酸根的水化作用进行了研究．由于微乳体系中水分子与表面活性剂分子的相互作用，S＝O对称伸缩振动的红外吸收峰向低频方向移动．体系中的加水量W0（水与AOT的摩尔比）由0.5增大至25时，磺酸根对称伸缩振动的红外吸收峰由1051．39cm－1向低频移动至1046．15cm－1．同时，由于Na 的不对称作用，AOT分子中磺酸根反对称伸缩振动分裂成两个吸收峰，分别位于正215cm-1及1245cm－1附近，两个劈裂峰的距离及各自的峰面积均随体系中加水量的变化而变化，应用二阶导数、傅立叶退卷积及曲线拟会等分辨率增强技术可更清楚地反映出这个二重峰的变化情况．固体AOT分子中碳酸根反对称伸缩振动分裂的两个峰之间频率的差值约为42cm－1，形成微乳液以后，这两个峰的差值变小，W0为20时，这两个峰频率的差值逐渐减小到29cm-1，这些变化与磺酸根的水化程度直接相关     

超临界萃取装置的研制及其应用

超临界流体萃取是近的上来兴起的一种新的分离技术，报道了将超临界萃取原理与回流技术相结合研制的二氧化碳回流中低压超临界流体萃取设备，解决了关键实验手段，通过应用证明设备可靠，费用低廉，有实用价值。