超子中子星性质的温度效应

从相对论平均场理论出发,考虑核子、超子和介子的相互作用,研究了温度对中子星组成粒子、状态方程和中子星质量等的影响.发现温度越高,超子在中子星内部出现时的重子数密度越低.当密度较高时,中子星的核心区主要由超子组成,即中子星转变成以奇异粒子为主要成分的超子星,并且这种转变受到温度的影响,温度越高,转变密度越低.由于超子的出现,中子星核心高密度区域的状态方程,对于不同温度,差别不大,所以有限温度中子星的最大质量都在1.8M_⊙附近.这与观测结果相符.     

Normalized LMS digital filter for chromatic dispersion equalization in 112-Gbit/s PDM-QPSK coherent optical transmission system

High bit rates optical communication systems pose the challenge of their tolerance to linear and non-linear fiber impairments. Coherent optical receivers using digital signal processing techniques can mitigate the fiber impairments in the optical transmission system, including the chromatic dispersion equalization with digital filters. In this paper, an adaptive finite impulse response filter employing normalized least mean square algorithm is developed for compensating the chromatic dispersion in a 112-Gbit/s polarization division multiplexed quadrature phase shift keying coherent communication system, which is established in the VPI simulation platform. The principle of the adaptive normalized least mean square algorithm for signal equalization is analyzed theoretically, and at the meanwhile, the taps number and the tap weights in the adaptive finite impulse response filter for compensating a certain fiber chromatic dispersion are also investigated by numerical simulation. The chromatic dispersion compensation performance of the adaptive filter is analyzed by evaluating the behavior of the bit-error-rate versus the optical signal-to-noise ratio, and the compensation results are also compared with other present digital filters.     

热电联产中热、电分摊比的合理确定

符号表D蒸汽量HF燃料热值W电量下角标h供热比拥m煤耗。分摊比e环境，电n乏汽h比烙q比热量f给水0新汽在热电联产的成本分摊中，如何确定热、电分摊比，一直是一个很有争议的问题［‘－‘］。采用不同分摊方法，其热、电所得的经济效益相差甚大。因此，它直接关系到热力价格的合理制定，影响着供热企业的经济效益和热用户的利益，对热电联产事业的发展有着重要影响。本文在分析现有各种分摊方法的基础上，提出一个新的更为合理的分摊方法。1现有的分摊方法及其缺陷和应用范围1．1热量法将总热耗量按热、电两种能量数量的比例来分配［‘－‘…     

Single-machine scheduling with time-and-resource-dependent processing times

We consider single-machine scheduling problems in which the processing time of a job is a function of its starting time and its resource allocation. The objective is to find the optimal sequence of jobs and the optimal resource allocation separately. We concentrate on two goals separately, namely, minimizing a cost function containing makespan, total completion time, total absolute differences in completion times and total resource cost; minimizing a cost function containing makespan, total waiting time, total absolute differences in waiting times and total resource cost. We show that the problems remain polynomially solvable under the proposed model.     

A directed topic model applied to call center improvement

We propose subject matter expert refined topic (SMERT) allocation, a generative probabilistic model applicable to clustering freestyle text. SMERT models are three‐level hierarchical Bayesian models in which each item is modeled as a finite mixture over a set of topics. In addition to discrete data inputs, we introduce binomial inputs. These ‘high‐level’ data inputs permit the ‘boosting’ or affirming of terms in the topic definitions and the ‘zapping’ of other terms. We also present a collapsed Gibbs sampler for efficient estimation. The methods are illustrated using real world data from a call center. Also, we compare SMERT with three alternative approaches and two criteria. Copyright © 2015 John Wiley & Sons, Ltd.     

Optimal mean–variance investment and reinsurance problems for the risk model with common shock dependence

In this paper, we study the optimal investment–reinsurance problems in a risk model with two dependent classes of insurance business, where the two claim number processes are correlated through a common shock component. Under the criterion of mean–variance, two cases are considered: One is the optimal mean–variance problem with bankruptcy prohibition, i.e., the wealth process of the insurer is not allowed to be below zero at any time, which is solved by standard martingale approach, and the closed form solutions are derived; The other is the optimal mean–variance problem without bankruptcy prohibition, which is discussed by a very different method—stochastic linear–quadratic control theory, and the explicit expressions of the optimal results are obtained either. In the end, a numerical example is given to illustrate the results and compare the values in the two cases.     

Experimental Investigation of the Effect of Purge Flow and Main Flow Interaction in a Low-Speed Turbine Cascade Passage

In order to protect the vulnerable turbine components from extreme high temperature, coolant flow is introduced from the compressor to the disk cavity, inevitably interacting with the main flow. This paper describes an experimental investigation of the interaction between the main flow and the purge flow in a low-speed turbine cascade with three purge flow rates, Cm = 0, Cm = 1%, and Cm = 2%. In order to study the effect of the interaction between the main flow and the purge flow on the secondary flows, a Rortex method developed by Liu Chaoquan is introduced to identify the vortex in the flow field. In the meantime, a method to calculate the mean entropy production rate based on the particle image velocimetry (PIV) result is adopted to investigate the flow loss. The PIV result indicates that the purge flow has a prominent impact on the flow field of the cascade passage, changing the velocity distribution that induces a local blockage area. The results of vortex identification show that the purge flow promotes the generation of the passage vortex near the suction side. In addition, the purge flow makes the passage vortex migrate to the tip wall direction, enlarging the region affected by the secondary flow. The mean entropy production (MEP) result shows that the flow loss is mainly caused by the passage vortex. The coincidence of the high-MEP region and the location of the passage vortex indicates that the purge flow increases the secondary flow loss by affecting the formation and the migration of the passage vortex.     

Robust reward–risk ratio optimization with application in allocation of generation asset

In this article, we study reward–risk ratio models under partially known message of random variables, which is called robust (worst-case) performance ratio problem. Based on the positive homogenous and concave/convex measures of reward and risk, respectively, the new robust ratio model is reduced equivalently to convex optimization problems with a min–max optimization framework. Under some specially partial distribution situation, the convex optimization problem is converted into simple framework involving the expectation reward measure and conditional value-at-risk measure. Compared with the existing reward–risk portfolio research, the proposed ratio model has two characteristics. First, the addressed problem combines with two different aspects. One is to consider an incomplete information case in real-life uncertainty. The other is to focus on the performance ratio optimization problem, which can realize the best balance between the reward and risk. Second, the complicated optimization model is transferred into a simple convex optimization problem by the optimal dual theorem. This indeed improves the usability of models. The generation asset allocation in power systems is presented to validate the new models.     

White and some colored marbles as alternative radiation shielding materials for applications

ABSTRACT

In this paper, the radiation shielding parameters such as linear attenuation coefficients (LAC, µ), mass attenuation coefficients (MAC, µ/ρ), effective atomic numbers (Z_eff), effective electron densities (N_eff), half value of layers (HVL), mean free paths (MFP) and buildup factors (exposure (EBF) and energy absorption (EABF)) were investigated for cream (M1), pink (M2), white (M3), maroon (M4) and green (M5) marbles. Attenuation coefficients were measured in the energy region 31.18–661.66 keV photon energies. The values of Z_eff and N_eff were then calculated using these coefficients with logarithmic interpolation method, and HVLs and MFPs were calculated using the values of LAC of marble samples at the same photon energies. The experimental results were compared with the theoretical values obtained from WinXCom program, and good agreements were observed between the experimental and theoretical results. HVLs and MFPs of all marble samples were compared with those of some concretes, glasses and commercial radiation shielding glasses (SCHOTT Co.). The studied marbles were better radiation shielding materials than standard shielding concretes due to lower HVL and MFP values lower than the ordinary concrete. Finally, EBFs and EABFs of the marbles were calculated in the energy region 0.015–1?MeV up to penetration depths of 40 mfps by Geometric Progression method (G-P), and the results were discussed in terms of photon energies and chemical compositions of the marbles.     

多釜串联模型停留时间分布方差的推导

简要分析了理想反应器的特点,并指出现实反应器与理想反应器的区别,介绍了多釜串联模型描述实际反应器的思想.针对多釜串联模型的停留时间分布的计算函数进行逐步的推导,以阶跃法对模型进行分析,采用数学归纳法和分部积分法等方法推导出了多釜串联模型无因次停留时间分布函数表达式;根据停留时间分布密度函数定义,推导出了无因次停留时间分布密度函数的表达式;根据概率中方差的定义,推导出了无因次方差的表达式.