Optical parametric chirped pulse amplification based on photonic crystal fibre

A compact two-stage optical parametric chirped pulse amplifier based on photonic crystal fibre is demonstrated.A 1064-nm soliton pulse is obtained in a home-made photonic crystal fibre (PCF) with femtosecond pulse pumping and then amplified to 2 mJ in an Nd:YAG regenerative amplifier.After the amplified pulses pass through the LBO crystal,the 532-nm double-frequency light with an energy of 0.8 mJ and a duration of over 100 ps at 10-Hz repetition rate is generated as a pump source in the following two-stage optical parametric amplification (OPA).The 850-nm chirped signal light gain from the stretcher is 1.5×10 4 in the first-stage OPA while it is 120 in the second-stage OPA.The total signal gain of optical parametric chirped pulse amplification (OPCPA) can reach 1.8×10 6.     

一种光纤F-P声发射传感器的设计与实现

为克服压电陶瓷传感器易受电磁干扰、不能实现长期实时检测的缺点,提出了光纤非本征F-P结构测量声发射信号的思想.对光纤非本征F-P腔声发射测量原理进行分析,提出了双波长的稳定方法,并进行了结构参量的优化设计,确定了合适的反射比、波长及F-P腔长.理论分析和实验结果表明：所设计的非本征F-P光纤声发射传感器具有良好的敏感性和高分辨率.     

三段加热系统对大尺寸MPOF预制棒一步拉伸工艺

采用自行设计的微结构聚合物光纤专用拉丝系统对大尺寸微结构聚合物光纤预制棒的一步拉伸工艺进行了研究.该微结构聚合物光纤加热系统采用三段式梯度加热,可保持炉内温度的控制准确度在±2℃以内.在保持送料速度与牵引速度恒定、协调的条件下,通过对温度场温度梯度控制优化,确定了最佳拉丝温度组合,并得到了直径规格310 μm、标准偏差为±20 μm的较高质量的微结构聚合物光纤.     

氢化物发生原子荧光法测定钢铁中微痕量碲

碲是钢铁的微痕量有害杂质,易引发晶间脆化和微裂纹,降低材料的力学与抗疲劳性能,危及船海装备的服役安全,需要准确快速的检测和控制。原标准方法GB/T 223.55—2008《钢铁及合金碲含量的测定示波极谱法》使用滴汞电极,存在局部汞富集与危及人员健康和水体环境的风险。伴随《关于汞的水俣公约》在国内外的全面生效,该方法已于2017年废止。钢铁中碲的检验迫切呼唤绿色环保、准确快速的分析方法。基于碲可被新生态氢还原为易挥发氢化物的特点,采用氢化物发生进样技术从基体溶液中高选择性地分离和富集碲,并联用原子荧光法测定钢铁中微痕量碲。实验优化了负高压、灯电流、观察高度、载气流量、屏蔽气流量等光谱仪的工作参数,研究确定了消解用酸、试液介质、溶液酸度、载流酸度与硼氢化钾浓度等氢化物发生条件,系统考察了铁基体与铬、镍、锰、铜、钼、钨、钛、硅、钒等共存离子的干扰效应及掩蔽方法。确定的条件参数如下,负高压：360 V,灯电流：70～80 mA,观察高度：7～8 mm,载气流量：700 mL·min^-1,屏蔽气流量：700～800 mL·min^-1,试液介质：15%盐...     

复发性阿弗他溃疡与相关的营养因素研究进展

以国内外研究复发性阿弗他溃疡营养因素的相关论文为依据,综述了近十年有关对复发性阿弗他溃疡（RAU）营养因素的研究进展。包括：RAU与微量元素锌、铁、硒、铜,维生素A、C、E、B2、B12,蛋白质,膳食纤维和谷类的关系。RAU的发生与体内微量元素锌、铁、硒、铜的减少,维生素A、C、E、B2、B12,蛋白质和膳食纤维的摄取不足密切相关,全谷类食品（功能稻米）对缓解RAU有帮助。     

Potassium selective chromoionophores

The ionisable chromoionophores5 were synthesised from simple precursors. These chromoionophores extract alkali metal cations from aqueous solutions at pH > 7 into dichloromethane. The ratio of extraction coefficients for the chromoionophore5c for K⁺ and Na⁺ indicate that it has potential for use in optical fibre sensors for K⁺ in the presence of Na⁺, Mg²⁺ and Ca²⁺ at extracellular concentrations.This paper is dedicated to the memory of the late Dr C. J. Pedersen.     

Turbulent flow through bifurcated nozzles

A finite-element model has been used to study steady-state turbulent flow through bifurcated submerged-entry nozzles with oversized ports typical of those used in the continuous casting of steel. Both 2D and 3D simulations have been performed with the commercial code FIDAP, using the standard K–? turbulence model. Predicted velocities from 3D simulations compare reasonably with experimental measurements using a hot-wire anemometer conducted in a physical water model, where severe turbulent fluctuations are present. Results show that a 2D simulation can also capture the main flow characteristics of the jet existing the nozzle and requires two orders of magnitude less computer time than the 3D simulation. A model combining the nozzle and mould was set up to study the effect of the outlet boundary conditions of the nozzle on the jet characteristics. This modelling technique will assist in the design of submerged-entry nozzles, especially as applied to enhance steel quality in the continuous casting process. Further, the model will provide appropriate inlet boundary conditions for a separate numerical model of the mould.     

Compensation for depolarisation by a fibre coil in the presence of self-phase modulation

We report on the dependence of the degree of polarisation of an 80 fs pulsed laser beam propagating through a length of a single-mode birefringent fibre on the illumination power. Due to the birefringence and the nonlinear effect of self-phase modulation, the measured depolarisation dependence is oscillatory. It is, however, demonstrated that the oscillatory depolarisation can be compensated for by introducing a loop into the fibre geometry, which maintains the degree of polarisation of the pulsed beam as high as 90%.     

Plasma-polymerized thiophene films for enhanced rubber-steel bonding

Thin films of plasma-polymerized thiophene (PPTh) were deposited on cold-rolled steel substrates to improve adhesion to rubber compounds. PPTh films were characterized by X-ray photoelectron spectroscopy, Fourier transform infrared spectroscopy (FT-IR) and atomic force microscopy. The ratio of carbon-to-sulfur found in PPTh films is 4:1, suggesting the monomer structure is generally intact, which was supported by FT-IR absorptions characteristic of polymerized thiophene rings. However, some fragmentation did occur to give acetylenic and aliphatic groups. Steel-rubber adhesion measurements, performed in accordance with the ASTM 429-B peel test, strongly depended on cleaning and pretreatment methods as well as film thickness. Best results were obtained on polished steel samples that were cleaned with acid, pretreated with a hydrogen/argon plasma, then coated with 50 Å of PPTh film. These samples exhibited a peel force of 14.3 N/mm, which is comparable to that of polished brass control samples. Depth-profiling XPS analysis of the rubber-steel interface showed the existence of an iron sulfide layer which is likely responsible for the strong adhesion.     

Berry联络与吴－杨单极势

通过研究一半整数自旋值的中性粒子在球对称磁场中的Ｂｏｒｎ－Ｏｐｐｅｎｈｅｉｍｅｒ方程，发现在自旋空间Ｂｅｒｒｙ联络呈非阿贝尔形式．在绝热近似下，Ｂｅｒｒｙ联络相当于阿贝尔形式的吴－杨单极场．由于拓扑的非平庸性，利用纤维丛中截面的概念研究了位形空间的动力学，发现中心势场中粒子的角动量和能量均取量子化值，但数值发生移动，这是纯几何起源的现象．