Thermal oxidation of cellulose investigated by chemiluminescence. The effect of magnesium and calcium carbonates and of different pHs

Whatman cellulose impregnated with calcium and magnesium carbonates was oxidized and chemiluminescence accompanying this oxidation has been measured. It was shown that magnesium ions in deacidified cellulose pulp promote the light emission significantly. On the other hand, acid papers give the more pronounced light signals at temperatures close to ambient. The relation between chemiluminescence runs and paper degradation has been implicated, with an attempt to extrapolate half-lives of paper samples to conditions close to ambient. To cite this article: J. Rychlý et al., C. R. Chimie 9 (2006).     

甲烷氧化偶联W-Mn/SiO2催化剂上O2-脉冲频率效应(PFE)的研究

采用频率脉冲反应方法,以Mn-Na2WO4/S iO2催化剂上甲烷氧化偶联为探针反应,通过实时、原位的四极质谱检测手段,研究氧物种对甲烷C-H键选择性活化的微观历程.首次发现了Mn-Na2WO4/S iO2催化剂上O2-脉冲频率效应,即脉冲反应产物量随氧脉冲注入频率的增加而增加.研究结果表明,在反应条件下,Mn-Na2WO4/S iO2催化剂上有两种活化甲烷的氧物种同时存在,它们活化甲烷的方式不同。     

Synthesis and properties of LiMIIPO4 (MII = Mg,Mn0.5Mg0.5, Co0.5Mg0.5) affected by isodivalent doping and Li-sources

NH₄M^IIPO₄·H₂O (M^II = Mg, Mn_0.5Mg_0.5, Co_0.5Mg_0.5) were synthesized by direct-precipitating method. The olivine-like LiM^IIPO₄ were successfully generated through the solid state reaction between the synthesized NH₄M^IIPO₄·H₂O precursors and two different Li-sources (Li₂CO₃ or LiOH·H₂O). The NH₄M^IIPO₄·H₂O and LiM^IIPO₄ compounds were confirmed by TG/DTG/DTA, AAS/AES, FTIR and XRD methods. The structural and morphological properties of LiM^IIPO₄ compounds were studied by XRD and SEM, respectively. The XRD reflection shifts of olivine-like LiM^IIPO₄ from the Li-source of Li₂CO₃ revealed changing toward higher diffraction angles than that of LiM^IIPO₄ from the Li-source of LiOH·H₂O. The XRD shifts of LiM_0.5Mg_0.5PO₄ (M = Mn or Co) compounds confirmed the formation of the single phase of isodivalent doping of Mn²⁺ and Co²⁺ ions according to the change in the lattice parameters and cell volumes. The morphological investigations of the LiM^IIPO₄ obtained from Li₂CO₃ system illustrated the grain-like shape particles having smaller size of about 150–400 nm on account of the sequential transformations of types: deammoniation, dehydration, polycondensation and decarbonization. Conversely, the larger size particles (300–700 nm) of the LiM^IIPO₄ obtained from LiOH·H₂O were observed due to the shorter transformation path through the reactions of types: deammoniation and dehydration without polycondensation and decarbonization.     

BF_3·OEt_2对钼体系催化合成1,2-聚丁二烯的影响

在以加氢汽油为溶剂,MoCl_3(C_7H_(15)COO)_2(Mo)为主催化剂,(i-Bu)_2AlO〈O〉(Al)为助催化剂合成1,2-聚丁二烯的二元催化体系中,添加BF_3CH3·OEt_2等,对体系的催化活性影响显著。以的混合物为第三组份加入催化体系,较大幅度提高了钼系催化体系的活性。在Mo/Bd=8.0×10~(-5)(摩尔比),聚合5小时,丁二烯转化率可达到70％。初步搞清了钼催化体系合成的1,2-聚丁二烯中产生凝胶的条件,推测了凝胶的生成原因,考察了聚合条件对催化活性、分子量及微观结构含量的影响。     

Adsorption and photochemical behaviors of the novel cationic xanthene derivative on the clay surface

Novel tetra-cationic xanthene derivative (Flu) was synthesized. Its adsorption and photochemical behaviors on the clay surface were investigated. Fluorescence quantum yield (?_f) and fluorescence lifetime were 0.50 and 2.9 ns for Flu/clay complex. ?_f of Flu was enough high (>0.1) even at high density conditions (0.080 molecules nm⁻²). It is supposed that the strong interaction between clay and Flu by the ‘Size-Matching Effect’ realizes the highly emissive clay complexes at high density adsorption condition by a suppression of a molecular aggregation, which tends to decrease the photochemical activity.     

Beyond microstructures: Using the Kerr Effect to characterize the macrostructures of synthetic polymers

The macrostructures of synthetic polymers are essentially the complete molecular chain architectures, including the types and amounts of constituent short‐range microstructures, such as the regio‐ and stereosequences of the inserted monomers, the amounts and sequences of monomers found in co‐, ter‐, and tetra‐polymers, branching, inadvertent, and otherwise, etc. Currently, the best method for characterizing polymer microstructures uses high field, high resolution ¹³C‐nuclear magnetic resonance (NMR) spectroscopy observed in solution. However, even ¹³C‐NMR is incapable of determining the locations or positions of resident polymer microstructures, which are required to elucidate their complete macrostructures. The sequences of amino acid residues in proteins, or their primary structures, cannot be characterized by NMR or other short‐range spectroscopic methods, but only by decoding the DNA used in their syntheses or, if available, X‐ray analysis of their single crystals. Similarly, there are currently no experimental means to determine the sequences or locations of constituent microstructures along the chains of synthetic macromolecules. Thus, we are presently unable to determine their macrostructures. As protein tertiary and quaternary structures and their resulting ultimate functions are determined by their primary sequence of amino acids, so too are the behaviors and properties of synthetic polymers critically dependent on their macrostructures. We seek to raise the consciousness of both synthetic and physical polymer scientists and engineers to the importance of characterizing polymer macrostructures when attempting to develop structure–property relations. To help achieve this task, we suggest using the electrical birefringence or Kerr effects observed in their dilute solutions. The molar Kerr constants of polymer solutes contributing to the birefringence of their solutions, under the application of a strong electric field, are highly sensitive to both the types and locations of their constituent microstructures. As a consequence, we may begin to characterize the macrostructures of synthetic polymers by means of the Kerr effect. To simplify implementation of the Kerr effect to characterize polymer macrostructures, we suggest that NMR first be used to determine the types and amounts of constituent microstructures present. Subsequent comparison of observed Kerr effects with those predicted for different microstructural locations along the polymer chains can then be used to identify the most likely macrostructures. © 2014 Wiley Periodicals, Inc. J. Polym. Sci., Part B: Polym. Phys. 2015 , 53, 155–166     

Effect of Chamber Gas Phase on Mobile Phase pH and on Separation Efficiency in TLC. A New Mode of Chromatography

A new variant of thin-layer chromatography (TLC), based on a gradual change of mobile phase acidity during elution, is proposed. The pH change occurs in the mobile phase moving along the TLC plate as a result of its contact with an acidic or a basic gas phase that replaces the initial mobile phase vapor in the TLC chamber. The potential of this approach has been demonstrated by using carbon dioxide and ammonia gases to improve the resolution of benzoic acids and aromatic amines on polyamide TLC plates.     

Novel correlations between the critical constants of the noble gases

For any particular fluid, the set of three critical constants (CC) – pressure P_c, temperature T_c and molar volume V_c – has a central importance in defining the physical behaviour of the fluid in the gas and liquid states. However, little attention seems to have been paid in the past to the relations between the CC of different substances. In the present paper, some simple and apparently novel relations have been found between the three CC for the set of four noble gases: Ne, Ar, Kr, Xe. Defining the critical quotient Q_c ≡ RT_c/P_c (where R is the Gas Constant) the correlations may be summarised by the dual equation: (V_c/cm³ mol⁻¹) = 27 + 0.31 (T_c/K) = 3.3 + 0.280 (Q_c/cm³ mol⁻¹), which describes the CC data for the quartet Ne–Xe with an average uncertainty of 0.5%. Regarding the other two noble gases, the two isotopes of the lightest member, ³He and ⁴He, show the deviations from these relations that are expected from quantal effects and their low molar masses; while for the heaviest member, Rn, the correlations enable a value of 145(5) cm³ mol⁻¹ to be estimated for V_c that is not otherwise well defined in the literature. By contrast, and contrary to the general assumption, the second lightest member, Ne, apparently does not show appreciable quantal effects in the area, so that Ne–Xe may be considered together as a group. These correlations are compared with the behaviour of a selection of polyatomic fluids; in these comparisons, the NG dual correlation equation provides a reference line defining the presumed simplest behaviour. This and related areas show a “Residual Volume Effect”, in that extrapolating the equivalent temperature and energy parameters to zero for the state of zero-mass point particles, referred to here as the hypothetical element zeronium (Ze), the system in each case still has a finite intercept; this intercept amounts to essentially 34% of the average volume for the present quartet Ne–Xe, rather than the zero volume expected for this condition.     

THE EFEFCT OF MAGNETIC FIELD ON POLYMERIZATION OF STYRENE IN THE PRESENCE OF POLYVINYL NAPHTHALENE AND POLYVINYL BENZOPHENONE

In the process of bulk photopolymerization of styrene initiated by AIBN decomposition polyvinyl benzophenone (PVB) can supply an effective cage for triplet-triplet energy transfer between PVB macromolecules and small molecules of AIBN to influence the molecular weight of polystyrene in weak magnetic field (less than 0.035T), that was different from the case of polyvinyl naphthalene (PVN) which supplied cages for this system only in the stronger magnetic field (more than 0.2 T) studies. It was found that in the same conditions, PVN could exert more tremendous influences on the bulk photopolymerizatiou system of styrene than PVB because in the stronger magnetic field the triplet PVN had much longer life time than PVB.     

温度对Nafion-结晶紫光纤湿度传感器性能的影响

The optical fiber relative humidity sensor based on Nation-crystal violet film was developed.The effect of samplef s temperature in the range from 299.15K to 324.15K on the sensing performance of the sensor was investigated. The mathematical function between temperature and the sensitivity of the sensor was established according to the reactive theory of sensor to the relative humidity, which was validated with the experiment. With the research, the application range of the sensor was extended, which made the sensor keep a good veracity when it was used in situ.